基于DIS数字信息化系统对透光物质透光性能的研究

采用DIS数字信息化系统,对不同浓度的蓝墨水溶液在激光光源照射下的透射平均照度及照度分布图像进行实验研究,得到了平均照度值随溶液浓度变化的规律。对不同颜色塑料膜片对白炽灯光源透过照度值及照度分布图像进行实验研究得到及其相关之规律。     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

The Role of a Specific Response of Media in the Vavilov-Cherenkov Effect

It is shown that the condition υ > υ_p (ω), which is necessary in order to trigger the Vavilov-Cherenkov effect, determines the interval of radiated frequencies and it alone cannot establish a strong restriction to the velocity of the particle. It is exhibited that it is possible to define a general lower bound for the velocity of the particle, which does not depend on the frequency when both, a specific response of the medium is taken into account and the mentioned condition is considered. The minimum value of the phase velocity of light in the medium determines the existence of such general lower bound.     

Coulomb blockade in molecular quantum dots

The rate-equation approach is used to describe sequential tunneling through a molecular junction in the Coulomb blockade regime. Such device is composed of molecular quantum dot (with discrete energy levels) coupled with two metallic electrodes via potential barriers. Based on this model, we calculate nonlinear transport characteristics (conductance-voltage and current-voltage dependences) and compare them with the results obtained within a self-consistent field approach. It is shown that the shape of transport characteristics is determined by the combined effect of the electronic structure of molecular quantum dots and by the Coulomb blockade. In particular, the following phenomena are discussed in detail: the suppression of the current at higher voltages, the charging-induced rectification effect, the charging-generated changes of conductance gap and the temperature-induced as well as broadening-generated smoothing of current steps.     

K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰     

Photobioelectronic studies with thylakoid membranes

The research described in this paper presents a method for chemically modifying the surface of plant photosynthetic membranes in such a way that electrical contact can be made. Colloidal platinum was prepared, precipitated directly onto thylakoid membranes from aqueous solution, and entrapped on fiberglass filter paper. This composition of matter was capable of sustained simultaneous photoevolution of hydrogen and oxygen when irradiated at any wavelength (400–700 nm) in the chlorophyll absorption spectrum. Experimental data support the interpretation that part of the platinum metal catalyst is precipitated adjacent to the photosystem-I reduction site of photosynthesis and that electron transfer occurs across the interface between photosystem I and the catalyst. When contacted with metal electrodes, the thylakoid-platinum combination was capable of generating a sustained flow of current through an external load resistor. Procedures for preparing this material and experimental data on its catalytic and electronic properties are presented. Also presented is an analysis of the flow of photocurrent in terms of the interfacial electron transfer reactions that occur at the interfaces of the components of the assembly.     

Thermally reversible light scattering films based on the melting/crystallization of organic crystals dispersed in an epoxy matrix

Films that can be reversibly switched from opaque to transparent states by varying temperature (TRLS films), have potential applications in thermal sensors, optical devices, recording media, etc. A dispersion of organic crystals in a thermoset may be used for these purposes provided that at temperatures higher than the melting point there is a matching of refractive indices of both phases. A model system consisting on a dispersion of diphenyl (DP) crystals in an epoxy matrix based on diglycidyl ether of bisphenol A and m-xylylenediamine, was analyzed as a possible TRLS film encapsulated between transparent covers to avoid sublimation of DP. To obtain a uniform dispersion of DP-rich domains in the epoxy matrix by polymerization-induced phase separation, it was necessary to add 5 wt% of polystyrene (PS) to the initial formulation. Phase separation induced by polymerization at 80 °C led to a dispersion of PS/DP domains in the epoxy matrix due to the low compatibility of PS with the epoxy and its high compatibility with DP. Crystallization and melting processes were confined to the interior of dispersed domains leading to an excellent reproducibility of the optical properties of TRLS films in the course of successive heating-cooling cycles.