Fabrication and characterization of cellulose nanoparticles from maize stalk pith via ultrasonic-mediated cationic etherification

In this study, parenchyma cellulose, which was extracted from maize stalk pith as an abundant source of agricultural residues, was applied for preparing cellulose nanoparticles (CNPs) via an ultrasound-assisted etherification and a subsequent sonication process. The ultrasonic-assisted treatment greatly improved the modification of the pith cellulose with glycidyltrimethylammonium chloride, leading to a partial increase in the dissolubility of the as-obtained product and thus disintegration of sheet-like cellulose into nanoparticles. While the formation of CNPs by ultrasonication was largely dependent on the cellulose consistency in the cationic-modified system. Under the condition of 25% cellulose consistency, the longer sono-treated duration yielded a more stable and dispersible suspension of CNP due to its higher zeta potential. Degree of substitution and FT-IR analyses indicated that quaternary ammonium salts were grafted onto hydroxyl groups of cellulose chain. SEM and TEM images exhibited the CNP to have spherical morphology with an average dimeter from 15 to 55 nm. XRD investigation revealed that CNPs consisted mainly of a crystalline cellulose Ι structure, and they had a lower crystallinity than the starting cellulose. Moreover, thermogravimetric results illustrated the thermal resistance of the CNPs was lower than the pith cellulose. The optimal CNP with highly cationic charges, good stability and acceptable thermostability might be considered as one of the alternatively renewable reinforcement additives for nanocomposite production.     

光束发散度对紫外写入光纤光栅的影响

用傅里叶衍射光学分析了准分子激光束发散度对于光纤光栅制备的影响，发现光束发散角使光纤光栅的布拉格波长发生改变，相位版后干涉场沿光纤轴向和径向不均匀，对制备30dB高反射率光纤光栅造成困难。实验结果与理论分析基本一致，相对于理想平行光束情况，会聚光束使得光纤光栅布拉格波长出现在短波一边，发射光束使得光纤光栅布拉格波长出现在长波一边。     

扩宽OMA-Ⅵ同时谱宽的新方法

OMA－Ⅵ存在同时谱宽窄的缺点，本文用一种新方法大幅度地扩宽了它的同时谱宽，且不降低其系统分辨率，应用效果甚佳。     

超声光栅实验及其多普勒频移的一种简单研究方法

采用光子学方法,对超声光栅衍射实验和实验中出现的多普勒频移现象进行了研究,所得结论与采用光的波动性观点的惠更斯-菲涅耳原理及傅里叶变换等常规方法相同.该方法进一步加深了对衍射的本质和光的粒子性的理解并对光子的信息传递能力有初步的认识.     

甲基紫掺杂聚乙烯醇薄膜材料红光多重全息存储

甲基紫掺杂聚乙烯醇薄膜材料在两束相干光照射下生成相位光栅.当改变一束相干光光程,通过监测相位光栅的一级衍射信号强度的变化,可以检测相位光栅的生长和擦除过程.在此实验基础上,讨论了甲基紫掺杂聚乙烯醇薄膜材料多重全息存储的原理与结果.     

关于康托集类光栅的实验探究

设计制作了康托集分形衍射光栅,通过对康托集分形光栅3个阶段的夫琅禾费衍射现象的观察,根据惠更斯-菲涅耳原理,得到了一维康托集分形光栅的夫琅禾费衍射光强分布特性.     

Nd0.5Ca0.5Mn1-xAlxO3 (x=0,0.03)体系中电荷有序态的超声研究

系统研究了Nd0．5Ca0．5Mn1-xAlxO3(x=0,0．03)单相多晶样品在低温下的电磁性质和超声特性．电阻和磁化率测量表明,Nd0．5Ca0.5O3体系在TCO-257 K处发生了电荷有序相变．超声声速从室温开始随着温度的降低逐渐减小,并在TCO附近达到最小,之后,随着温度的进一步降低,声速急刷增加,同时伴随着一个尖锐的超声衰减峰出现.TCO附近的超声异常表明体系中存在着强烈的电-声子相互作用,该电-声子耦合来源于Mn3 的Jahn-Teller效应．在低温下,出现了另一个超声衰减峰,它的出现归结为反铁磁相与顺磁相之间的相分离现象.随着Al在Mn位的掺入,超声声速的最低点和衰减峰向低温移动,表明体系中的电荷有序态和反铁磁相均被部分抑制,     

Fiber torsion sensor demodulated by a high-birefringence fiber Bragg grating

A new high-birefringence (Hi-Bi) fiber torsion sensor demodulated by a Hi-Bi fiber Bragg grating (FBG) is proposed in this study. The twisted Hi-Bi fiber sensor characteristics are analyzed using the Jones matrix. The intensity ratio from two reflected Bragg wavelengths is associated with the twist angle of the measured Hi-Bi fiber. It is found that the twist angle resolution is estimated at around 0.3° under ±0.1 dB readout from an optical spectrum analyzer if the polarization state of the light source is stable. The advantages of this new torsion sensor are: (1) insensitivity to intensity variations from the light source, (2) insensitivity to the torsion gauge length, and (3) absolute measurement in the twist angle. However, the polarization state of light in the proposed method needs to be controlled, and any birefringence change in the twisted Hi-Bi fiber needs to be prevented.     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。