Blind Channel Identification Based on Noisy Observation by Stochastic Approximation Method

A stochastic approximation algorithm for estimating multichannel coefficients is proposed, and the estimate is proved to converge to the true parameters a.s. up-to a constant scaling factor. The estimate is updated after receiving each new observation, so the output data need not be collected in advance. The input signal is allowed to be dependent and the observation is allowed to be corrupted by noise, but no noise statistics are used in the estimation algorithm.     

Surface morphologies of anthracene single crystals grown from vapor phase

The morphologies and lattice structures of anthracene single crystals grown from the vapor phase were investigated using optical microscopy, phase contrast microscopy, atomic force microscopy (AFM), and X-ray diffraction analysis. Common morphologies with hexagonal large planes were observed irrespective of crystal size. The observation of certain surface morphologies with a phase contrast microscopy revealed that the spiral steps originated from screw dislocations present on the (0 0 1) planes. Moreover, the center and edge of the (0 0 1) planes had large curvatures, similar to hills. Resultantly, quarter-monolayer (ML) steps were observed on the large and flat planes between both hills.     

利用弧形光栅尺测量大型转轴扭矩的原理研究

利用弧形光栅尺的旋转微位移测量功能,组建一组测量体系,用于测量巨型转轴的扭矩。采用四组相同的弧形光栅尺同时测量两截面的相对转角,通过多点测量实现误差均化,得出了消除转轴直径对测量影响的公式,使仪器的环境适应能力得到了极大地提高。根据不同的工作情况,提出了相应的动态测量扭矩的计算方程。实现了大型机械设备主传动的动力监测,为设备自动化、智能化奠定了基础。     

In situ observation of NaBi(WO4)2 dendrite growth and the study on microstructure of solidification

The dendrite growth process of transparent NaBi(WO₄)₂ with small prandtl and high melting point was studied by using the in-situ observation system. According to the dynamic images and detailed information, there are two kinds of restriction effect on the dendrite growth, the competition between arms and branches and the convection in the melt. The dendrite growth rate was time dependent, and the rate of arm growth reached the maximum 5.8 mm/s in the diffusive-advective region and rapidly decreased in the diffusive-convective region. The growth rate of branch had the same change trends as the arm’s. Based on the EPMA-EDS data of solidification structure of quenched NaBi(WO₄)₂ melt, it was found that there were component differences from stoichiometric concentration in the melt near the interface during the growth process. Supported by the National Natural Science Foundation of China (Grant No. 50331040) and the Innovation Funds from Shanghai Institute of Ceramics, Chinese Academy of Sciences (Grant No. SCX0623)     

A novel method for automated grid generation of ice shapes for local‐flow analysis

Modelling a complex geometry, such as ice roughness, plays a key role for the computational flow analysis over rough surfaces. This paper presents two enhancement ideas in modelling roughness geometry for local flow analysis over an aerodynamic surface. The first enhancement is use of the leading‐edge region of an airfoil as a perturbation to the parabola surface. The reasons for using a parabola as the base geometry are: it resembles the airfoil leading edge in the vicinity of its apex and it allows the use of a lower apparent Reynolds number. The second enhancement makes use of the Fourier analysis for modelling complex ice roughness on the leading edge of airfoils. This method of modelling provides an analytical expression, which describes the roughness geometry and the corresponding derivatives. The factors affecting the performance of the Fourier analysis were also investigated. It was shown that the number of sine–cosine terms and the number of control points are of importance. Finally, these enhancements are incorporated into an automated grid generation method over the airfoil ice accretion surface. The validations for both enhancements demonstrate that they can improve the current capability of grid generation and computational flow field analysis around airfoils with ice roughness. Copyright © 2004 John Wiley & Sons, Ltd.     

Qualitative Theory and Identification of Dynamic System with One Degree of Freedom

Dynamic systems described by nonlinear differential equations of the second order are studied. It is assumed that certain preliminary information on the dissipative or elastic characteristics of systems is known. A new approach is demonstrated to obtaining full information on unknown or partially known characteristics of a system from measurements of not only displacements but also velocities and accelerations __________ Published in Prikladnaya Mekhanika, Vol. 41, No. 6, pp. 139–143, June 2005.     

降脂经验方降脂作用的临床观察

采用自拟的降脂方治疗血胆增高患者６３人，并与用月见草油胶丸治疗患者６１人比较，前者疗效优于后者，两组有显著性差异。     

A central limit theorem in nonlinear filtering

It is shown that the probability law of a diffusion process conditioned on weakly corrupted observations is asymptotically Gaussian when properly scaled. The method of proof involves Fisher information matrices and a Cramér-Rao inequality.     

运用CAFP教学提升学生化学意志素质的教学案例

鉴于当前学生化学意志素质缺乏的问题，探讨以认知、情绪唤醒、情感、意志为主控目标，在预习、尝试学习、交错搭配合作学习中，开展CAFP教学研究，以促成情意因素对认知的调动、动力、强化等功能。     

Natural convection heat transfer at reduced pressures

This paper experimentally studies the natural convection heat transfer characteristics on horizontal and vertical plates at pressures lower than atmospheric value. Eight different pressures ranging from 10Pa to 101.325kPa, and three heating loads were used in the experiments. It is found that natural convection heat transfer characteristics at reduced pressures are independent of the plate arrangements and present different behaviors in two pressure ranges, 10Pa < p < 1000Pa and p > 1000Pa. The experimental heat transfer results are correlated into a non-dimensional equation to help the thermal design of stratosphere aircrafts and airborne equipment.