Collective Tunnelling of Strongly Interacting Cold Atoms in a Double-Well Potential

It is known that under resonance conditions, a group of strongly interacting bosonic atoms, trapped in a double-well potential, mimics a single particle, performing Rabi oscillations between the wells. By implication, all atoms need to tunnel at roughly the same time, even though the Bose–Hubbard Hamiltonian accounts only for one-atom-at-a-time transfers. The mechanism of this collective behavior is analyzed, the Rabi frequencies in the process are evaluated, and the limitation of this simple picture is discussed. In particular, it is shown that the small rapid oscillations superimposed on the slow Rabi cycle result from splitting the transferred cluster at the sudden onset of tunnelling, and disappear if tunnelling is turned on gradually.     

来自磁光阱中冷原子团的荧光干涉条纹及其应用

实验观察来自磁光阱中冷原子团的荧光经真空系统窗口的平板玻璃反射产生的干涉条纹，理论分析表明从从荧光干涉条纹的强度分布可获得关于俘获原子总数以及密度分布的信息。采用该方法实测了俘获原子总数，并模拟得到了不同密度分布时条纹的对比度变化。     

微球板电子倍增器基体制备技术研究

新型微球板电子倍增器和微通道板相比具有高增益、无离子反馈、制备简单、造价低廉等优点。介绍了微球板电子倍增器的工作原理、特点和广阔的应用前景。由于微球板基体的形成技术是微球板制备的关键技术，论文从理论上研究了微球板基体烧结过程中的烧结速率。并采用自行设计组分的高铅玻璃，用立式炉成珠设备进行了玻璃微珠的制备。探索了微球板制备过程中玻璃微珠的分级技术、微球板电子倍增器基体成型工艺和技术。制备出基本满足要求的微球板电子倍增器基体。给出了制造的样品和文献上样品结构的SEM对比照片，最后对实验过程中的一些现象进行了分析，并给出了实验的结论。     

Cold compaction of ceramic powder: Computational analysis of the effect of pressing method and die shape

This paper deals with a computational analysis of the influence of the pressing method and part geometry on the final density distribution in the cold compaction process of ceramic alumina powders. The analysis is based on the explicit finite-element model proposed and validated in a previous study. The mechanical behavior of the processing material is described using a multisurface elastoplastic model, the modified Drucker-Prager/Cap model Published in Prikladnaya Mekhanika, Vol. 43, No. 10, pp. 129–134, October 2007.     

微脉冲电子枪的初步实验研究

给出了微脉冲电子枪的模拟计算及其初步实验结果. 该电子枪采用铜铝镁合金作为冷阴极材料, 在以磁控管作为微波功率源的出束实验中得到了100mA/cm²的电流密度.实验结果与次级电子倍增解析计算和SEEG程序的模拟计算结果基本符合, 初步验证了微脉冲电子枪的基本原理, 为今后实验中得到更大的电流密度打下了基础.     

测量冷原子温度的理论与近似拟合公式的误差分析

对短程飞行时间法(tim e-of-flight,TOF)中推算冷原子温度的理论拟合公式与近似拟合公式进行了误差分析与比较。研究表明:对于使用短程飞行吸收光谱信号推测冷原子团温度,当探测光光斑半径与冷原子团高斯半径之比k小于0.2时,理论拟合公式和近似拟合公式能很好的相符,随着探测光光斑半径与冷原子团高斯半径比值的逐渐增大,用近似拟合公式所得TOF吸收信号与用理论拟合公式所得TOF吸收信号的误差也将逐渐增大,当比值为0.5时,用近似拟合公式所得TOF吸收信号的误差将增大到20%。     

Design and Cold Tests of Asymmetric Quasioptical Resonators

This paper presents the design and test of asymmetric quasioptical resonators for gyrotron applications, where most of the diffraction output coupling comes from the smaller of two mirrors. A computer code based on scalar diffraction theory is used to calculate the resonator losses and the electric field near the mirrors. Resonators with mirror separations approaching confocal have reduced side lobes in the diffraction patterns, which should allow for better power transmission and focusing. Cold tests have been performed at 94 and 141 GHz to measure the quality factor of the asymmetric resonators as a function of mirror separation and mirror misalignment. Typical resonator parameters include 65 cm mirror separation, 1-3% output coupling and 85% of the losses from the small mirror. A half-symmetric resonator with one flat and one curved mirror has also been investigated. The calculated values of Q are in reasonably good agreement with the cold test measurements.     

Nd掺杂的Bi4Ti3O12变温X射线衍射分析

利用变温X射线衍射技术，在预烧过程中分析了Nd掺杂Bi4Ti3O12后生成Bi3.15Nd0.85Ti3O12（BNT）相的形成过程以及微结构的变化．实验观察到以30℃／min的升温速率，BNT相在700℃时开始形成，其衍射峰强度随温度的继续升高而增强，衍射峰半高宽随烧结时间延长而减小．X射线衍射分析结果表明，在900℃恒温条件下，烧结约2h，可形成单一的BNT相．     

Modification of a three-way catalyst washcoat by aging: A study along the longitudinal axis

This work reports the research carried out by studying aliquots extracted at different axial coordinates from Three Way Catalyst (TWC) monoliths aged under real traffic conditions. Our study focused on the catalytic properties and on several chemical and physical effects caused in the Front and Rear monolith washcoat surfaces by vehicle aging after 60,000 km. Regarding the catalytic properties, all the used aliquots showed poorer activity than their corresponding fresh counterparts. The strongest deactivation was detected for NO and hydrocarbon conversion. CO conversion was less affected and the Rear monolith was as deactivated as the Front one. The characterisation techniques (TXRF, N₂ adsorption-desorption isotherms, XRD and H₂-TPR) detected - (i) the deposition of P, Zn and Pb; (ii) the formation of CePO₄ on account of the Ce from the washcoat; (iii) thermal sintering; (iv) inhibition of the reducibility of Ce oxides - as the main effects brought about by vehicle aging conditions. The deactivation observed at the beginning of the Front monolith was the result of a combination of the former effects. When moving downstream to higher axial coordinates, Pb accumulation and the loss of specific area appeared to be the only probable sources of deactivation.     

冷态德士古气化炉流场与停留时间分布的研究

测定了德士古气化炉的冷态速度分布和停留时间分布。结果表明：德士古气化炉内在轴向２．５～３．０倍直径范围内存在回流，最大回流量为射流量的３．５倍左右；在平均停留时间之前，已有５０％左右的物料逸出炉外。本文指出，德士古气化炉中存在的问题，如结渣、耐火砖寿命短、有效气体成分偏低均与炉内流场有关。