Photonic crystal beam splitters

In this work, the beam splitter with two input ports and two output ports in two-dimensional photonic crystals is studied through the finite-difference time-domain method. The beam splitter consists of two orthogonally cross line defects. The diameter of the two diagonal air holes at the intersection of the two line defects was modified. The input light can be identically divided into the two output ports. The beam splitters can be applied in the photonic crystal Mach-Zehnder interferometers or photonic crystal optical switches.     

Imprint lithography of pyramidal photonic pillars using hydrazine etching

An inexpensive method to produce a pyramidal-type 2D photonic structures in the silicon substrate was proposed. The method is based on the combination of imprint lithography and wet Si1 0 0 etching in water solution of hydrazine, which etches 1 1 1 faces much more slowly than others. Thermally grown SiO₂ mask for the hydrazine etching was used, because single Al mask cannot be well bonded to the substrate and tends to peel during the etching. It was revealed that transmittance in the infrared spectrum region of the patterned silicon decreases by about five times compared with that of flat silicon substrate and this decrease is almost independent of the angle of the incident beam. In the infrared region, decrease of transmittance of the patterned samples is directly proportional to the wave number. The shape of formed pyramids has strong influence on the transmittance. Decrease of the transmittance is much more rapid and larger in the case of sharpless pillars.     

Decay distribution of spontaneous emission from atoms in one-dimensional photonic crystal

Spontaneous emission behavior from atoms (or molecules) in one-dimensional photonic crystal with a defect is investigated. Taken all the TE and TM modes into account, the normalized spontaneous emission rate of the atom is calculated as a function of the position of the atom in the crystal. Results for both nonabsorbing dielectric structure and absorbing dielectric structure are presented. With the increase of the thickness of the defect in which the atoms are embedded, the oscillations of the spontaneous emission rate versus the position of the atom become dense and the lifetime distribution becomes narrow and sharp. The PC effect may lead to the coexistence of both accelerated and inhibited decay processes.     

Laser nanosources based on planar photonic crystals as new platforms for nanophotonic devices

Two-dimensional photonic crystal lasers have been fabricated on III–V semiconductor slabs. Tuning of the spontaneous emission in micro and nanocavities has been achieved by accurate control of the slab thickness. Different structures, some of them of new application to photonic crystal lasers, have been fabricated like the Suzuki-phase or the coupled-cavity ring-like resonators. Laser emission has been obtained by pulsed optical pumping. Optical characterization of the lasing modes have been performed showing one or more laser peaks centred around 1.55 μm. Far field characterization of the emission pattern has been realized showing different patterns depending on the geometrical shape of the structures. These kinds of devices may be used as efficient nanolaser sources for optical communications or optical sensors.     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

聚苯乙烯乳胶球三维有序体的制备及其显微形貌表征

A three-dimensional (3D) ordered structure was achieved by self-organization of monodisperse polystyrene latex about 250nm in diameter after being ambient dried. The stacked morphology was investigated by scanning electron microscopy(SEM) observation. It is shown that the face-centered cubic(FCC) phase dominantly exists. This finding presents a potential template for preparing an inverse FCC structure as a photonic crystal of full band gap if the index contrast is higher than 2.8.     

Some exact solutions of generalized Zakharov system

In this paper, we seek exact solutions of generalized Zakharov system. We use extended trial equation method to obtain exact solutions of this system. Consequently, we obtain some exact solutions including soliton solutions, rational, Jacobi elliptic and hyperbolic function solutions of this system by using extended trial equation method.     

Successive approximation-like 4-bit full-optical analog-to-digital converter based on Kerr-like nonlinear photonic crystal ring resonators

Implementing of photonic sampling and quantizing analog-to-digital converters (ADCs) enable us to extract a single binary word from optical signals without need for extra electronic assisting parts. This would enormously increase the sampling and quantizing time as well as decreasing the consumed power. To this end, based on the concept of successive approximation method, a 4-bit full-optical ADC that operates using the intensity-dependent Kerr-like nonlinearity in a two dimensional photonic crystal (2DPhC) platform is proposed. The Silicon (Si) nanocrystal is chosen because of the suitable nonlinear material characteristic. An optical limiter is used for the clamping and quantization of each successive levels that represent the ADC bits. In the proposal, an energy efficient optical ADC circuit is implemented by controlling the system parameters such as ring-to-waveguide coupling coefficients, the ring’s nonlinear refractive index, and the ring’s length. The performance of the ADC structure is verified by the simulation using finite difference time domain (FDTD) method.     

基于CdSe/ZnS量子点薄膜结构的高双折射光子晶体光纤的色散与损耗控制

基于有限元法,设计了一种六边形排列含CdSe/ZnS量子点薄膜结构的高双折射光子晶体光纤,分析了具有不同厚度CdSe/ZnS量子点薄膜光子晶体光纤的色散及损耗特性.结果表明,含CdSe/ZnS量子点薄膜结构的光子晶体光纤在x和y方向均存在基模.当泵浦光波长逐渐增加时,具有相同厚度CdSe/ZnS量子点薄膜光子晶体光纤的双折射值逐渐增大,x和y方向总色散先增大后减小且存在两个零色散点,损耗逐渐增大并在可见光波段趋近于零;具有不同厚度CdSe/ZnS量子点薄膜光子晶体光纤随CdSe/ZnS量子点薄膜厚度的增加,在相同泵浦光波长处,双折射值逐渐减小,x和y方向总色散逐渐减小且两个零色散点逐渐靠近,损耗逐渐增大.通过沉积不同厚度CdSe/ZnS量子点薄膜和选择合适泵浦光波长,可有效控制光子晶体光纤的色散和损耗.     

双原子正方晶格光子晶体边界模式的光传输特性

利用平面波展开法,发现双原子正方晶格光子晶体中ΓM方向边界面存在着快慢两类边界模式,并且通过计算色散关系和电场分布研究了边界参量对这两类边界模式传输特性的影响.依据两种模式的色散关系,计算了群指数和群速度色散参量,结果表明边界参量的变化对第一类边界模式传输特性的影响较小,该模式的平均群指数始终维持在5.0左右;第二类边界模式与第一类模式明显不同,边界参量的变化能够有效地影响到这种模式的传输特性,该模式的最大平均群指数可达178左右.利用时域有限差分法记录了不同时刻电场强度在边界附近的分布及监测点处的电场幅度变化情况,结果表明,两类模式都能够被限制在边界附近并向前传播,时域有限差分法得到的群速度与平面波展开法的结果完全吻合.