像管亮度增益与背景测试仪

论述像管亮度增益与背景测试仪的原理，介绍仪器的组成以及测试数据的处理方法。     

Basic Characteristics of Synchrotron Radiation

Many advances have been made in chemical structure research over the past three decades using synchrotron radiation. Synchrotron radiation has a number of unique properties. They include high brightness, high collimation, broad energy spectrum, variable polarization, coherent power, and subnanosecond pulse width. The third-generation storage rings with wiggler and undulator sources and lower electron beam dimensions are delivering over 10¹² times higher brightness than laboratory-based sources. The future of synchrotron sources looks very promising with the development of energy recovery linac sources and free-electron laser sources. These will permit dynamic studies of chemical structure with subpicosecond time resolution. Commensurate with the development of X-ray sources, major progress has occurred in optical schemes to meet the challenging needs of chemical structure research. High-resolution monochromatization and submicron focusing of X rays present new avenues for the future.     

增强实验室X激光的亮度

实验室X激光已经取得重大进展,但均属自发辐射放大,缺乏模式限制的措施,故激光功率分散在多横模中,提高激光亮度的措施之一是模式限制.由于X光多层膜一般为高吸收膜,用以形成谐振腔作模式限制看来是困难的.本文建议采用相距足够远的二段激光等离子体作同步延迟行波放大来进行横模限制.分析表明,达到衍射极限的单横模X激光是可能的,这对X光全息术以及高亮度X激光的实现是十分重要的.本文还建议改变一般采用的产生线状等离子体的光学系统设计,使激光功率密度在长线上达到均匀;认为过去的光学系统不良是长焦线时,X激光增益-长度乘积低的一个可能原因.     

Monte Carlo simulation of spatial distribution of X rays in multifilm targets. III: optimum design as applied to W/Al‐film targets

The brightness of the X‐ray source in a W/Al‐film target used for X‐ray projection microscopy was studied by an approach using the Monte Carlo simulation. Since continuous X rays generated in a thin film have a specific angular distribution of emission, the brightness of the continuous X‐ray source cannot simply be estimated on the assumption that the angular distribution is homogeneous. The newly developed approach using the Monte Carlo simulation enables the evaluation of the effective source size, angular distribution, and brightness of a continuous X‐ray source with sufficient accuracy that it leads to the optimum design of a high‐brightness X‐ray source for uses such as X‐ray projection microscopy. The Monte Carlo calculations were performed for W(Δz)/Al (200 µm)‐film targets with different thicknesses of W film, Δz, under bombardment of 60 kV electrons. The results have suggested an optimum design consisting of a W (2 µm)/Al (200 µm)‐film target as most promising for providing an X‐ray source of higher brightness than the W (5 µm)/Al (200 µm)‐film target, which has already been in practice for X‐ray projection microscopy. Copyright © 2006 John Wiley & Sons, Ltd.     

Two Intercalation Mechanisms of Oxazole Yellow Dimer (YOYO-1) into DNA

The oxazole yellow dye, YOYO-1 (a symmetric homodimer), is a commonly used molecule for staining DNA. We applied the brightness analysis to study the intercalation of YOYO-1 into the DNA. We distinguished two binding modes of the dye to dsDNA: mono-intercalation and bis-intercalation. Bis-intercalation consists of two consecutive mono-intercalation steps, characterised by two distinct equilibrium constants (with the average number of base pair per binding site equals 3.5): K1=3.36±0.43×107M−1 and K2=1.90±0.61×105M−1, respectively. Mono-intercalation dominates at high concentrations of YOYO-1. Bis-intercalation occurs at low concentrations.     

百瓦级高亮度光纤耦合半导体激光模块的研制

用3只976 nm半导体激光短列阵作为子模块,研制出连续工作的百瓦级高亮度光纤耦合模块。首先,利用光束转换器将每个半导体激光短列阵进行光束整形;然后采用空间复用技术将3个半导体激光短列阵在光参数积小的方向上叠加,并利用倒置伽利略望远镜作为扩束器进一步压缩发散角;最后利用优化结构的透镜组将激光聚焦到芯径200 μm,数值孔径为0.22的光纤中。测量结果显示:聚焦后激光的发散角为24.8°,焦平面的光斑尺寸为175.2 μm;耦合后测量光纤出光功率可达107 W,对应亮度为2.23 MW/(cm²·sr),达到了国内利用列阵进行光纤耦合的领先水平;在工作电流为52.5 A时,电光转换效率为43.1%,远高于全固态等激光器;最后测量本模块在不同驱动电流时的光谱,并以此计算出模块的热阻为1.29 K/W,说明它的散热性能良好。结果表明,本光纤耦合模块适合应用于泵浦光纤激光器、医疗和激光加工等领域。     

Brightness Temperature Emitted by Radiometer Calibration Load at Millimeter Wave Band

In this paper, the DVRT (vector radiative transfer theory of densely distributed random discrete scatters) model to calculate the brightness temperature emitted by radiometer calibration load is presented. It takes the multiple scattering of isolation layer into account, which is neglected by the incoherent homogeneous model often used in calibration. Hence, it works much better than incoherent homogeneous model at millimeter wave band. Furthermore, the iteration of DVRT model is presented, and it proves that the incoherent homogeneous model is just the zero-order solution of DVRT model. Some numerical results are provided in the end.     

高功率980nm垂直腔面发射激光器的亮度特性

在循环水冷却(工作环境温度控制在15℃)和连续注入电流条件下,从垂直腔面发射激光器(VCSEL)亮度基本定义出发,实验测量了不同注入电流时口径为400μm的高功率980nm InGaAs/GaAs应变量子阱垂直腔面发射激光器(VCSEL)的亮度特性。结果表明:在注入电流4 A时,随着注入电流的增加,亮度也跟着增加;当注入电流4A时,尽管输出功率在增加,但是器件的光束质量变差,M2因子升高,表明此时影响器件亮度的主导因素是M2因子,所以亮度减小;在注入电流为4A,输出功率为1.2W时,亮度达到最大值2.43kW/cm2.sr,此时的光束质量最好,M2因子为207。最后,分析了影响高功率VCSEL器件亮度特性的主要因素,提出了提高器件亮度特性的解决方法。     

像增强器增益对输出信噪比影响的分析

针对传统上像增强器输出信噪比测试条件的不完备性,阐述了亮度增益对输出信噪比的影响,在不同增益条件下利用设计的像增强器信噪比测试仪对输出信噪比进行了测试,验证了在输出信噪比测试中亮度增益标定的必要性。     

360 GHz辐射计探测地面目标试验

为验证亚毫米波辐射计在弹药末制导中的应用可行性,计算了不同天气条件下天空亮温和视在温度,利用360 GHz辐射计对地面金属目标和涂层隐身目标进行了模拟探测试验。计算和试验表明,在寒冷干燥的季节,辐射计可以探测到地面金属目标,随着温度和湿度的升高,辐射计很难再探测到目标;对于高温涂层隐身目标,辐射计可以探测到,而不受天气的限制。