A post curing strategy toward the feasible covalent adaptable networks in polyacrylate latex films

The implementation of covalent adaptable networks (CANs) in general resin system is becoming attractive. In this work, we propose a simple post-curing strategy based on the core-shell structured acrylate latex for the achievement on both the improved general performance and the CANs characteristics in latex films. The building to the CANs was relied on the introduction of 4,4′-diaminophenyl disulfide as the curing agent, which cured the acetoacetoxy decorated shell polymer through the ketoamine reaction. The metathesis reaction of aromatic disulfides in the crosslinking segments enabled the thermally induced dynamic behavior of the network as revealed in the stress relaxation tests by comparison with other diamine crosslinking agents without the incorporation of disulfide. The synergism of the dynamic crosslinking of the shell polymer and static crosslinking in the core polymer contributed to the improved mechanical strength (15 MPa, strain% = 250%) and the suppressed water adsorption (~1% in 24 h of soaking) of the latex film, which exhibited above 90% of recovery in both strength and strain from a cut-off film damage within 1 h at 80°C. Moreover, the cured latex film could be recycled, and 75% of the mechanical performance was regained after three fragmentation-hot-pressing cycles. These, in addition with the feasible and environmental friendly characteristics, suggest a sustainable paradigm toward the smart thermosetting latex polymers.     

对位酚类衍生物作为化学发光分析的增强剂研究

在化学发光分析中，常常要用到碱性条件下鲁米诺与过氧化氢的反应系统，通过催化剂辣根过氧化物酶使反应顺利进行。如果再加入适当的增强剂，则灵敏度提高且发光时间延长，可改善测定的重现性。实验证明，对位酚类衍生物，如：对叔丁基苯酚，对甲苯酚的发光增强作用明显，其发光效率可上升几十倍，发光时间也获得有效延长。     

铁铝催化体系催化丙烯酸丁酯聚合

研究了Fe(acac)3-Al(i-Bu)3-8-羟基喹啉(acac=乙酰丙酮)催化体系催化丙烯酸丁酯(BA)聚合，考察了聚合规律，用凝胶渗透色谱研究了聚合物分子量和分子量分布．动力学研究表明聚合反应对单体浓度呈一级关系，表观活化能为13．9kJ／mol．     

Mechanisms of n‐butanol formation in butyl acrylate latexes

The mechanisms involved in the formation of n‐butanol during the synthesis of butyl acrylate containing latices were investigated. The experimental results showed that neither the hydrolysis of butyl acrylate nor of the ester bond in the butyl acrylate segments of the polymer played a major role in the formation of n‐butanol, which was mainly generated from the polymer backbone, by transfer reactions to polymer chain followed by cyclization. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5838–5846, 2007     

Diffraction grating in noncrosslinked polymers

The diffraction efficiency and morphology of the transmission modes of holographic polymer dispersed liquid crystals were studied with respect to the molecular structure of poly(urethane acrylate) (PUA), the film (polymer/liquid crystal) and resin (oligomer/monomer) compositions, and the cell thickness. PUA, based on N‐vinylpyrrolidone and ethyl hexyl acrylate, with low‐molecular‐weight poly(propylene glycol) at a low oligomer content, showed high diffraction efficiency. The results were interpreted in terms of the monomer reactivity and polymer elasticity. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 613–620, 2004     

Determination of residual monomers in acrylate dispersions by gas chromatography

The content of residual monomers is one of the most important characteristics of polymer dispersions. As a result of the similar physicochemical parameters of ethyl acrylate and methyl methacrylate, it is very difficult to determine the residual monomers in acrylate dispersions obtained by emulsion polymerization of both monomers. Gas chromatography with capillary columns, however, permits separation of these monomers and their quantitative determination in acrylate dispersions.     

α，ω-二羧基-甲基丙烯酸丁酯低聚物的合成及MS分析

利用传统自由基聚合法，在四氢呋喃溶液中自由基引发聚合甲基丙烯酸丁酯单体而得到ω-羧基-甲基丙烯酸丁酯低聚物(CTBMA)(分子量在1500左右)；利用CTBMA末端酯基的反应特性，在二氧六环／水／KOH混合溶液中皂化CTBMA，使之转化为α，ω-羧基甲基丙烯酸丁酯低聚物(di-CTBMA)；研究了溶剂的类别、反应时间等反应条件对皂化产物结构的影响；利用MALDI-TOF-MS及LSIMS对皂化各阶段产物进行了分析监测．实验表明，在适当的皂化条件下，CTBMA皂化时主要为末端酯基转化为羧基，相应得到的产物di-CTMBA具有很好的结构特性，其官能团度(functionality)接近2．     

聚丙烯酸长链酯的Huggins常数与其分子量的依赖性关系

聚丙烯酸高碳醇酯(PBA)及聚丙烯酸十八醇酯(POA)是具有长烷基侧链的梳状聚合物,在溶剂苯中的Huggins常数(k′)随其分子量(M)的变化而变化.在PBA-苯体系中发现,当M低于某一临界分子量(MLC)时,k′随分子量的降低显著增大;当M大于某临界分子量(MHC)时,k′随分子量的升高而增大;当M在MLC～MHC时,k′基本上保持不变.而在POA-苯体系中发现,当M低于某一临界分子量(MC)时,k′随分子量的降低显著增大;当M大于该临界分子量(MC)时,k′在0.33～0.43变化.文中同时给出了精确算法用来计算PBA-苯体系及POA-苯体系中PBA及POA的特性粘度.当k′＞0.758时,用稀释外推法计算;当0.758＞k′＞0.426时,用一点法公式[η]=ηsp/C(√)ηr计算;当0.426＞k′＞0.334时,用另一一点法公式[η]=(√)2(ηsp-lnηr)/C计算.     

Synthesis and characterization of 6‐ and 12‐arm star polymers by nitroxide‐mediated radical polymerization of St and MA from dendritic TIPNO‐based hexafunctional and dodecafunctional macroinitiators

Dendritic multifunctional macroinitiators having six and 12 TIPNO‐based alkoxyamines, TIPNO‐6 and TIPNO‐12 , were synthesized and used in the living radical polymerization of styrene (St), methyl acrylate (MA), N,N‐dimethylacrylamide (DMAAm), and isoprene (IP). The polymerizations of St initiated with TIPNO‐6 gave 6‐arm star polymers with narrow polydispersities of 1.14–1.18. In the polymerizations of MA initiated with TIPNO‐6 and TIPNO‐12 , the influences of added TIPNO on the polydispersity indexes (PDIs) of the resulting star polymers were first investigated, and this led to the successful formation of poly(MA) star polymers with narrow polydispersities (1.10–1.18). Moreover, the polymerizations of DMAAm and IP from TIPNO‐6 in the presence or absence of TIPNO were briefly investigated. The benzyl ether bonds of the poly(St) and poly(MA) star polymers were cleaved by treating with Me₃SiI or Pd/C, and the resulting arm's parts were analyzed with SEC. The PDIs of the resulting arm parts were low (1.19–1.23), and the M_ns agreed with the M_n,theor, indicating that the poly(St) and poly(MA) star polymers had well‐controlled arms. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4364–4376, 2007