Mass and isotopic concentrations of water-insoluble refractory carbon in total suspended particulates at Mt.Waliguan Observatory(China)

Mass concentration and isotopic values δ¹³C and ¹⁴C are presented for the water-insoluble refractory carbon（WIRC） component of total suspended particulates（TSP）,collected weekly during 2003,as well as from October 2005 to May 2006 at the WMO-GAW Mt.Waliguan（WLG） site.The overall average WIRC mass concentration was（1183±120）ng/m³（n = 79）,while seasonal averages were 2081 ±1707（spring）,454±205（summer）,650±411（autumn）,and 1019±703（winter） ng/m3.Seasonal variations in WIRC mass concentrations were consistent with black carbon measurements from an aethalometer,although WIRC concentrations were typically higher,especially in winter and spring.The δ¹³C PDB value（-25.3 ± 0.8）%.determined for WIRC suggests that its sources are C₃ biomass or fossil fuel combustion.No seasonal change in δ¹³C PDB was evident.The average percent Modern Carbon（pMC） for ¹⁴C in WIRC for winter and spring was（67.2 ± 7.7）%（n = 29）.Lower pMC values were associated with air masses transported from the area east of WLG,while higher pMC values were associated with air masses from the Tibetan Plateau,southwest of WLG.Elevated pMC values with abnormally high mass concentrations of TSP and WIRC were measured during a dust storm event.     

Cu2O/TiO2-Bi2WO6三元复合催化剂的制备及光催化性能研究

采用水热法制备花状Bi2 WO6,并利用超声分散法制备了Cu2 O/TiO2-Bi2 WO6复合光催化剂,通过FESEM、XRD、XPS、FI-IR、UV-vis DRS和PL对光催化剂进行了分析和表征.表征结果证明:花状Bi2 WO6表面负载着碎片状的TiO2和立方体Cu2 O形成Cu2 O/TiO2-Bi2 WO6复合光催化剂;以短链脂肪酸(SCFAs)为牺牲剂,考察复合光催化剂的光催化产生氢气和烷烃的性能.实验结果表明:Cu2 O/TiO2-Bi2 WO6复合光催化剂以乙酸为牺牲剂,主要产氢气和甲烷,降解率高达91.82;;以丙酸为牺牲剂,产物主要是乙烷和丁烷,降解率高达90.70;;以丁酸为牺牲剂,除了氢气,甲烷,乙烷,丙烷,丁烷外,气体产物还含有一定量的戊烷,其降解率高达91.50;.结合反应液中间产物的成分进行检测,由此推断出光催化反应的可能机理.     

盐酸伊达比星杂质A的合成工艺优化及其高效液相分析

通过对盐酸伊达比星脱羟基杂质A的合成研究，为盐酸伊达比星的质控标准提供参考。以盐酸伊达比星为起始原料，经过4步反应得到脱羟基杂质A。本文提供了盐酸伊达比星杂质A的制备方法以及高效液相色谱分析方法，为杂质含量控制提供了依据。该工艺可以稳定、快速制备高纯度脱羟基杂质A，制备总收率为57.20%，纯度为57.20%，其结构经¹H NMR， ¹³C NMR和MS(ESI)表征。     

原子吸收光谱法测定铝锂合金中锂

本文研究了用原子吸收光谱法在笑气－乙炔火焰中测定铝锂合金中锂的最佳条件。其电离干扰可通过加进钾进盐来控制。应用本法测定合金中 锂的含量，获得了满意结果。     

共沉淀法制备Y_2O_2S∶Eu~(3+),Mg~(2+),Ti~(4+)红色长余辉材料

用共沉淀法制备了Y2O2S∶Eu3 ,Mg2 ,Ti4 红色长余辉材料。测量了材料的电子显微形貌、晶体结构和发射光谱。通过与固相法制备的Y2O2S∶Eu3 ,Mg2 ,Ti4 长余辉材料比较,发现两种方法都可以制备粒度基本相同的纯相Y2O2S基质晶体,但共沉淀法样品的颗粒结构更松散。研究了Eu3 浓度对两种方法制备样品的谱线发射强度的影响,通过比较共沉淀法和高温固相法制备的样品中Eu3 的5D1→7F3较高能级跃迁的587.6 nm谱线强度随Eu3 浓度的变化,发现共沉淀法更有利于Eu3 均匀进入Y2O2S基质晶格而形成有效的发光中心。     

V型三能级原子与非经典光场作用中光场特性的变化

研究了V型三能级原子BEC与双模压缩光场相互作用系统中,忽略原子间相互作用和考虑原子间相互作用时光场的正交压缩和光子数压缩。结果表明,光场的正交压缩依赖于压缩参数,而光子数压缩与压缩参数、光场信号强度有关,在一定条件下,两种压缩可同时存在。原子间相互作用影响两种压缩的涨落随时间变化的周期,以及正交分量涨落随时间变化的幅度,而对光子数压缩涨落随时间变化的幅度几乎无影响。     

A comparative study of the structure and crystallization of bulk metallic amorphous rod Pr60Ni30Al10 and melt-spun metallic amorphous ribbon Al87Ni10Pr3

Pr-based bulk metallic amorphous （BMA） rods （Pr60Ni30Al10） and Al-based amorphous ribbons （Al87Ni10Pr3） have been prepared by using copper mould casting and single roller melt-spun techniques, respectively. Thermal parameters deduced from differential scanning calorimeter （DSC） indicate that the glass-forming ability （GFA） of Pr60Ni30Al10 BMA rod is far higher than that of Al87Ni10Pr3 ribbon. A comparative study about the differences in structure between the two kinds of glass-forming alloys, superheated viscosity and crystallization are also made. Compared with the amorphous alloy Al87Ni10Pr3, the BMA alloy Pr60Ni30Al10 shows high thermal stability and large viscosity, small diffusivity at the same superheated temperatures. The results of x-Ray diffraction （XRD） and transmission electron microscope （TEM） show the pronounced difference in structure between the two amorphous alloys. Together with crystallization results, the main structure compositions of the amorphous samples are confirmed. It seems that the higher the GFA, the more topological type clusters in the Pr-Ni-Al amorphous alloys, the GFAs of the present glass-forming alloys are closely related to their structures.     

93W合金有关力学参量的综合选评

 对93W合金材料进行了超声测量实验，并结合原有的超声测量结果进行了分析比较，提出了可以直接用冲击波速度关系式的三个系数c₀ 、λ和λ′来对钨合金的有关力学参量，如G₀、K₀、G₀′、K₀′等进行综合选评的方法。得到了一组对93W合金较为合理的力学参量推荐值。     

Recent Experimental Results of HL-1M Tokamak and Progress of HL-2A Project

Recent experimental results of HL-1M tokamak and progress of HL-2A project are presented. Strong fishbone instability was observed during off-axis ECRH. This is first observation of the fishbone instability purely driven by energetic electrons produced by ECRH. The MBI was first proposed and demonstrated on HL-1M. Recently new results of MBI experiment were obtained by increasing the pressure of gas. A stair-shape density increment was obtained with high-pressure multi-pulse MBI just like the density evolution behavior during the multipellet injection. It is shown