Wide-range regulation of polyaniline conduction by interphase doping of a polyaniline film

The not-sufficient-enough conductance of semioxidized protonated polyaniline (PANI) is usually attributed to the presence of ordered quasi-metallic domains surrounded by a poorly conducting amorphous phase. The paper presents experimental results testifying to the existence, in semioxidized PANI, of multilevel redox heterogeneity that crucially effects the conductance magnitude in view of specific topology at which higher-oxidized (conducting) domains are surrounded by less oxidized (poorly conducting) domains and because the PANI conduction is extremely sensitive to the oxidation degree. It is shown experimentally that the interphase doping with metals and degenerate semiconductors of a semioxidized salt of PANI and poly(2-acrylamide-2-methyl-1-propanesulfonic acid) (PAMPSA) with a 1: 2 ratio between PANI and PAMPSA raises the PANI-PAMPSA conductivity by 3–8 orders of magnitude due to the formation near the interface of thin layers whose conductance depends on the work function of the material in contact with PANI-PAMPSA and in extreme cases substantially exceeds the conductance of gold and copper at room temperature.     

Changes in the Laser-Induced Fluorescence Spectrum of Myocardium Tissue with Decrease in Its Viability

We investigated the laser-induced fluorescence spectra (LIF) of porcine cardiac tissues with different degrees of viability. The data obtained are compared with the results of routine histological investigations and also with the experiments performed with the use of fluorescent probes. It has been found with a high degree of reliability that the loss of the viability of the myocardium tissue leads to the alteration of its LIF spectra. This can be used for low-invasive rapid control of transplant viability in the process of its preparation and during surgery.     

Study of the pulsed laser vapor doping of Si(1 0 0) with KrF excimer laser and BCl3 gas

The properties of pulsed laser vapor doping on p-Si(1 0 0) with a KrF (248 nm) excimer pulsed laser (248 nm) and BCl₃ gas are reported in this paper. The doped samples are characterized by the resistance measured using a four-probe method, since the sheet resistance changes with the carrier concentration of the sample. The doping effects with the variation of laser energy density, pulse number, and the pressure of BCl₃ were investigated in terms of the sheet resistance. In this way, the optimized parameters were obtained and used for the positive heavy doping on p-Si(1 0 0) and p-Si(1 1 1). Then, using a square mesh under the above conditions, an image doping was completed. Finally, the metal–semiconductor Ohmic contacts were realized by plating Ag and Cu films on the doped surface.     

有机薄膜器件负电阻特性的影响因素

研究了影响有机染料掺杂聚合物薄膜器件负电阻特性的因素，为探索有机负电阻的机理提供实验依据。实验中制备了多种有机染料掺杂聚合物薄膜器件，研究了有机小分子染料、聚合物基体、薄膜组成及厚度、ITO和聚苯胺阳极等对有机染料掺杂聚合物薄膜器件负电阻特性的影响。在室温、大气环境下，所制备的多种有机染料掺杂聚合物器件在所加电压为3～4V时，观察到明显的负电阻特性，电流峰谷比最大约为8。负电阻现象及峰谷比的大小受膜厚和器件的结构、制备工艺等影响。提出用负电阻和二极管并联组成的等效电路模型解释影响负电阻特性的因素，认为负电阻特性与载流子的不平衡注入有关。在此基础上设计、合成了主链含唔二唑电子传输基团的可溶性聚对苯撑乙烯衍生物，该聚合物兼具空穴和电子传输功能，在空气中具有较稳定的N型负电阻特性。进一步控制相关材料和工艺条件，有可能得到易于控制的负阻效应，开发出新型的有机负电阻器件。     

Quantitative assessment of solid oxide electrochemical doping

Quantitative analysis of metal cation doping by solid oxide electrochemical doping (SOED) has been performed under galvanostatic doping conditions. A M–β″-Al₂O₃ (M=Ag, Na) microelectrode (contact radius: about 10 μm) was used as cation source to attain a homogeneous solid–solid contact between the β″-Al₂O₃ and doping target. In Ag doping into alkali borate glass, the measured dopant amount closely matched the theoretical value. High Faraday efficiencies of above 90% were obtained. This suggests that the dopant amount can be precisely controlled on a micromole scale by the electric charge during electrolysis. On the other hand, current efficiencies of Na doping into Bi₂Sr₂CaCu₂O_y (BSCCO) ceramics depended on the applied constant current. Efficiencies of above 80% were achieved at a constant current of 10 μA (1.6 A cm⁻²). The relatively low efficiencies were explained by the saturation of BSCCO grain boundaries with Na. By contrast, excess Na was detected on the anodic surface of ceramics at a constant current of 100 μA (16 A cm⁻²). In the present study, we demonstrate that SOED enables micromole-scale control over dopant amount.     

Energy levels in doped SiGe quantum well studied by admittance spectroscopy

SiGe/Si quantum wells (QWs) with different Boron doping concentrations were grown by molecular beam epitaxy (MBE) on p-type Si(1 0 0) substrate. The activation energies of the heavily holes in ground states of QWs, which correspond to the energy differences between the heavy hole ground states and Si valence band, were measured by admittance spectroscopy. It is found that the activation energy in a heavily doped QW increases with doping concentration, which can be understood by the band alignment changes due to the doping in the QWs. Also, it is found that the activation energy in a QW with a doping concentration of 2 × 10²⁰ cm⁻³ becomes larger after annealing at a temperature of 685 °C, which is attributed to more Boron atoms activation in the QW by annealing.     

Preparation and characterization of nitrogen-doped TiO2 photocatalyst in different acid environments

Nitrogen-doped TiO₂ powders were successfully prepared by a wet method, i.e., a micro-emulsion-hydrothermal method, in different acid environments. Several characterization techniques, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and UV-visible diffuse reflectance spectra, were combined to determine the crystal phase, concentration and chemical states of the nitrogen doped in TiO₂. The high photocatalytic activity of the nitrogen-doped TiO₂ was evaluated through the decomposition of rhodanmine B under visible light irradiation. It was suggested that the doped nitrogen formed oxynitride (NO) and produced impurity states at higher above the valence band of TiO₂. Therefore, the nitrogen doping could enhance the response of photocatalyst to the visible light and improve the photocatalytic activity because of the narrowing of band gap of TiO₂.     

Structural and Optical Properties of Sol-Gel Derived Aluminosilicate Planar Waveguides Doped with Er3+ Ions

Er3+ doped-aluminosilicate thin films were prepared on silica and silica/Si substrates by the sol-gel process and dip-coating. The sol-gel aluminosilicate planar waveguides were prepared from silicon and aluminium alkoxides. Their structural characterization has been carried out by Raman spectroscopy, Atomic Force and Scanning Electron Microscopies. The results indicated that these films present an amorphous structure until an annealing temperature of 900°C, while at temperatures higher than 1000°C, crystallization occurs. An estimate of microcrystallite sizes using Raman spectroscopy is given, which agrees with data from scanning electron microscopy. The optical properties have been investigated by Fluorescence spectroscopy in the visible region.     

手性液晶掺杂剂（S）—4‘—辛氧基—4—（2—酰氧基—丙氧基）联苯的合成

手性液晶掺杂剂（Ｓ）┐４┐辛氧基┐４┐（２┐酰氧基┐丙氧基）联苯的合成马汝建李培荣国斌＊（华东理工大学化学系上海２００２３７）关键词铁电液晶材料，手性液晶掺杂剂，合成，手征性１９９７－０２－０３收稿，１９９７－０８－０７修回铁电液晶显示器所用的材料...