TBOR-shaped electro-optic modulator with dual output based on double-layer graphene

We proposed an electro-optic modulator with two-bus one-ring (TBOR) structure to improve the extinction ratio and reduce insert loss. It has a dual output compared with one-bus one-ring structure. In addition, double-layer graphene makes it possible for the modulation in the visible to mid-infrared wavelength range. It shows that this new electro-optic modulator can present two switching states well with low insertion loss, high absorption and high extinction ratio. At $\lambda =1550\text{ nm}$, when the switching states are based on the chemical potential, ${\mu }_{\mathrm{c}}=0.38\text{ eV}$ and ${\mu }_{\mathrm{c}}=0.4\text{ eV}$, the insertion losses of both output ports are less than 2 dB, the absorption of the output port coupled via a micro-ring reaches 45 dB and the extinction ratio reaches 14 dB. When the refractive index of the dielectric material is 4.2, the applied voltage will be less than 1.2 V, thus can be used in low-voltage CMOS technology.     

Effect of high intensity ultrasound on gelation properties of silver carp surimi with different salt contents

Surimi from silver carp with different salt contents (0–5%) was obtained treated by high intensity ultrasound (HIU, 100 kHz 91 W·cm⁻²). The gelation properties of samples were evaluated by puncture properties, microstructures, water-holding capacity, dynamic rheological properties and intermolecular interactions. As the salt content increased from 0 to 5%, gel properties of surimi without HIU significantly improved. For samples with low-salt (0–2% NaCl) content, HIU induced obvious enhancement in breaking force and deformation. HIU promoted the protein aggregation linked by SS bonds, hydrophobic interactions and non-disulfide covalent bonds in surimi gels with low-salt content. Moreover, microstructures of HIU surimi gels with low-salt content were more compact than those of the corresponding control samples. HIU also improved the gelation properties of surimi with 3% NaCl to an extent. However, for high-salt (4–5% NaCl) samples, HIU decreased the breaking force and deformation of surimi gels due to the degradation of proteins suggested by increased TCA-soluble peptides. In conclusion, HIU effectively improved the gelation properties of surimi with low-salt content (0–2% NaCl), but was harmful for high-salt (4–5% NaCl) surimi. This might provide the theoretical basis for the production of low-salt surimi gels.     

Novel model of FM-noise conversion in a UMZI using RF external phase modulation of lasers: Theoretical and experimental results

In this paper, we propose and demonstrate a new and original model for theoretical calculation and experimental measurement of the noise power spectral density (NPSD) in phase-modulated optical links. The phase modulation is operated in the RF frequency range by an external phase modulator. The NPSD is derived for the first time in interferometric systems, by considering all effects such as the 1/f FM noise of the laser and white noise applied to light from a 1550 nm DFB laser, with phase modulation. The results show for the first time the influence of the phase modulation index, modulation frequency and interferometric delay in the phase-to-intensity noise conversion. The experimental and simulation results of conversion of FM-noise to intensity noise in an optical link by considering the external RF phase modulation are shown with good agreement.     

利用振幅调制器进行光电负反馈抑制激光强度噪声

采用振幅调制器作为抑制激光强度噪声的元件，首先对光电负反馈回路进行了简要的理论分析，然后利用该光电负反馈进行抑制激光二极管抽运全固化单频环形Nd:YVO4红外激光器强度噪声的实验。结果表明，在0－1MHz的低频段，强度噪声大幅度降低，最大降低约15dB。     

激光诱导荧光探测水体中溶解有机物浓度

用Nd∶YAG激光器的三倍频355 nm光作为激发光源,根据激光诱导荧光(LIF)方法激发并探测污染水体的荧光光谱.通过对荧光光谱的分析处理研究归一化荧光强度,即450 nm处水中溶解有机物(DOM)峰与405 nm处水的拉曼峰的比值,反演溶解有机物浓度.用商品腐殖酸和去离子水配置成已知浓度的溶液代替标准DOM溶液进行标定,得到回归方程.结果证明,DOM的归一化荧光强度与水体中DOM浓度有较好的线性关系,因此LIF方法是对大面积水域水质进行动态遥测的较理想方法.     

基于液晶光阀的全息照相控光仪

设计了通过液晶光阀自动调整全息照相物光和参考光辐照比至最佳状态,同时能实现曝光时间自动控制的控光仪.该仪器巧妙运用液晶光阀和硅光电池器件,使测量、调整、自控一体化,从而提高拍摄优质全息图的工作效率.     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

X-Ray Mapping and Interpretation of Scatter Diagrams

Electron beam induced quantitative X-ray mapping has become a very useful characterisation tool for determining the elemental distribution in materials, whether using energy dispersive spectroscopy or wavelength dispersive spectroscopy. The X-ray intensity distributions of the elements from an X-ray map allow us to generate two dimensional and ternary scatter diagrams thus converting spatial information into concentration dimensions, which is an important tool for displaying the spatial relationships of elements or correlated elements (phases) in materials. To best understand how to use this tool, we need to understand the production and features of the scatter diagram. The type of clustering observed in the scatter diagram, whether oval, linear or spherical, can give the major and trace element distributions within phases as well as qualitative and quantitative phase information. This paper demonstrates the generation of scatter diagrams, properties of scatter diagrams, interpretation of scatter diagrams and the advantages of scatter diagrams through the use of examples.     

半导体激光自混频干涉式传感器中的干涉与调制

应用F-P模型，阐述了半导体激光自混频干涉式传感器的干涉与调制过程，同时给出了相应的计算．     

Single to 16-Channel Wavelength Conversion at 10 Gb/s Based on Cross-Gain Modulation of ASE Spectrum in SOA

A simple scheme for single to multi-channel wavelength conversion based on cross-gain modulation of amplified spontaneous emission (ASE) spectrum in semiconductor optical amplifier (SOA) is described. Single to 16-channel wavelength conversion at 10 Gb/s is first demonstrated without any additional probe lights, the modulation information carried by input signal could be converted into arbitrary many channels if only the demultiplexer with enough channels is exploited. Output performance and pattern effects are investigated experimentally.