Geometric visualization of the Brewster angle from dielectric-magnetic interface

A geometric visualization is presented for the Brewster angle for a plane wave reflecting from an interface. The surface is assumed to be isotropic but it is allowed to display both dielectric and magnetic susceptibility, and hence the Brewster (polarizing) angle can attain any value between 0 and 90^°, and can exist for both parallel and perpendicular polarizations. The geometric construction (a tetrahedron) is spanned by the basic material parameters of the surface. The Brewster angle appears in one of the faces of the tetrahedron.     

ω-meson photoproduction on nucleons in the near-threshold region

The European Physical Journal A - The ω-meson photoproduction, γ + p→p + ω, is studied in the framework of a model, containing π-meson exchange in t-channel and...     

Combined effect of PMD and PDL on four-wave-mixing-induced crosstalk in WDM system

We derive an explicit autocorrelation function (ACF) formula of state of polarization for a fiber transmission system with polarization mode dispersion (PMD) and polarization dependent loss (PDL), which is found to agree well with Monte Carlo simulation. Then we use the new ACF to investigate the combined effect of PMD and PDL on the polarization multiplexed scheme. We find the performance of the polarization multiplexed scheme can be deteriorated more severely than the case without PDL.     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Temperature measurements using fiber optic polarization interferometer

A novel measurement method of temperature based on the phenomena that the phase difference between principle polarization states in the optical retarder is function of temperature is described. The polarization state of optical beam is changed as it passes through the optical retarder, which depends on the temperature. The temperature of optical retarder is determined by comparison of the power difference between principal polarization states. We demonstrate successfully the temperature measurement by using a polarization maintaining fiber as the optical retarder. With a 100 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.236 rad/°C and the measurement error was ±0.038°C over the temperature range of −2.6 – +3.4°C. With a 11.5 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.021 rad/°C and the measurement error was ±0.79°C over the temperature range of −8.5 – +86.5°C.     

Polarization modification of PZT thin films by means of electric fields and stress in scanning force microscopy

Polarization switching in scanning force microscopy (SFM) is influenced by both electric fields and stress, whereby the latter can arise inherently from Maxwell stress. We discuss the influence of electric charges and of the polarization asymmetry on the switching behaviour. For single crystallites of PZT(53/47) thin films, the sectors for ferroelectric, ferroelastoelectric and ferroelastic switching are represented in a field-stress map. The influence of stress on the second harmonic of the SFM is also discussed.     

Hard collisions of spinning protons: Past,present and future

There will be a review of the history of polarized proton beams, and a discussion of the unexpected and still unexplained large transverse spin effects found in several high-energy proton-proton spin experiments at the ZGS, AGS and Fermilab. Next, there will be a discussion of present and possible future experiments on the violent elastic collisions of polarized protons at IHEP-Protvino's 70GeV U-70 accelerator in Russia and the new high-intensity 50GeV J-PARC facility being built at Tokai in Japan.     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

A linearized vector radiative transfer model for atmospheric trace gas retrieval

We present a plane parallel radiative transfer model for polarized light, that provides the intensity vector as well as the derivatives of the four Stokes parameters with respect to atmospheric trace gas profiles. These derivatives are essential for retrieval of height resolved trace gas information from satellite measurements of backscattered sunlight. The model uses the Gauss-Seidel iteration technique for solving the radiative transfer equation. For the first time, the forward-adjoint radiative perturbation theory is applied for the linearization of a radiative transfer model including polarization. The accuracy of the model is better than 0.025% for all four Stokes parameters and better than 0.03% for the derivatives.     

Polarization inscription in ferroelectric (111) PZT and (100) SBT films

Ferroelectric thin films form an equilibrium domain structure compatible with their respective crystallographic symmetry. In tetragonal (111) PZT, 90° domains prevail; in (pseudo-tetragonal) (100) SBT both 90° and 180° domains are present. The size of 90° domains has been measured for e.g., PZT as slabs of 15 nm width. Domain size is a result of stress minimization in the film during the paraelectric (PE) → ferroelectric (FE) transition. A precise and regular domain pattern for (111) PZT and (100) SBT films has been investigated in detail by TMSFM. Single domains can be addressed mechanically with the tip of an AFM. Such single domain switching corresponds to a data storage density of 200 Gbit/inch². Applications of ferroelectric and high- paraelectric materials for e.g., non-volatile data storage replacing DRAM devices or as sensors in infrared cameras are increasingly becoming popular.