Reactivity of a N-Coordinated Germylene-Borane Complex: From Ge→B to Ge→Ga Coordination

Reactivity studies of the Ge^II→B complex L(Cl)Ge⋅BH₃ ( 1 ; L=2-Et₂NCH₂-4,6-tBu₂-C₆H₂) were performed to determine the effect on the Ge^II→B donation. N-coordinated compounds L(OtBu)Ge⋅BH₃ ( 2 ) and [LGe⋅BH₃]₂ ( 3 ) were prepared. The possible tuning of the Ge^II→B interaction was proved experimentally, yielding compounds 1-PPh₂-8-(LGe)-C₁₀H₆ ( 4 ) and L(Cl)Ge⋅GaCl₃ ( 5 ) without a Ge^II→B interaction. In 5 , an unprecedented Ge^II→Ga coordination was revealed. The experimental results were complemented by a theoretical study focusing on the bonding in 1 − 5 . The different strength of the Ge^II→E (E=B, Ga) donation was evaluated by using energy decomposition analysis. The basicity of different L(X)Ge groups through proton affinity is also assessed.     

Helicate tris(aryl)carbinolates bearing pendant NR2 donors – a new family of supporting ligands for the synthesis of Sc3+ alkyl complexes

The reactions of aryllithium reagents o-LiC₆H₄CH₂NR₂ with (MeO)₂CO afford two new tris(aryl)carbinols bearing pendant-NR₂ donor groups in the side chain [o-R NCH C H ] COH [R = Me, R + R = (CH) ]. These alcohols feature helical chirality due to differently inclined aromatic fragments and are presented in a crystalline cell as two M and P enantiomers. Carbinol (R = Me) readily reacts with (Me3SiCH2)3Sc(THF)2 to give a scandium bis(alkyl) complex [(o-C₆H₄CH₂NMe₂)₃CO]Sc(CH₂SiMe₃)₂ featuring rigid binding of the alkoxy anion through a κ¹-O, κ²-N chelating coordination mode     

Catalytic Nitrene Transfer by an FeIV-Imido Complex Generated by a Comproportionation Process

Nitrene transfer reactions have emerged as one of the most powerful and versatile ways to insert an amine function to various kinds of hydrocarbon substrates. However, the mechanisms of nitrene generation have not been studied in depth albeit their formation is taken for granted in most cases without definitive evidence of their occurrence. In the present work, we compare the generation of tosylimido iron species and NTs transfer from Fe^II and Fe^III precursors where the metal is embedded in a tetracarbene macrocycle. Catalytic nitrene transfer to reference substrates (thioanisole, styrene, ethylbenzene and cyclohexane) revealed that the same active species was at play, irrespective of the ferrous versus ferric nature of the precursor. Through combination of spectroscopic (UV-visible, Mössbauer), ESI-MS and DFT studies, an Fe^IV tosylimido species was identified as the catalytically active species and was characterized spectroscopically and computationally. Whereas its formation from the Fe^II precursor was expected by a two-electron oxidative addition, its formation from an Fe^III precursor was unprecedented. Thanks to a combination of spectroscopic (UV-visible, EPR, Hyscore and Mössbauer), ESI-MS and DFT studies, we found that, when starting from the Fe^III precursor, an Fe^III tosyliodinane adduct was formed and decomposed into an Fe^V tosylimido species which generated the catalytically active Fe^IV tosylimide through a comproportionation process with the Fe^III precursor.     

One-pot,one-step,and selective terpolymerization of ethylene oxide,propylene oxide,and COS to copoly(thioether)s with tunable thermal properties

Facile construction of sulfur-rich polymers using readily available raw chemicals is an area aggressively pursued but challenging. Herein we use common feedstocks of ethylene oxide (EO), propylene oxide (PO), and carbonyl sulfide (COS) to synthesize copoly(thioether)s which are traditionally produced from unpleasant and difficult to store episulfides. In this protocol, the EO/COS coupling selectively generates a pure poly(ethylene sulfide) (PES) with melting temperature (T_m) values up to 172°C and high yields up to 98%. The EO/PO/COS terpolymerization leads to the incorporation of soft poly(propylene sulfide) (PPS) and hard PES segments together, affording a random PES-co-PPS copoly(thioether) with the complete consumption of EO and PO. Additionally, by simply varying the EO/PO feeding ratio, the obtained copoly(thioether)s possess tunable thermal properties, T_m values in the range of 76–144°C, and excellent solubility. These copolymerizations are conducted in one-pot/one-step at industrially favored reaction temperatures of 100–120°C using catalysts of common organic bases, suggesting a facile and practical manner. Especially, the copoly(thioether) exhibits high refractive indices up to 1.68 owing to its high sulfur content, suggesting a broad application prospect in optical materials.     

Calcium-based coordination polymers from a solvothermal synthesis of HKUST-1 in 3D printed autoclaves

A mixed-metal 1D coordination polymer [CaCu(HBTC)₂(H2O)₈]_n (where H₃BTC – benzene-1,3,5-tric arboxylic acid) was obtained in a solvothermal synthesis of a well-known copper-containing metal–organic framework [Cu₃(BTC)₂(H₂O)₃]_n (HKUST-1) in autoclaves 3D-printed from commercial polypropylene. This material was a source of calcium ions, apparently, leaking from a colorant (calcium carbonate) promoted by glacial acetic acid as a modulator used to produce large single crystals of HKUST-1. This finding was confirmed by elemental analysis and a model experiment that resulted in a new calcium-based 1D coordination polymer [Ca(H₂BTC)₂(H₂O)₅]_n under the same solvothermal conditions with no copper or calcium salts put into a 3D-printed autoclave.     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Chemical bonding in representative astrophysically relevant neutral,cation, and anion HCnH chains

Most existing studies assign a polyynic and cumulenic character of chemical bonding in carbon-based chains relying on values of the bond lengths. Building on our recent work, in this paper we add further evidence on the limitations of such an analysis and demonstrate the significant insight gained via natural bond analysis. Presently reported results include atomic charges, natural bond order and valence indices obtained from ab initio computations for representative members of the astrophysically relevant neutral and charged HC_2k/2k+1H chain family. They unravel a series of counter-intuitive aspects and/or help naive intuition in properly understanding microscopic processes, e.g., electron removal from or electron attachment to a neutral chain. Demonstrating that the Wiberg indices adequately quantify the chemical bonding structure of the HC_2k/2k+1H chains—while the often heavily advertised Mayer indices do not—represents an important message conveyed by the present study.     

Synthesis and characterization of VO–vanillin complex immobilized on MCM-41 and its facile catalytic application in the sulfoxidation reaction,and synthesis of 2,3-dihydroquinazolin-4(1H)-ones and disulfides in green media

In this work, a vanillin complex is immobilized onto MCM-41 and characterized by FT-IR, X-ray diffraction, scanning electron microscopy, energy dispersive spectroscopy, thermogravimetric analysis, and BET techniques. This supported Schiff base complex was found to be an efficient and recoverable catalyst for the chemoselective oxidation of sulfides into sulfoxides and thiols into their corresponding disulfides (using hydrogen peroxide as a green oxidant) and also a suitable catalyst for the preparation of 2,3-dihydroquinazolin-4(1H)-one derivatives in water at 90°C. Using this protocol, we show that a variety of disulfides, sulfoxides, and 2,3-dihydroquinazolin-4(1H)-one derivatives can be synthesized in green conditions. The catalyst can be recovered and recycled for further reactions without appreciable loss of catalytic performance.     

桉树杂交种与其亲本的近红外光谱判别

研究桉树控制授粉后目标性状的基因作用方式是探索其基因重组规律的重要内容。常规的数量统计分析精度往往不高,而DNA分析的专业要求高,且费时费力。该研究利用近红外光谱(NIRs)研究不同基因型桉树杂交种、亲本及杂交种与亲本间近红外光谱信息的关系,探索NIRs用于桉树杂交种与其亲本判别的可行性和准确性。以控制授粉的桉树亲本及其杂交F1代材料为对象,每种基因型从各自田间试验分别选取10个单株,采集树冠中上部新鲜健康叶片。用手持式近红外仪Phazir Rx(1624)采集桉树杂交种与其亲本叶片的NIRs信息。每单株选10片完全生理成熟的健康叶片,避开叶脉扫描其正面光谱5次,以50条NIRs信息的均值代表单个叶片的NIRs信息,最终每个基因型获得10条NIRs信息。对原始NIRs采用二阶多项式S.G一阶导数预处理。预处理后的NIRs用于多元统计分析,首先对桉树杂交亲本和子代样本进行主成分分析(PCA),直观展示不同基因型的分类情况。然后运用簇类独立软模式(SIMCA)和偏最小二乘判别分析(PLS-DA)两种有监督的判别模式验证NIRs用于桉树杂交种与其亲本树种的分类判别效果。PCA结果显示,不同的亲本间、杂交种间及杂交种与亲本间样本的主因子得分可以清晰地将各基因型分开。SIMCA模式判别分析中,桉树杂交种样本到亲本PCA模型的样本距离显示,待判别样本能够形成单独的聚类,且能直观反映两者的遗传相似。PLS-DA判别结果显示,桉树杂交亲本的PLS模型能通过预测其杂交子代的响应变量将其与亲本准确分开。结果表明,桉树叶片的NIRs信息可以准确地反映桉树杂交子代遗传信息的传递规律,NIRs判别模型可以准确地将各种基因型予以区分。因此,NIRs信息不仅可用于桉树杂交种和纯种的定性判别,还可以分析桉树基因重组过程中加性遗传效应的大小,从而为桉树遗传基础分析及其育种改良研究提供理论支撑。