激光二极管泵浦的高重复频率Nd：YAG激光器

报道两个１．５Ｗ连续激光二极管端面泵浦的声光调ＱＮｄ：ＹＡＧ激光器，输出激光脉冲的最高重复频率为３０ｋＨｚ重复频率１ｋＨｚ时，最窄脉宽为１２ｎｓ，最高峰值功率为１２．１ｋＷ。     

Fuzzy-PID分级控制变水量空调系统温度的研究

针对变水量空调系统温度控制的时变、大滞后、非线性特点,结合模糊控制和PID控制,设计了基于模糊规则切换的Fuzzy-PID分级控制器,并在Matlab/Simulink软件上进行了仿真。仿真结果表明,控制器同时具有模糊控制超调量小、鲁棒性好和PID控制精度高、响应速度快的优点。     

用于SCA ASIC测试的数字读出模块设计

高速开关电容阵列(SCA)具有高速采样、低功耗的特点,基于SCA的高速波形数字化是目前高精度时间测量的一个重要研究方向。为此,我们开展SCA芯片的研究,目前已设计完成原型ASIC设计,并正在进行后续版本的改进设计。为便于未来多版本ASIC的测试和评估,需设计具有一定通用性的数字读出模块,本论文工作主要介绍此模块的设计工作以及相应的数据读出软件。数字读出模块基于FPGA实现对待测ASIC的控制、配置及数据读出,采用DDR3片外存储芯片,使用USB3.0等接口进行数据传输;上位机软件基于Python3.7设计,实现了数据采集与波形绘制等功能。目前已使用设计完成的数字读出模块对第2版SCA ASIC进行了初步的测试,测试结果表明,此读出模块工作正常,且SCA芯片输出结果符合预期。     

Power dissipation characteristics of great power and super high speed semiconductor switch

The power dissipation characteristics of pulsed power switch reversely switched dynistors （RSDs） are investigated in this paper. According to the expressions of voltage on RSD, derived from the plasma bipolar drift model and the RLC circuit equations of RSD main loop, the simulation waveforms of current and voltage on RSD are acquired through iterative calculation by using the fourth order Runge-Kutta method, then the curve of transient power on RSD versus time is obtained. The result shows that the total dissipation on RSD is trivial compared with the pulse discharge energy and the commutation dissipation can be nearly ignored compared with the quasi-static dissipation. These characteristics can make the repetitive frequency of RSD increase largely. The experimental results prove the validity of simulation calculations. The influence factors on power dissipation are discussed. The power dissipation increases with the increase of the peak current and the n-base width and with the decrease of n-base doping concentration. In order to keep a low power dissipation, it is suggested that the n-base width should be smaller than 320μm when doping concentration is 1.0×10^14cm^-3 while the doping concentration should be higher than 5.8×10^13cm^-3 when n-base width is 270μm.     

Queueing Dynamics and Maximal Throughput Scheduling in Switched Processing Systems

We study a processing system comprised of parallel queues, whose individual service rates are specified by a global service mode (configuration). The issue is how to switch the system between various possible service modes, so as to maximize its throughput and maintain stability under the most workload-intensive input traffic traces (arrival processes). Stability preserves the job inflow–outflow balance at each queue on the traffic traces. Two key families of service policies are shown to maximize throughput, under the mild condition that traffic traces have long-term average workload rates. In the first family of cone policies, the service mode is chosen based on the system backlog state belonging to a corresponding cone. Two distinct policy classes of that nature are investigated, MaxProduct and FastEmpty. In the second family of batch policies (BatchAdapt), jobs are collectively scheduled over adaptively chosen horizons, according to an asymptotically optimal, robust schedule. The issues of nonpreemptive job processing and non-negligible switching times between service modes are addressed. The analysis is extended to cover feed-forward networks of such processing systems/nodes. The approach taken unifies and generalizes prior studies, by developing a general trace-based modeling framework (sample-path approach) for addressing the queueing stability problem. It treats the queueing structure as a deterministic dynamical system and analyzes directly its evolution trajectories. It does not require any probabilistic superstructure, which is typically used in previous approaches. Probability can be superposed later to address finer performance questions (e.g., delay). The throughput maximization problem is seen to be primarily of structural nature. The developed methodology appears to have broader applicability to other queueing systems.     

一类切换线性系统的动态输出反馈H_∞控制:LMIs方法

研究一类由任意有限多个线性子系统组成的切换系统的动态输出反馈H∞控制问题.利用共同Lyapunov函数方法和凸组合技术,给出由矩阵不等式表示的控制器存在的充分条件,并设计了相应的子控制器和切换规则.采用消元法,将该矩阵不等式转化为一组线性矩阵不等式(LMIs).最后给出一个数值仿真实例证明结论的有效性.     

Megawatt peak power 8–13 μm CdSe optical parametric generator pumped at 2.8 μm

Infrared pulses, continuously tunable in the 8–13 μm range, and with up to 1 MW peak power, have been achieved using single-stage frequency conversion in a CdSe travelling-wave optical parametric generator, pumped by 100 ps pulses from an actively mode-locked, Q-switched and cavity dumped 2.8 μm Cr,Er:YSGG laser. The external quantum conversion efficiency reached 10%.     

一类线性系统的数值控制设计

主要讨论了具有不稳定切换子模型的切换线性系统的稳定性问题.首先考虑了通过设计切换律来达到切换线性系统的稳定性问题.然后研究了切换线性控制系统可镇定性问题,通过设计控制律和切换律得到系统可镇定的判据.