光突发交换的交换控制策略和光缓存配置

光突发交换是面向下一代互联网的光交换模式.讨论了异步光突发交换系统的交换控制策略以及相应光缓存的优化配置策略.除了传统预约模式的交换策略,还研究了非预约和改进型预约模式,它们的性能评估由计算机仿真给出.结果表明:在条件相当情况下,改进型预约模式具有最低的丢包率.同时光缓存的配置对上述几类交换控制策略的性能都有很大影响,仿真结果指出:光缓存的粒度对系统性能具有重要影响,所讨论的几类交换模式都存在最佳时延粒度,研究结果对光交换矩阵的设计有指导意义.     

Magnetic structures and crystal field in the heavy electron materials YbAgGe and YbPtIn

We have examined the magnetic properties of the heavy electron compounds YbAgGe and YbPtIn by ¹⁷⁰Yb M?ssbauer spectroscopy down to 0.1 K, and the crystal field properties of YbAgGe by Perturbed Angular Correlations (PAC) measurements up to 900 K. In YbAgGe, we show that each of the two magnetically ordered phases below 0.8 K involves a specific incommensurate modulation of the Yb moment. An analysis of existing low temperature specific heat data suggests the persistence of fluctuations of the correlated Yb spins down to 0.1 K. The PAC data allow to discriminate among proposed Yb³⁺ crystal field level schemes. In YbPtIn, we show that the low temperature magnetic order phase has an antiferro-para structure, where zero moment Yb ions coexist with large moment ones, and that a 90° moment reorientation occurs at 1.4 K.     

Radiation induced polymerization of vinyl monomers and their application for preparation of wood-polymer composites

Polymerizing effects of high energy radiation has been found suitable for preparation of wood-polymer composites. In the present work after evaluating polymer products that have been obtained by irradiation method, wood-polymer composites have been prepared by in situ polymerization of vinyl acetate, acrylic acid and acrylic acid/styrene mixture using two samples of Iranian hardwoods, Beech and Hornbeam. These woods and their composites have been tested for their physical and mechanical properties. The results have shown that chemical bonding between polymer and the cell wall component lead to better strength properties in the composites.     

Synthesis and burst strength of water‐swollen immunoisolatory tubules

A series of amphiphilic hydrogel tubules have been prepared by copolymerizing/crosslinking hydrophilic poly(dimethylacrylamide) segments with hydrophobic di‐, tri‐, and octamethacrylate‐telechelic polyisobutylene crosslinkers, and their elastic modulus and burst strength in the water‐swollen state were investigated. Because the burst characteristics of hydrogels have not yet been quantitatively investigated, equipment was designed and built to generate fundamental insight into the burst properties of thin‐walled (200–250 μm) narrow lumen (2–3 mm i.d.) water‐swollen tubules. The theory developed to describe quantitatively the inflation behavior of thin‐walled rubber tubules was adapted to treat our experimental observations. Changes in the burst strength, elastic modulus, and expansion during the inflation of hydrogel tubules were interpreted in terms of the molecular weight of the hydrophilic segments between crosslinking sites (M_{c,hydrophilic}), which in turn was calculated according to the rubber elasticity theory. According to these investigations, the burst strength of our water‐swollen amphiphilic tubules is in the 0.2–0.5 MPa range, which is sufficient for implantation and immunoisolatory applications. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 2075–2084, 2002     

细胞呼吸爆发的微量量热学研究

The heat production of Wistar rat polymorphonuclear leukocytes (PMN) was measured by an LKB 2277 Thermal Activity Monitor. When PMN were activited with phorbol-12-myristate13-acetate (PMA), the respiratory burst was recorded by greatly incr eased heat production. Experiment was also carred out in the present of the inhibitor, Total Flavonoids of Lycium Barbarum L. (TFL). The respiratory burst heat production peak was disappeared, but the heat production curve was higher than that of PMA because TFL increased the metabolic activities of PMN.     

A maximum-efficiency-first multi-path route selection strategy for optical burst switching networks

In this paper, the impact of a path selection on other existing paths in optical burst switching (OBS) networks is studied by analyzing the contention among different traffic streams and the interaction between the route selection and traffic load balance. The results show that there exists a mutual reinforcement interaction among the traffic load of a path, the path burst loss ratio and the contention ability of the path when burst loss ratio based multi-path selection strategies are adopted, which may increase the unbalance of traffic and lead to severe congestion further. A maximum-efficiency-first multi-path selection strategy, which considers the performance of the burst flows and the impact of a path selection on existing OBS paths at the same time by a combined metric of route efficiency, is proposed to maximize the utility of the burst flows and minimize the increment of lost throughput on the path. The performance of the proposed multi-path selection strategy is evaluated through simulation. The results show that the presented strategy obviously outperforms the least burst loss ratio strategy and shortest path first strategy in terms of the burst loss ratio in the practical unbalanced background traffic, especially when the network is heavily loaded.     

A continuum model for intermittent deformation of single crystal micropillars

Strain bursts are often observed during compression tests of single crystal micropillars. In this work, we formulate a new continuum model that accounts for the strain bursts within the framework of crystal plasticity. The strain bursts are separated from the loading stage (nearly elastic loading) by introducing a dimensionless constant in the continuum model, and are detected by load serrations. The boundary conditions in the context of micropillar compression are studied and they are shown to be changing and unpredictable as plastic deformation proceeds. To evaluate the validity of our model, finite element simulations of the uniaxial compression tests on nickel micropillars are performed. Our simulations produce clearly visible strain bursts during the plastic flow and the produced intermittent flows are comparable with the experimental observations. For the bulk crystal, a series of strain bursts is identified in the course of plastic flow, despite an apparently smooth stress–strain response. We also show that the intermittent flow is intensified in the micrometer-scale due to both increasing numbers of the successive strain bursts and increasing amplitude of the strain burst, when the specimen size decreases. Finally, we show that the occurrences of the strain bursts are always associated with negative values of the second-order work.     

适用于光突发交换网的可编程光缓存器

提出了两种适用于光突发交换网的可编程光缓存器结构：交叉型和多端口开关型.两种结构都能满足突发包缓存的超长性和可变性的要求,且结构简单紧凑,成本低,可扩展.交叉型缓存器通过指定信号在每个子缓存模块的光纤环中的循环次数即能实现可变时间的延迟.多端口开关型缓存器通过指定信号在两个多端口开关相应端口与所接光纤延迟线组成的光纤环中的循环次数实现可变时间的延迟.仿真结果表明,两种可编程光缓存器都能对光突发包实现ns级指定时间延迟,可用于解决光突发交换网突发包的冲突问题.     

光突发交换网络中最长队列优先调度组装机制

提出了光突发交换网络中的最长队列优先调度（LQF-SA）机制,将边缘节点的突发组装和突发调度两种技术紧密结合在一起.在现实网络中,业务通常是非均匀分布的,即在某些源宿对之间存在更大的业务流量.仿真结果表明,LQF-SA机制可以很好地完成非均匀分布业务流的组装.即使在均匀分布业务流输入下,LQF-SA机制在突发大小分布、组装效率和突发丢失率等方面也优于已提出的轮询调度组装（RR-SA）机制.     

Li-defect interactions in electron-irradiated n-type silicon by EPR measurements

Single crystal silicon, both with and without oxygen, has been diffused with lithium to concentrations ～10¹⁷/cm², irradiated with 1 to 1.5 MeV electrons, and the ensuing defects studies by EPR measurements. The presence of oxygen strongly affects the properties of these defects. Measurements have indicated the presence of two new defects which involve Li-one in O-containing material and one in O-free material. The defects are observed in their electron-filled state, and indicate a net electron spinof ½. The defect spectra disappear (with time) at room temperature, and can be explained by the formation of other Li-involved defects which lie deeper in the energy bandgap and are not visible by EPR. Electron irradiation at 40 °K followed by annealing at higher temperatures show that both EPR defects described above begin to form at about 200 °K and begin to decrease at about 275 °K-just as does the 250 °K reverse annealing observed generally for n-type Si. Based on these data, and the work of others, it is suggested that both defects form as a result of the motion of Si interstitials which produce a (Li-O-interstitial) complex in O-containing Si, and a (Li-interstitial) complex in O-free Si.