A survey of surface tension,molar volume and density for Sn–Ag–Cu–Bi–Sb quinary alloys as lead-free solders

ABSTRACT

By applying the geometric models and the theoretical equation, the surface tension, the molar volume and the density were studied. The empirical calculations were carried out in temperature range 623?K?≤?T?≤?1123?K. Only few thermophysical properties were estimated for eight quinary alloys: Sn3.55Ag0.5Cu3Bi3Sb, Sn3.48Ag0.5Cu3Bi5Sb, Sn3.48 Ag0.5Cu5Bi3Sb, Sn3.40 Ag0.5Cu5Bi5Sb, Sn3.53Ag1Cu3Bi3Sb, Sn3.46Ag1Cu3Bi5Sb, Sn3.46Ag1Cu5Bi3Sb, Sn3.38Ag1Cu5Bi5Sb. The results show that surface tension and density have a linear appearance for all temperatures. We have also studied the influence of the composition and temperature in the studied alloys. The obtained theoretical results are compared with the experimental ones and with the conventional Pb–Sn welds.     

Chalcogenide based all-solid-state thin electroplated ion-selective membrane for Hg(II) flow-injection determinations

The response to Hg(II) of a thin all-solid-state Te-doped silver chalcogenide membrane, described by the general formula Ag₂ + δSe_{1 − x}Te_x, which has been electrochemically prepared following a previously proposed approach, has been investigated. The kinetics of formation of the membrane's secondary dynamic response to Hg(II) has been successfully combined with the precise timing and transient signal, typical for flow-injection (FI) measurements, in developing a sensitive and reliable mercury FI detector. Under optimized stream conditions it exhibits a linear Nernstian response, with a double slope of the calibration graph of 59 mV dec⁻¹, over the mercury(II) concentration range 10⁻⁶ − 10⁻³ M, the typical sample throughput amounting to about 70 samples per hour. The observed chemical amplification of the signal is due to the specificity of the processes dominating the initial step in formation of the steady-state signal of the membrane to mercury. The analytical performance of the Hg(II) FI detector, as regards sensitivity, reproducibility, selectivity and long-term stability has been thoroughly investigated. The exact procedure for membrane electrodeposition is given and the potential of the proposed approach as a cost-effective way for preparing chalcogenides of unique structure and properties has been outlined in the above context.     

燃煤烟气中As、Se、Pb的形态分布及S、Cl元素对其形态分布的影响

基于化学热力学平衡分析方法，计算分析了燃煤烟气中重金属As、Se、Pb的形态分布规律，研究了S、Cl等元素对As、Se、Pb的形态分布规律的影响。结果表明，氧化性气氛下，As以As₂O₅、As₄O₆、AsO等氧化物的形式存在；Se主要以SeO₂形式存在；Pb在1000 K以下主要是固态PbSO₄，1200 K以上为气态PbO。还原性气氛下，As在较低温度时为固态As₂S₂，900-1400 K以As₂、AsS、AsN气体共存，2000 K以上全部转化为气态AsO。Se在1100 K以下主要以气态H₂Se存在，1100 K开始生成SeS和Se₂气体，1800 K时主要是气态Se和少量气态SeO；Pb在中低温时主要是PbS，1800 K以上气态Pb为主要存在形态。S在还原性气氛下增大了AsS（g）、PbS（g）、SeS（g）的比例，氧化性气氛下对As、Se、Pb形态分布基本无影响；Cl无论在氧化还是还原气氛下对As、Se影响均较小，但对Pb的形态分布影响较大。     

流动注射原子吸收光谱法测定富硒天麻、葡萄及大米中的硒

建立了流动注射氢化物发生-原子吸收光谱法测定富硒天麻、葡萄及大米中硒的方法。测定硒的线性范围为0．33μg/L-50μg/L，相对标准偏差小于3％，加标回收率为93％-106％。方法已广泛应用于实际样品中微量硒的测定。     

Adducts of Rh2[MTPA]4 with some phosphine chalcogenides: nature of binding and ligand exchange

Adducts of four phosphine chalcogenides with the chiral dirhodium complex ([Rh-Rh]) were investigated by variable-temperature 1H and 31P NMR spectroscopy in order to compare their properties as axial ligands. Whereas the selenide (1) and the sulfide (2) are strong ligands with electrostatic attraction and, in addition, a significant orbital (HOMO-LUMO) interaction, the phosphine oxide compounds (P=O) bind primarily via electrostatic attraction and are relatively weak donors. Moreover, the overall bond strength in these adducts depends on steric congestion around the P=O group.     

活泼配盐[(μ-RE)(μ-E′)Fe_2(CO)_6][Et_3NH][E,E′=S,Se]的亲电反应研究——蝶状Fe_2SSe及Fe_2Se_2簇合物的合成及表征

本文由［（μｔＢｕＳ）（μＣＯ）Ｆｅ２（ＣＯ）６］［Ｅｔ３ＮＨ］和硒粉形成的［（μｔＢｕＳ）（μＳｅ）Ｆｅ２（ＣＯ）６］［Ｅｔ３ＮＨ］，分别与溴化苄，二碘甲烷及邻一、间一、对一双（溴甲基）苯反应，合成了蝶状Ｆｅ２ＳＳｅ单簇物（μｔＢｕＳ）（μＰｈＣＨ２Ｓｅ）Ｆｅ２（ＣＯ）６（３ａ）和双簇物［（μｔＢｕＳ）Ｆｅ２（ＣＯ）６］２（μＳｅＺＳｅμ）［Ｚ＝ＣＨ２，ｏ．ｍ．ｐ双（亚甲基）苯］（４ａｄ）。类似地，由［（μＰｈＳｅ）（μＣＯ）Ｆｅ２（ＣＯ）６］［Ｅｔ３ＮＨ］和硫粉或硒粉所形成的［（μＰｈＳｅ）（μＳ）Ｆｅ２（ＣＯ）６］［Ｅｔ３ＮＨ］或［（μＰｈＳｅ）（μＳｅ）Ｆｅ２（ＣＯ）６］［Ｅｔ３ＮＨ］分别与对一双（溴甲基）苯反应合成了蝶状Ｆｅ２ＳＳｅ和Ｆｅ２Ｓｅ２双簇物［（μＰｈＳｅ）Ｆｅ２（ＣＯ）６］２［μＳ（ｐＣＨ２Ｃ６Ｈ４ＣＨ２）Ｓμ］（５ａ）及［（μＰｈＳｅ）Ｆｅ２（ＣＯ）６］２［μＳｅ（ＰＣＨ２Ｃ６Ｈ４ＣＨ２）Ｓｅμ］（５ｂ）。所有产物均经元素分析、ＩＲ和１ＨＮＭＲ表征。     

氢化物－气相色谱的元素光度检测器

研究开发的一种新型的元素光度检测器主要用于锗、砷、锡和锑的氢化物气相色谱检测，具有高灵敏，高选择性。它是在普通火焰光度检测器的基础上加装了特制的滤光片改制而成的。对锗、砷、锡和锑的检测限分别为３．０×１０￣（－１１）ｇ、７．０×１０￣（－１１）ｇ、７．０×１０￣（－１０）ｇ和１．１×１０￣（－８）ｇ，相对标准偏差分别为１．８％、２．４％、２．６％和３．０％。     

Synthesis of β-ketoenamine donors having O, N, Se/Te donor functionalities and their reaction chemistry with Pd(II) and Pt(II) metal ions

Monoanionic tridentate ligands LH_a and LH_b containing ONSe and ONTe donor sequences and their Pd²⁺ and Pt²⁺ derivatives were synthesized and characterized. The formation of a five- and a six-membered ring around the central metal atom and associative phenomena in solutions provide extra stability to the metal complexes.     

Study of metal-loaded activated charcoals for the separation and determination of selenium species by energy dispersive X-ray fluorescence analysis

Conversion of adsorption properties of activated charcoal (C^∗) by metal modification towards selenite, selenate and seleno-dl-methionine (Se-Met) was studied. Several metals were included in modification studies and also a procedure was developed for the separation and independent determination of microgram quantities of these selenium species in aqueous solution. Selenium species were collected one by one from the same sample solution onto collector material by adsorbing them directly or after complex formation onto different metal-loaded activated charcoals (MgC^∗ and FeC^∗). The mass of selenium in these collectors was measured directly by energy dispersive X-ray fluorescence spectrometry (EDXRF). Detection limits for all three selenium species were better than 6 μg corresponding to concentration of 60 μg/l with 0.100 l of initial sample volume.