Diastereoselective Cyclobutenol Synthesis: A Heterogeneous Palladium-Catalyzed Oxidative Carbocyclization-Borylation of Enallenols

A highly selective and efficient oxidative carbocyclization/borylation of enallenols catalyzed by palladium immobilized on amino-functionalized siliceous mesocellular foam (Pd-AmP-MCF) was developed for diastereoselective cyclobutenol synthesis. The heterogeneous palladium catalyst can be recovered and recycled without any observed loss of activity or selectivity. The high diastereoselectivity of the reaction is proposed to originate from a directing effect of the enallenol hydroxyl group. Optically pure cyclobutenol synthesis was achieved by the heterogeneous strategy by using chiral enallenol obtained from kinetic resolution.     

一种新颖的测定和分析羟自由基氧化损伤RNA及其分子机理的化学发光体系

近年来，羟自由基（^.OH)对DNA氧化损伤已受到广泛关注，但是很少研究^.OH对RNA的氧化损伤。其实，RNA与DNA一样，也是核酸的两大组分之一，也有许多重要功能。所以^.OH攻击RNA也会引起重后果，会造成细胞功能衰退甚至细胞死亡等。为此，我们建立了Vit.C-CuSO4-Phen-H2O2-PNA这一产生和测定^.OH氧化损伤RNA的化学发光体系，以便加强^.OH氧化损伤RNA的研究。通过对本体系测定条件的研究，得出了本体系最佳组方是：Vit.C,CuSO4,Phen,H2O2和RNA，浓度分别为350μmol/L,55μmol/L,350μmol/L,0.2mol/L和20μg/mL,体系pH为5．5，体系终体积为1mL。随后，利用本体系检测了槲皮素，咖啡酸，黄芩甙和芦丁抗^.OH氧化损伤RNA的作用，发现这四种抗氧化剂均能有效抑制^.OH氧化损伤RNA的分子机理，结果发现，^.OH清除剂硫脲几乎抑制全部发光，推测是因硫脲清除了引发剂^.OH所致；O^-.2清除剂SOD只能抑制小部分发光；^1O2清除剂叠氮化钠和苯甲酸都能抑制绝大部分发光。这些事实提示，^.OH是RNA氧化损伤的引发剂；O^-.2只是导致RNA氧化损伤的次要因素，^1O2才是导致RNA氧化损伤的最主要因素。     

Ageing of wet-synthesized oxide powders

Wet chemical synthesis of precursor oxide ceramics is a method to obtain small particulate powders. Such powders are far more prone to ageing in air than more traditional precursors. Thermogravimetric analysis is used to highlight the species responsible for the ageing of ceramic precursors. Indeed water and carbon dioxide are observed to evolve from aged powders. Ceramics obtained from aged precursors can reach a very low final density with respect to the theoretical value. A large degree of the original sintering properties can be recovered after washing the aged powders with ethanol in a basic medium.     

Dibutyltin-3-hydroxyflavone titrates a dissociable component (cofactor) of mitochondrial ATP synthase: An energy-transfer component linked to the ubiquinone pool

Dibutyltin-3-hydroxyflavone, Bu₂Sn(of), is a new fluorescence probe inhibitor of F₁F₀-ATPase and oxidative phosphorylation which inhibits by titration of an unidentified component of F₀. Its site of action is closely related to that of the trialkyltins and of venturicidin. This F₀ component is part of a pool of this component which is present in the heart mitochondrial inner membrane at levels of 5–7 nmol (mg protein)^?1 [18 ± 3 Bu₂Sn(of) sites per mol F₁F₀-ATPase]. However, ATPase activity in submitochondrial particles is near maximally inhibited by titration of approx. three Bu₂Sn(of) sites per mol F₁F₀-ATPase. Over 60% (60–80%) of the Bu₂Sn(of) interaction sites can be lost during the purification of F₁F₀-ATPase from submitochondrial particles. The number of Bu₂Sn(of) interaction sites in various F₁F₀-ATPase preparations is variable. The high numbers of Bu₂Sn(of) sites per mol F₁F₀-ATPase for heart mitochondria (18–21) and submitochondrial particles (15–19.5) decline in ATP synthase (11–15) to the low values obtained in Complex V (7–10.5) and the minimal values observed in highly purified F₁F₀?ATPase (3.5–5.6), thus indicating a variable dissociable component or cofactor of ATP synthase. The Bu₂Sn(of) interaction site, a component of ATP synthase, is responsive to the redox status of the respiratory chain and the interaction with Bu₂Sn(of) is with the reduced form of this component. Fluorescence titration studies show that this component is in redox equilibrium with the ubiquinone pool of the respiratory chain. It is proposed that this redox component serves as an inhibitor titratable cofactor pool which cycles through an F₀ interaction site (or sites) via a system which serves as an energy-transfer link between the respiratory chain and ATP synthase.     

Carbon–epoxy composites based on fibers coated with nylon 6,6: hygrothermal ageing versus interlaminar shear strength

Carbon fibers were coated in situ with a thin film of polyhexamethylene adipamide by an interfacial polycondensation technique. The modified fibers were used for the preparation of epoxy-based unidirectional composites. Specimens of these materials were immersed in water until equilibrium conditions were attained. The weight gain at equilibrium was determined as a function of the immersion temperature, the fiber volume fraction and the polyamide content deposited on the fibers. Water penetration in specimens made with uncoated carbon fibers increases when the volume fraction decreases. Introduction of the polyamide interlayer initially increases the water absorption, but reduces it at higher immersion temperatures and/or higher polyamide contents. The treated specimens were subjected to the short beam test to determine the interlaminar shear strength (ILSS). The data show that the ILSS decreases with water penetration but increases when the immersion temperature increases from 40 to 70°C. The overall performance encountered is discussed in terms of the possible roles of the polyamide interphase while taking into account mechanisms concerned with matrix plasticization, interphase degradation and residual stress relaxation.     

Synthesis and cell cycle inhibition of the peptide enamide natural products terpeptin and the aspergillamides

Total syntheses of the peptide enamide natural products terpeptin and aspergillamides A and B are reported. An oxidative decarboxylation-elimination protocol is employed to construct the indolic enamide moiety. Unambiguous stereochemical assignment of (−)-terpeptin is accomplished by synthesis of all possible stereochemical analogues. Select compounds have been evaluated in cell cycle inhibitor assays which show that the natural amino acid configuration of terpeptin has the most potent inhibitory activity.     

Ethylene polymerization by novel Ziegler–Natta‐type catalysts obtained in situ by the oxidative addition of 8‐hydroxyquinoline‐based ligands to bis(1,5‐cyclooctadiene)nickel(0) and methylaluminoxane

Novel catalytic systems, prepared in situ by the oxidative addition of 8‐hydroxyquinoline ligands to bis(1,5‐cyclooctadiene)nickel(0) and activated by methylaluminoxane, were studied in ethylene polymerization. When 8‐hydroxyquinoline was employed, only oligomeric products were obtained. On the contrary, 5,7‐dinitro‐8‐hydroxyquinoline gave linear polyethylene (PE), but with a modest activity. For the catalyst based on 5‐nitro‐8‐hydroxyquinoline, the productivity was largely dependent on the content of free trimethylaluminum (TMA) present in the commercial aluminoxane. The progressive optimization of the TMA/oligomeric methylaluminoxane ratio increased the productivity, which reached 700 kg of PE/(mol of Ni × h), by an order of magnitude. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 200–206, 2006     

Synthesis and characterization of mid‐ and end‐chain functional telechelics by controlled polymerization methods and coupling processes

Well‐defined polystyrene‐ (PSt) or poly(ε‐caprolactone) (PCL)‐based polymers containing mid‐ or end‐chain 2,5 or 3,5‐ dibromobenzene moieties were prepared by controlled polymerization methods, such as atom transfer radical polymerization (ATRP) or ring opening polymerization (ROP). 1,4‐Dibromo‐2‐(bromomethyl)benzene, 1,3‐dibromo‐5‐(bromomethyl)benzene, and 1,4‐dibromo‐2,5‐di(bromomethyl)benzene were used as initiators in ATRP of styrene (St) in conjunction with CuBr/2,2′‐bipyridine as catalyst. 2,5‐Dibromo‐1,4‐(dihydroxymethyl)benzene initiated the ROP of ε‐caprolactone (CL) in the presence of stannous octoate (Sn(Oct)₂) catalyst. The reaction of these polymers with amino‐ or aldehyde‐functionalized monoboronic acids, in Suzuki‐type couplings, afforded the corresponding telechelics. Further functionalization with oxidable groups such as 2‐pyrrolyl or 1‐naphthyl was attained by condensation reactions of the amino or aldehyde groups with low molecular weight aldehydes or amines, respectively, with the formation of azomethine linkages. Preliminary attempts for the synthesis of fully conjugated poly(Schiff base) with polymeric segments as substituents, by oxidative polymerization of the macromonomers, are presented. All the starting, intermediate, or final polymers were structurally analyzed by spectral methods (¹H NMR, ¹³C NMR, and IR). © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 727–743, 2006     

添加助剂的钙钛矿型氧化物NdMO_3上的甲烷氧化偶联——Ⅱ.15% Li_2O/NdMO_3(M=Cr、Mn、Fe、Co、Ni)上的OCM反应研究

在添加了15%Li_2O的NdMO_3(M=Cr、Mn、Fe、Co、Ni)上进行了甲烷氧化偶联(OCM)反应研究.通过改变反应气中CH_4:O_2浓度比,在氧化态和“脱氧态”催化剂上的CH_4脉冲反应,探讨了表面吸附氧和晶格氧在OCM反应中的作用以及NdMO_3中不同金属离子(M)对OCM反应活性的影响等.     

甲烷分子在碱性催化剂上的吸附与酸碱活化机理

以碳酸锶为甲烷吸附活化的模型催化剂，用切换变应答、ＣＨ４（ＣＯ２）－ＴＰＤ等技术，对甲烷的吸附、碱性对催化剂性能的影响进行了研究，结果表明，甲烷在碳酸锶上的活化显示出明显的酸碱活化机理特征，瞬变应答及ＴＰＤ结果均证明，甲烷在碳酸锶表面有较强的吸附，其脱附温度约３１０℃，关联结果表明，甲烷转化率及Ｃ２烃收率与催化剂表面ＳｒＯ碱性中心浓度有非常一致的顺变关系，因此催化剂表面的酸碱中心可能是甲烷的选择活