QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Paper I: The use of measurement-time dependent single-aliquot equivalent-dose estimates from quartz in the identification of incomplete signal resetting

The identification of incomplete signal re-setting of optically stimulated luminescence signals in sedimentary quartz is a vitally important step in the continued improvement of optical dating. It is shown that narrow spectrum (blue-green) laboratory partial bleaching of aliquots of natural sedimentary quartz has a significant effect on equivalent dose (measured using a single aliquot procedure) calculated as a function of measurement time (D_e(t)). The blue-green stimulation spectrum mimics that found underwater and the results suggest that incomplete re-setting of waterlain sediments may be possible using the D_e(t) method.     

Radiation heat transfer in axisymmetric quartz glass tubes

A mathematical model is proposed to describe the heat transfer in quartz glass axisymmetric tubes. Heat is transferred inside the glass by radiation and conduction. Scattering of thermal radiation inside the glass is ignored. At the boundaries of the tube the radiative intensity is specularly reflected. The spectral dependent radiative intensity and the temperature distribution inside the tube are determined. The model is applied to simulate the cooling process of a quartz glass tube. The calculated temperature is in agreement with that obtained from an experiment. Furthermore, steady-state temperature distributions in quartz glass tubes of different lengths have been determined.     

An Oscillation Condition for an Electrode－separated Piezoelectric Sensor in Non－electrolyte Liquid

ＡｎＯｓｃｉｌｌａｔｉｏｎＣｏｎｄｉｔｉｏｎｆｏｒａｎＥｌｅｃｔｒｏｄｅ－ｓｅｐａｒａｔｅｄＰｉｅｚｏｅｌｅｃｔｒｉｃＳｅｎｓｏｒｉｎＮｏｎ－ｅｌｅｃｔｒｏｌｙｔｅＬｉｑｕｉｄＳＨＥＮＤａ－ｚｈｏｎｇ，ＨＵＡＮＧＭｉｎｇ－ｓｈａｎ，ＬＩＮＳｏｎｇ，Ｎ...     

用石英晶体微天平研究表面活性剂在银固态表面上的动态吸附

吸附是表面活性剂的一个重要特征.迄今用于原位监测表面活性剂在固体表面上吸附重量变化的方法尚不多见.近年来压电石英晶体作为一种高灵敏的质量传感器(石英晶体微天平)已被用于大气和溶液中多种微量成分的监测.用石英晶体微天平研究I~-、Br~-和表面活性剂在金电极上的吸附行为亦有报道.本文研究了十六烷基三甲基溴化铵(CTAB)、十二烷基磺酸钠(SDSO)、十二烷基硫酸钠(SDS)在银固态表面上的吸附平衡动力学特性及其吸附机制.     

用原子捕获技术提高火焰原子吸收光谱法的灵敏度

采用简易的石英原子捕获器，使Ｃｕ，Ａｇ，Ａｕ，Ｚｎ，Ｃｄ，Ｐｂ，Ｓｂ，Ｂｉ等易挥发元素在空气－乙炔火焰原子吸收光谱法中的灵敏度提高了３～５倍，并有较好的精密度，相对标准偏差在１％左右，方法中用此技术测定了标准物质中Ｐｂ、Ｃｄ的含量，获得了满意的结果，它较之石墨炉原子吸收光地具有快速，简便的特点，具有较大的实用价值。     

Direct electrochemistry of recombinant tobacco peroxidase on gold

Direct electron transfer (DET) reactions of recombinant tobacco peroxidase (rTOP), namely direct electroreduction of Compound I/Compound II and heme Fe^3+/2+ conversion, were studied on gold electrodes. rTOP of wild type, non-glycosylated, was produced using an Escherichia coli expression system. At pH 5.0, the redox potential for direct electrochemical transformation of the Fe^3+/2+ of the peroxidase heme was −143 mV vs. AgAgCl, and 0.26 ± 0.07 pmol of the adsorbed rTOP were in DET contact with the gold electrode. The total amount of the adsorbed rTOP estimated from QCM data was 53 ± 5 pmol/cm² or 1.67 pmol when referred to the surface area of the electrodes used for electrochemical measurements. Of 1.67 pmol of adsorbed rTOP, only 0.76 pmol were catalytically active. DET between Au and the enzyme was also studied in the reaction of the bioelectrocatalytic reduction of H₂O₂ by cyclic voltammetry and amperometric detection of H₂O₂ at +50 mV with rTOP-modified Au electrodes placed in a wall-jet flow-through electrochemical cell. Maximal bioelectrocatalytic current response of the rTOP-modified gold electrodes to H₂O₂ was observed at pH 5.0 and stemmed from its bioelectrocatalytic reduction based on DET between Au and the active site of rTOP. Kinetic analysis of the DET reactions gave 52% of the adsorbed rTOP molecules active in DET reactions (0.4 pmol of adsorbed catalytically active rTOP, correspondingly), which correlated well with the non-catalytic-voltammetry data. DET was characterised by a heterogeneous ET rate constant of 13.2 s⁻¹, if one takes into account the QCM data, and 19.6 s⁻¹, if the amount of rTOP estimated from the data on DET transformation of Fe^3+/2+ couple of rTOP is considered. The sensitivity for H₂O₂ obtained for the rTOP-modified Au electrodes was 0.7 ± 0.1 A M⁻¹ cm⁻². These are the first ever-reported data on DET reactions of anionic plant peroxidases on bare gold electrodes.     

GC/MS法分析油松节挥发油化学成分

用气相色谱-质谱法对山东昆嵛山产油松节挥发油进行化学成分的分析。采用水蒸气蒸馏法从油松节中提取挥发油。采用不同类型的毛细管柱进行分析，找出最佳分析条件，用归一化法测定其含量，并用气相色谱-质谱法对化学成分进行鉴定。共鉴定了48个成分，占挥发油总成分的84％以上。结果表明，此方法稳定可靠，重现性好，适用于中药挥发油的化学成分分析。     

Methods for research on immune complement activation on modified sensor surfaces

We have developed a methodological system consisting of a new surface sensitive quartz crystal microbalance with dissipation monitoring (QCM-D) sensor surfaces together with different surface modification methods for the investigation of surface associated complement activation in human sera. The QCM-D surface, 10 mm in diameter, was modified by spin-coating of poly(urethane urea) (PUUR) and polystyrene (PS). Some sensor surfaces were also sputtered with titanium (Ti) or modified by hydrophobic self-assembled monolayer (SAM) of an 18-carbon alkane thiol with a ---CH₃ end group. The amount of surface deposited complement protein was investigated by incubation of the modified sensor surfaces in human sera, followed by incubation with antibodies directed against complement factor 3c (C3c). The amounts of bound anti-C3c were then used as an arbitrary measure of surface induced complement activation. The order of complement activation of the different surfaces, as judged by three separate measurements per surface modification, was PUUR>PS=SAM>Ti. The Ti surface had a similar low degree of anti-C3c binding as the negative controls (heat inactivated sera). The novel QCM-D methodology was found to be very simple, accurate, sensitive and well suited as a screening method for complement activation and protein adsorption on different materials. We also compared the sensitivity of QCM-D method with surface plasmon resonance (SPR) for the quantification of protein adsorption and complement activation on gold sensor surfaces. The QCM-D method was equally sensitive as the SPR for the detection of protein adsorption from a solution independently if low flow rate (5 μl/min) was used. A slight increase in sensitivity was found at higher flow rate (30 μl/min). However, we found it difficult to use the SPR method on the Ti, PS and PUUR surfaces due to decreased light penetration of the modified SPR sensor chip.     

Influence of the variable wall thickness of the sample tubes and a quartz Dewar on the EPR signal intensity in a single TE102 and double TE104 rectangular cavity

The response of a single TE₁₀₂ and double TE₁₀₄ rectangular cavity to the insertion of samples contained in tubes with variable wall thickness and a quartz Dewar into the cavity has been analyzed. A direct, indirect, and concurrent (positive or negative) “lens effect” inside the double TE₁₀₄ rectangular cavity is discussed. The experimental dependence of the EPR signal intensity on the wall thickness of the sample tube, δ, for the line-like samples with identical length of the sample material column, L=30 mm, recorded in the microwave cavity showed a directly proportional increase of the relative “lens effect” with the increase of the wall thickness of the tube in the interval, δ∈<0.1 mm, >0.5 mm. The insertion of the variable-temperature double-wall quartz Dewar (home-built, resonant frequency shift, ca. −300 MHz) into the single TE₁₀₂ rectangular cavity showed the same relative “lens effect”, with ca. 1.5-time increase of the EPR signal intensity, for a point-like sample and the line-like samples with material columns of diameter of 1 and 1.3 mm, and wall thickness of the sample tubes, δ∈<0.1 mm, >0.5 mm. The increased effect of the Dewar arises because the active volume of the quartz Dewar tube walls is always much more larger than the active volume of the sample tube wall. In the case of the double TE₁₀₄ rectangular cavity, the insertion of the quartz Dewar: (i) into the same cavity, in which the sample is present, caused a direct “lens effect”, with ca. 1.8-fold increase of the EPR signal intensity; however, (ii) into the complementary cavity, in which the sample is absent, caused an indirect “lens effect”, with ca. 0.6-fold decrease of the EPR signal intensity. With the Dewar and sample in one cavity and a large empty sample tube in the complementary cavity, a concurrent (positive or negative) “lens effect” can be observed. Thus, the possible increase/decrease of the EPR signal intensity depends on the volume ratio of the quartz Dewar tube walls and large sample tube wall inserted into the double TE₁₀₄ rectangular cavity. Each of the above phenomena may be a significant source error in quantitative EPR spectrometry unless the samples to be compared in the quantitative EPR analysis are contained in sample tubes having the same wall thickness and each EPR spectra should be recorded inside an identical quartz Dewar.