TBOR-shaped electro-optic modulator with dual output based on double-layer graphene

We proposed an electro-optic modulator with two-bus one-ring (TBOR) structure to improve the extinction ratio and reduce insert loss. It has a dual output compared with one-bus one-ring structure. In addition, double-layer graphene makes it possible for the modulation in the visible to mid-infrared wavelength range. It shows that this new electro-optic modulator can present two switching states well with low insertion loss, high absorption and high extinction ratio. At $\lambda =1550\text{ nm}$, when the switching states are based on the chemical potential, ${\mu }_{\mathrm{c}}=0.38\text{ eV}$ and ${\mu }_{\mathrm{c}}=0.4\text{ eV}$, the insertion losses of both output ports are less than 2 dB, the absorption of the output port coupled via a micro-ring reaches 45 dB and the extinction ratio reaches 14 dB. When the refractive index of the dielectric material is 4.2, the applied voltage will be less than 1.2 V, thus can be used in low-voltage CMOS technology.     

激光调Q CAI

从激光调Q速率方程出发,分析推导了激光调Q过程中,腔内光子数与工作物质内反转粒子数间的关系.再根据激光调Q的过程中,对腔Q值控制方式不同,将激光调Q技术分为:转镜调Q、声光调Q、电光调Q、饱和吸收调Q和脉冲透射式调Q.用C语言进行了激光调Q CAI软件的开发研制,获得了将文学、图形、动画和计算融为一体的,直观而生动地将调Q的理论和过程再现于屏幕的CAI课件.介绍了课件的内容、结构及其特点.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Analysis of reflectance and modulation spectroscopic lineshapes in optoelectronic device structures

We discuss the spectral lineshapes of reflectance and modulated reflectance (MR) measurements on optoelectronic device structures such as epi-layers, quantum wells (QWs), vertical-cavity surface emitting-lasers (VCSELs) and resonant-cavity light-emitting diodes (RCLEDs). We consider the various methods for the extraction of built-in electric fields and band-gap energies from Franz-Keldysh oscillations (FKO), using the example of a tensilely strained InGaAs QW system, whose InGaAsP barriers yield strong FKO. We describe how critical point transition energies can be easily obtained by eye from Kramers-Kronig (KK) transforms of low field or QW modulation spectra, using the example of the modulated transmittance spectra of dilute-nitrogen InGaAsN p-i-n structures. We also discuss how the ordinary reflectivity spectrum, usually acquired at the same time as the MR signal, may also be exploited to extract layer thicknesses and compositions, and information about the active QW absorption spectrum in VCSEL and RCLED structures.     

Numerical reconstruction of an infrared wavefront utilizing an optical phase modulation device

We utilize nitroanisole, that absorbs infrared (IR) radiation as heat, as an optical modulation device based on a thermal process. The nitroanisole exhibits a thermal lens effect, i.e. a temperature dependent refractive index. Hence, the nitroanisole can induce phase modulation to visible light, in direct response to intensity of the incident IR radiation. The proposed method can be used to obtain the phase modulation distribution that corresponds to the IR intensity distribution, i.e. the IR hologram itself, on the nitroanisole by examining the phase map of visible light that is modulated upon passing through the nitroanisole. The IR wavefront can be reconstructed by calculating extracted IR holograms through the Fresnel transform. It is verified that both the amplitude and the phase of the IR wavefront can be reconstructed accurately by proposed method.     

各向同性湍流中颗粒引起湍流变动的直接模拟

本文通过直接数值模拟对均匀各向同性湍流中颗粒对湍流的变动作用进行了研究.颗粒相的体积分数很小而质量载荷足够大,以至于颗粒之间的相互作用可以忽略不计,而重点考虑颗粒与湍流间能量的交换。颗粒对湍流的反向作用使得湍动能的耗散率增强,以至于湍动能的衰减速率增大.湍动能的衰减速率随颗粒惯性的增大而增大。三维湍动能谱显示,颗粒对湍动能的影响在不同的尺度上是不均匀的。在低波数段,流体带动颗粒,而高波数段则相反.     

Comparative Study on Large and Small Signal Theory for Intensity Modulation Response of Semiconductor Lasers Including Higher-Order Dispersion Terms

In this article, the comparison of large signal theory and small signal theory has been done with dispersive propagation of optical signal with IMDD (Intensity Modulation Direct Detection) systems for semiconductor lasers with higher-order dispersion terms. The expressions for an exact large signal theory and small signal theory including higher-order dispersion terms for propagation of an optical wave with sinusoidal amplitude and frequency modulation in a dispersive fiber have been derived. It is observed that small signal theory is more sensitive compared to large signal theory in terms of intensity modulation/direct detection systems. Also, it is reported that for large signal analysis the higher-order effects of dispersion can be ignored, whereas for small signal theory, the higher-order effects can be ignored for lower modulation frequencies only. The variation in the transfer function for various values of modulation indices are greater for small signal analysis than for large signal analysis. Also, as the intensity modulation index is increased, there is a decrease in the value of transfer function. The large signal model approximates the small signal model for lower values of the intensity modulation index.     

显像管调制特性的测量与分析

测试了显象管调制特性曲线，并分析了特性曲线与显像管工作原理．     

调制不稳定性对级联放大光纤传输系统信噪比的影响

在考虑光纤损耗和级联放大器的情况下，推导了调制不稳定性的产生条件和增益的普适解析表达式，分析了调制不稳定性对信噪比的影响，给出了一个新的计算信噪比的表达式。