拆边法求最短路径

本文利用局部比较法 ,在图中定义子图、无效路径、以及可去边 .利用推导的有关定理 ,拆去可去边 ,利用最短路径相同的等价性 ,达到化简图 ,从而求出最短路径     

NMR investigation of concentrated alumina and silica slurries

The longitudinal relaxation times (T₁) of water in concentrated silica and alumina slurries were measured as a function of solids content. It was shown that the results could be fit very well with a two-phase fast-exchange model between free and surface-bound water. As expected, values of T₁ for bound water were in the order of 20–2000 times lower than that for free water, indicating a higher effective viscosity of the surface-bound water. The strength of the interaction depended on the particular surface, and all of the aluminas examined interacted more strongly with water than the two silicas studied, which themselves differed considerably. The chemical mechanical polishing (CMP) removal rate of tantalum by silica slurries was shown to be directly correlated with the interaction parameters, derived from the NMR relation times rather than with total surface hydroxyl group concentration.     

Theoretical analysis of the onset of liquid entrainment for slots of finite width

The onset of liquid entrainment during discharge from large reservoirs containing a stratified mixture of two immiscible fluids through a side slot of a finite width is considered theoretically. A previously reported analysis in which the slot was approximated as a two-dimensional line sink has been extended to account for the finite width of the slot. The model resulting from the present analysis is expressed in terms of two simple algebraic equations suitable for hand calculations. According to the present results, the ratio of the critical height to the slot width is dependent only on the Froude number. Numerical results show that the present model approaches the correct physical limits at low Froude numbers and it converges to the predictions of the previously reported simple model at high Froude numbers.     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

Thermal stability of poly(mono-n-alkylitaconates) and mono-n-alkylitaconate-co-vinylpyrrolidone copolymers I

Poly(monoitaconates) containing octyl, decyl and dodecyl groups and random monoalkylitaconate-co-vinylpyrrolidone copolymers were studied by thermogravimetric analysis. Copolymers of mono-n-octylitaconate (MOI), mono-n-decylitaconate (MDI), and mono-n-dodecylitaconate (MDoI), respectively, with N-vinyl-2-pyrrolidone (VP) of different compositions were studied by dynamic thermogravimetric analysis. The thermal stability of the copolymers depends on the structure of the monoitaconate comonomer and on the composition of the copolymer The kinetic analysis of the degradation data shows that the thermal decomposition of these copolymers can be described by several kinetic orders depending on the copolymer and on the composition. The relative thermal stability of the copolymers increases as the VP content increases and as the length of the side chain of the itaconate increases, following the same trend as the flexibility of the copolymers in solution.     

The effect of side substituents on rotation hindrance in polyheteroarylenes

Hindered rotation was considered in calculations of the conformational parameters of a series of polyheteroarylenes with bulky side substituents by the Monte-Carlo method. Within the range of experimental errors, the results of calculations for several polyarylates coincide with the values of conformational rigidity, determined from hydrodynamic experimental data. The proposed procedure was used to estimate the rigidities of a number of polymers with bulky side substuents for which experimental determination is difficult. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 7, pp. 1287–1296, July, 1998.     

STUDY ON MAGNETIC FIELD-INDUCED 0RIENTATI0N OF A CHIRAL SIDE-CHAIN LIQUID CRYSTAL POLYACRYLATE USING INFRARED DICHROISM

Magnetic field-induced orientation of a chiral side chain liquid crystalline polyacrylate(P-11) was studied by using IR dichroism. For the investigated P-11, it has been shown thatthe magnetic alignment takes place over the entire temperature range between its meltingpoint and clearing point and the orientation level is strongly temperature-dependent, thedevelopment with time of the magnetic orieatation follows an exponeotial-type relation,and the smectic phase state influences the thermal relaxation process in the absence of themagnetic field.     

24ζ-甲基-20 S-胆甾醇的合成

已发现的天然甾醇均为20R 构型。近年来在地质体中发现了具有20S 构型的甾烷类生物标志化合物,并称之为地质构型。合成20S 构型的甾烷的方法之一是由20S 构型的甾醇为原料。20S-胆甾醇及20S-胆甾烷的合成已有报道,但24ξ-甲基-20S-     

缩聚反应合成侧链液晶聚合物

侧链液晶聚合物的合成方法,可归纳为3类:一是烯基的单体,如甲基丙烯酸酯,或丙烯酸酯,氯代丙烯酸酯等,经自由基聚合反应,阴离子聚合反应及甲基丙烯酸酯的基团转移聚合反应,得到侧链液晶聚合物;二是变性反应,如聚硅氧烷与丙烯酸酯介     

水合醋酸铈直接热分解制备超细氧化铈及其抛光性能

Ultra fine ceria was prepared by calcining hydrate cerium acetate. The effects of pyrolysis temperature on the particle size, morphology, specific surface area and loose packing density of ceria were investigated, and the removal rate of optical glasses polishing by ceria was determined. The results show that with the increase of pyrolysis temperature, the loose deposit density and crystallinity increases and the specific surface area decreases, however, the particle size decreases firstly and then increases, the minimum medium particle size D₅₀ is 0.47 μm at pyrolysis temperature of 1 000 ℃. The SEM images of ceria prepared by the decomposition at 800 ℃ or at 1 100 ℃ show porous powders or quasi-sphere small particles with loosely agglomeration, respectively. It was found that the removal rate varied with pyrolysis temperature in preparation of ceria and the property of glass polished. The removal rate for three kinds of glasses was in the order of ZF7> F1> K9, and the maximum value appeared at around 1 000 ℃ for ZF7 and F1, and at around 1 100 ℃ for K9.