Density functional theory investigation of the structure of SO2 and SO3 on Cu(1 1 1) and Ni(1 1 1)

Density functional theory (DFT) slab calculations, mainly using the generalised gradient approximation, have been used to investigate the minimum energy structures of molecular SO₂ and SO₃ on Cu(1 1 1) and Ni(1 1 1) surfaces. On Ni(1 1 1) the optimal local adsorption structures are in close agreement with experimental results for both molecular species obtained using the X-ray standing wavefield technique, although for adsorbed SO₂ the energetic difference between two alternative lateral positions of the lying-down molecule on the surface is marginally significant. On Cu(1 1 1) the results for adsorbed SO₂, in particular, were sensitive to the DFT functional used in the calculations, but in all cases failed to reproduce the experimentally-established preference for adsorption with the molecular plane perpendicular to the surface. This result is discussed in the context of previously published DFT results for these species adsorbed on Cu(1 0 0). The optimal geometry found for SO₃ on Cu(1 1 1) is similar to that on Ni(1 1 1), providing agreement with experiment regarding the molecular orientation but not the adsorption site.     

Sulfur adsorption on Fe(1 1 0): a DFT study

The adsorption of atomic S on the Fe(1 1 0) surface is examined using density functional theory (DFT). Three different adsorption sites are considered, including the atop, hollow and bridge sites and the S is adsorbed at a quarter monolayer coverage in a p(2 × 2) arrangement. The hollow site is found to be the most stable, followed by the bridge and atop sites. At all three sites, S adsorption results in relatively minor surface reconstruction, with the most significant being that for the hollow site, with lateral displacements of 0.09 Å. Comparisons between S-adsorbed and pure Fe surfaces revealed reductions in the magnetic moments of surface-layer Fe atoms in the vicinity of the S. At the hollow site, the presence of S causes an increase in the surface Fe d-orbital density of states between 4 and 5 eV. However, S adsorption has no significant effect on the structure and magnetic properties of the lower substrate layers.     

少量人发中硫的测定

建立了测定一根长2～3cm人发中硫的间接分光光度法,表观吸光系数为5.1×10~4,络合物组成Ba:CPA-mA为1:2,比耳定律范围为0～20μg硫。硫的检测限为0.025μg/mL,变动系数为2.7%,回收率为91.2～97.2%,且不用掩蔽即可直接进行测定,测定211例人发的结果表明,含硫量范围为(28.5±3.2)×10~3μg/g。     

Determination and fractionation of sulphur in a contaminated dredged sediment

Conversion of sulphur compounds in reduced, contaminated sediments that are brought in upland conditions may largely affect the potential mobility of heavy metal contaminants. We applied selected methods for the determination of total sulphur and sulphur fractions in a contaminated sediment in the reduced state and after gradual drying and oxidation during 1 month. Dry ashing, followed by ion chromatographic detection, was reliable for the determination of total sulphur. Good recoveries were obtained in both reference samples and spiked samples. Total sulphur was 14.5±0.6 g kg⁻¹ relative to dry sediment. Wet chemical methods that involve the determination of acid-volatile, Zn–HCl-reducible, chromium-reducible, acetone-soluble and HI-reducible sulphur were used to estimate specific sulphur forms. Results for acetone-soluble sulphur were to high and not consistent with results for other fractions. Major part of sulphur in the sediment (90%) was inorganic. Sulphides were converted partially to sulphate and to intermediary oxidised sulphur compounds upon oxidation of the sediment. The results suggested that the intermediary oxidised sulphur pool in the reduced sediment (2.5 g kg⁻¹) mainly consisted of pyrite, that was not converted during drying and oxidation. No significant changes in organic sulphur were detected.     

Volatile sulphur compounds in wines related to yeast metabolism and nitrogen composition of grape musts

The influence of nitrogen compounds in grape musts on the content of sulphur compounds of wines was studied. Different vinifications were performed with the addition of methionine (20 mg l⁻¹) and/or cysteine (40 mg l⁻¹) to grape musts before alcoholic fermentation. Six grape musts, with different nitrogen composition, from cultivars of the ‘Vinhos Verdes’ Region, in Portugal, were used. Addition of methionine to grape musts enhanced the content of wines in 3-(methylthio)-1-propanol, acetic acid-3-(methylthio)propyl ester, 3-(methylthio)propionic acid and some unidentified sulphur compounds. Increase of cysteine concentration in musts led to the production of wines with high levels of hydrogen sulphide and cis-2-methyltetrahydro-thiophene-3-OL and also unidentified sulphur compounds; however, the content of 3-(methylthio)propionic acid in the wines decreased considerately with the addition of cysteine to grape musts. This work showed that cultivars from the Vinho Verde Region show different sulphur compound contents. Avesso wines, elaborated from grape musts with low amino acids level, presented the highest total sulphur compounds content. Wines from Azal branco and Alvarinho were characterised by high contents of 4-(methylthio)-1-butanol and 3-(methylthio)propionic acid, respectively. A high content of N-(3-(methylthio) propyl)-acetamide and dimethylsulphone characterise the Loureiro wines. In contrast, Trajadura wines, produced from a must rich in amino acids, presented a low total sulphur compounds content; however, these wines were also characterised by high concentrations of 4-(methylthio)-1-butanol, acetic acid-3-(methylthio)propyl ester and hydrogen sulphide.     

Determination and fractionation of sulphur in a contaminated dredged sediment

Conversion of sulphur compounds in reduced, contaminated sediments that are brought in upland conditions may largely affect the potential mobility of heavy metal contaminants. We applied selected methods for the determination of total sulphur and sulphur fractions in a contaminated sediment in the reduced state and after gradual drying and oxidation during 1 month. Dry ashing, followed by ion chromatographic detection, was reliable for the determination of total sulphur. Good recoveries were obtained in both reference samples and spiked samples. Total sulphur was 14.5±0.6 g kg⁻¹ relative to dry sediment. Wet chemical methods that involve the determination of acid-volatile, Zn–HCl-reducible, chromium-reducible, acetone-soluble and HI-reducible sulphur were used to estimate specific sulphur forms. Results for acetone-soluble sulphur were to high and not consistent with results for other fractions. Major part of sulphur in the sediment (90%) was inorganic. Sulphides were converted partially to sulphate and to intermediary oxidised sulphur compounds upon oxidation of the sediment. The results suggested that the intermediary oxidised sulphur pool in the reduced sediment (2.5 g kg⁻¹) mainly consisted of pyrite, that was not converted during drying and oxidation. No significant changes in organic sulphur were detected.     

聚丙烯中硫酯类抗氧剂的质谱分析

采用齐格勒-钠塔催化剂使丙烯催化聚合得到聚丙烯。聚丙烯树脂本身具有优良的性能,如机械强度好,易加工成型,质量轻,成本低等,但也存在一些缺陷,如由于聚丙烯结构中存在叔碳原子,在造粒加工、贮存和使用过程中,易受热、光、氧等的作用而降解,导致材料的性能降低。为了抑制和延缓聚丙烯的氧化降解,需要在造粒阶段加入抗氧剂。本文以一种聚丙烯树脂样品为研究对象,采用溶剂抽提法提取有机添加剂,并用柱层析法对添加剂进行了分离;利用EI-MS分析了添加剂的组成,其中通过谱图解析,鉴定出添加剂中含有硫酯类抗氧剂-硫代二丙酸二(十四)酯(DMTP),并用此类常用化合物进行了验证,分析结果对树脂牌号的开发具有指导意义。     

基于荧光熄灭的二氧化硫选择性光化学敏感膜的研究

本文基于二氧硫对固定于增塑的聚氯乙烯膜上的芳香稠环化合物蒽的荧光熄灭，研制了二氧化硫选择性光化学敏感膜，经过组成优化 的敏感膜测定二氧化硫的浓度范围为6．59×10^-3-5.23×10^-1mol/L，校正曲线与理论推导的模拟曲线相吻合，且荧光信号具有较高的重现性，信号响应时间为5－30s.     

Conventional hydrothermal process versus microwave-assisted hydrothermal synthesis of La1−xAgxMnO3+δ (x = 0, 0.2) perovskites used in methane combustion

A study on the synthesis of La_1−xAg_xMnO_3+δ (x = 0, 0.2) using a microwave process (MWhyd) has been carried out by comparing the heating time and reaction temperature with the same factor under conventional thermal process (CHhyd). Experiments have been conducted using the hydrothermal method at medium pressure (T = 200 °C, P = 20 atm) followed by a thermal treatment of the precursor at 700 °C (10 h).Structural and physico-chemical properties of the catalysts were investigated using X-ray diffraction (XRD), BET sorption, temperature-programmed reduction or desorption, mass spectrometry (TPR-MS and TPD-MS), and X-ray photoelectron spectroscopy (XPS). While CHhyd and MWhyd powder catalysts exhibited the same XRD patterns indexed as pure perovskite structure, their surface physico-chemical properties were found to be strongly influenced by the preparation method. The effect of the nature of oxygen species, their amount and mobility, evidenced by temperature programmed experiments, on the catalytic properties in methane combustion in the presence and in the absence of hydrogen sulphide has been studied. MWhyd-La_0.8Ag_0.2MnO_3+δ catalysts were found to exhibit a much better performance in methane combustion together with higher resistance to sulphur poisoning than CHhyd catalysts.     

Comparison of sulphur and sulphur–oxygen ligands as ionophores for liquid–liquid extraction and facilitated transport of silver and palladium

The reactivity of new ligands described as S₁, S₅, S₂O₉ (in respect to character and amount of donors) towards metal ions was examined by extraction from HNO₃ and HCl media. These ligands were next utilised as carriers for Ag and Pd transport through a supported liquid membrane (SLM). The effect of collecting a greater number of S donors in one molecule and the influence of type of donors (O–S versus S) on efficiency and selectivity of Ag and Pd(II) extraction and transport were examined.

The extraction of Ag from HNO₃ solutions increased with increasing amount of S-donors in one molecule (S₁2O₉5). For palladium the sequence was different (S₅12O₉). The transport of Ag through SLM impregnated with m-chlorotoluene solution of ionophore increased in the same order as in the case of extraction, whereas for Pd the row was different: S₅2O₉1. The highest fluxes of Ag and Pd transported from HNO₃ equalled to 5.25×10⁻⁷ and 1.37×10⁻⁷ mol/m² s, respectively. Palladium flux depended on stripping solution type (Na₂S₂O₃相似文献