Tesla变压器型电子束加速器初步实验

 介绍了一种Tesla变压器型的强流电子束加速器。当变压器初级输入20kV左右的电压时，加速器二极管输出电压500kV，电流9kA，信号脉宽大约50ns，该装置具有结构简单，安装方便，运行可靠等特点。     

水平管外强化凝结传热的数值解

以Nusselt理论为基础,运用三维坐标建立了肋片侧面的冷凝传热模型,对肋片侧面的冷凝传热机理进行了分析,得出了肋片侧面表面传热系数的积分表达式。利用此法对水平环肋单管表面传热系数进行计算并将结果与传统解法进行比较。     

300kVA高温超导变压器电流引线漏热损耗的测量

电流引线是高温超导变压器的主要外部漏热来源,它的漏热量直接影响了超导变压器的经济性能,因此,引线的设计与漏热测量一直备受关注。文中构建了一个实验方案,运用量热法测量低压引线的漏热,并将试验结果与仿真预期值进行了对比和分析,从而验证了仿真设计的正确性。     

鱼翅中硫酸软骨素的酶解-高效液相色谱法测定

建立了一种测定鱼翅中硫酸软骨素的酶解－高效液相色谱方法；该法利用在一定条件下硫酸软骨素能被硫酸软骨素酶ABC定量酶解成软骨素二糖，通过高效液相色谱法测定软骨素二糖的量来计算硫酸软骨素的含量。     

Graded PZT ceramics for piezoelectric transformers

In the present study two types of the synthesized Pb(Zr_1−xTi_x)O₃ (PZT) powders differing in Zr/Ti ratio were used to prepare the spatially inhomogeneous (i.e., graded) structure. A position-dependent chemical composition was expected to cause the property gradient. Disk-shaped compacts were prepared in a way such that two different orientations of the radial gradients were formed. The solid state sintering under pressure was utilized to prepare ceramics. Simultaneous thermal analysis was used to study thermal behavior of the ceramic powders. Graded PZT ceramics were characterized using X-ray diffraction, scanning electron microscopy and energy dispersive spectroscopy. It was also characterized in terms of its dielectric properties by both bridge technique and the impedance spectroscopy. On the basis of graded PZT ceramics the disk-shaped radial mode piezoelectric transformer was developed and fabricated.     

用气相色谱仪测定变压器油中气体

本文采用多柱自动切换气相色谱仪和真空全脱气装置对变压器和互感器用油中的气体进行了系统的分析，除可测定油中的氢、甲烷、乙炔、乙烯、乙烷、二氧化碳和一氧化碳等气体外，还可根据不同需要测定氮、氧以及Ｃ３和Ｃ４烃的含量。本方法已用于诊断变压器和互感器内部变化及故障。     

分光光度法测定微量炔烃的研究

叙述了利用生成炔亚铜的反应来定量测定微量炔烃的分光光度法。研究表明，在严格控制氨的浓度、保持足量的还原剂的条件下，可以有效地消除反应介质、反应时间、反应物的浓度、空气中的氧等对测定的影响，获得满意的定量结果。该方法已在实际生产中得到应用。     

Interference of Transformer oil Matrices to the Internal Standards on PCB Quantification

Abstract

Polychlorinated biphenyls (PCBs) are toxic, perssstent, global environmental contaminants which were formulated as complex mixtures of congeners. Many methods have been developed in the past to analyze PCB in transformer oil samples for regulatory purposes. The most important consideration in the cleanup procedure is the ability to remove the oil from the sample matrix, since trace amount of oil will interfere with the subsequent GC-MS analysis. Electron capture detection (ECD) has been the most common method for gas chromatographic analysis of PCBs because of its high sensitivity toward halogenated compounds. ECD can also respond to some non-PCB compound resulting in biased concentrations of PCB. In this work, a two-stage cleanup method, using DMSO liquid/liquid extraction and HPLC column chromatography. has been applied to two types of transformer oil. Five internal standards have been selected to show their performance in the presence of different oil matrices. The comparison of the PCB quantification at different conditions for GC-MS and GC-ECD will be demonstrated.     

The Effect of Temperature on GPC for the Separation of PCBs from Transformer Oil and Subsequent Analysis by GC-MSD

Abstract

The analysis of PCBs often involves lengthy and expensive cleanup procedures to remove interferences associated with environmental sample matrices. Gel permeation chromatography (GPC) has proven to be a useful tool in removing many of these interferences from environmental samples, especially from difficult matrices such as oils, lipids and sediments. This paper describes the effect of temperature upon the GPC column in separating PCBs from transformer oil and its implication on GC-MS analysis.     

干式变压器有限元仿真模型的电磁和振动分析

随着电力需求的逐年增长,干式变压器的数量也在不断增加。干式变压器在运行时存在着振动和噪声的问题,为了对干式变压器振动的规律与特点进行研究,本文建立了干式变压器本体振动的有限元仿真模型,通过电磁分析获得相应的磁场分布,然后利用结构动力学分析得到其本体振动的相关规律。通过对处于运行状态的变压器振动数据进行实测分析,得到变压器振动的特征频率,然后对仿真结果进行对比分析,可以发现振动幅度与频率之间存在的关系。本文的研究结果可对干式变压器的减振降噪研究提供参考。