A molecular fluorophore in citric acid/ethylenediamine carbon dots identified and quantified by multinuclear solid-state nuclear magnetic resonance

The composition of fluorescent polymer nanoparticles, commonly referred to as carbon dots, synthesized by microwave-assisted reaction of citric acid and ethylenediamine was investigated by ¹³C, ¹³C{¹H}, ¹H─¹³C, ¹³C{¹⁴N}, and ¹⁵N solid-state nuclear magnetic resonance (NMR) experiments. ¹³C NMR with spectral editing provided no evidence for significant condensed aromatic or diamondoid carbon phases. ¹⁵N NMR showed that the nanoparticle matrix has been polymerized by amide and some imide formation. Five small, resolved ¹³C NMR peaks, including an unusual ═CH signal at 84 ppm (¹H chemical shift of 5.8 ppm) and ═CN₂ at 155 ppm, and two distinctive ¹⁵N NMR resonances near 80 and 160 ppm proved the presence of 5-oxo-1,2,3,5-tetrahydroimidazo[1,2-a]pyridine-7-carboxylic acid (IPCA) or its derivatives. This molecular fluorophore with conjugated double bonds, formed by a double cyclization reaction of citric acid and ethylenediamine as first shown by Y. Song, B. Yang, and coworkers in 2015, accounts for the fluorescence of the carbon dots. Cross-peaks in a ¹H─¹³C HETCOR spectrum with brief ¹H spin diffusion proved that IPCA is finely dispersed in the polyamide matrix. From quantitative ¹³C and ¹⁵N NMR spectra, a high concentration (18 ± 2 wt%) of IPCA in the carbon dots was determined. A pronounced gradient in ¹³C chemical-shift perturbations and peak widths, with the broadest lines near the COO group of IPCA, indicated at least partial transformation of the carboxylic acid of IPCA by amide or ester formation.     

催化动力学光度法测定水中痕量铁

本文研究了ｐｈ５．０的ＨＡｃ－ＮａＡｃ介质中，痕量铁催化过氧化氢氧化紫脲酸的褪色反应，建立了催化动力学光度法测定痕量铁的新方法，方法的线性范围０－０．４０，０．４０－２．０μｇ／２５ｍＬ，检出限为８×１０＾－１１ｇ／ｍＬ，用于水样中痕量铁的测定，结果满意。     

[Na(18-C-6)]2[Cu(i-mnt)2]的合成与结构分析

研究了18-冠-6与Na2[Cu(i-mnt)2][i-mnt=异丁二腈烯二硫醇阴离子,S2CC(CN)2-2]的反应,得到的配合物[Na(18-C-6)]2[Cu(i-mnt)2](1)通过元素分析、红外光谱、X射线单晶衍射进行了结构分析.配合物为单斜晶系,空间群P2(1)/c.晶体学结构数据a=1.2819(11),b=1.1793(10),c=1.4928(13)nm,β=99.121(16)°,V=2.228(3)nm3,Z=2,Dcaled.=1.369g/cm3,F(000)=958,R1=0.0521,wR2=0.1003.1中的[Cu(i-mnt)2]基团通过配体i-mnt的氮原子与两个[Na(18-C-6)]基团中的钠原子成键,形成稳定的中性配合物.     

混合位级正交试验设计的极差分析方法

本文指出，在混合位级的正交试验设计中，以往的极差分析方法存在着不足。本文给出了极差的修正方法，并用大量实例做了数值验证，说明这个修正确实很有效     

羰基镍分析报警仪

羰基镍分析报警仪运用化学发光原理构成，不仅适用于羰基镍生产车间现场的检测和报警，也适于实验室的研究工作。检出限达0.037mg/m^3(0.5ppb），响应时间2min。     

On practical metrology and chemical analysis: etalons and traceability systems

 National measurement systems are infrastructures to ensure, for each nation, a consistent and internationally recognised basis for measurement. Such complex systems have historical, technical, legal, organisational and institutional aspects to connect scientific metrology with practical measurements. Underlying any valid measurement is a chain of comparisons linking the measurement to an accepted standard. The ways the links are forged and the etalons (measurement standards) to which they connect are defining characteristics of all measurement systems. This is often referred to as traceability which aims at basing measurements in common measurement units – a key issue for the integration of quantitative chemical analysis with the evolving physical and engineering measurement systems. Adequate traceability and metrological control make possible new technical capabilities and new levels of quality assurance and confidence by users in the accuracy and integrity of quantitative analytical results. Traceability for chemical measurements is difficult to achieve and harder to demonstrate. The supply of appropriate etalons is critical to the development of metrology systems for chemical analysis. An approach is suggested that involves the development of networks of specialised reference laboratories able to make matrix-independent reference measurements on submitted samples, which may then be used as reference materials by an originating laboratory using its practical measurement procedures. Received: 31 July 1995 Accepted: 19 August 1995     

光泽精化学发光体系的研究与应用

对光泽精化学发光体系的动力学性质、荧光光谱、化学发光光谱及化学发光机理进行研究和探讨。详细研究了光泽精 - H2 O2 - Co( )流动注射化学发光体系的最佳分析条件。结果表明 ,当光泽精 (L c)为 2 .5×10 - 5mol/L、H2 O2 为 0 .5 mol/L、Na OH为 0 .4 mol/L、CTMAB为 2 .0× 10 - 5mol/L时 ,测定 Co( )的校准曲线线性范围为 0 .0 5— 2 0 0μg/m L ,检出限为 0 .0 1μg/m L。对 10μg/m L Co( )连续测定 7次 ,相对标准偏差为 1.7%。     

脂松香、石炭酸松香树脂和马林酸松香树脂的红外光谱剖析及鉴别

本文对脂松香、石炭酸松香树脂和马林酸松香树脂的红外光谱剖析及鉴别，方法快速，简便，准确。     

拟因子试验设计在生产中的应用

根据生产实际,综合利用并列、赋闲列和拟水平试验设计,运用多重比较进行方差分析,寻找水泥熟料的最佳工艺.不仅解决了不同水平多因素试验问题,同时还可考虑交互作用,大大减少了试验次数,从而提高经济效益.