空间光通信指令传输的抗干扰设计

设计一种用归零码及多重相关解调技术的传输方案，并给了所需的几种抗干扰单元电路，最后结合实验说明了此方案可提高不良环境下传输数据的置信率。     

Measurement of surface topography by RGB Shadow-Moiré with direct phase demodulation

In this paper we present the application of a direct demodulation method for the measurement of surface topography by means of Shadow-Moiré. In our set-up, we use three LEDs (with green, red and blue peak wavelengths) to illuminate the grating. Due to the different position of these light sources, a polychromatic Shadow-Moiré fringe pattern is produced, which can be described as the superposition of three monochromatic (red, green and blue) fringe patterns. Taking the image of this polychromatic fringe pattern with a RGB CCD camera, we get a monochromatic fringe pattern stored at each RGB channel of the CCD. The direct demodulation algorithm employed uses these fringe patterns to calculate the wrapped phase map. After unwrapping the phase map using a standard multi-grid technique, we implemented an automatic procedure to detect the area of interest of the phase map by removing low modulation zones and to calculate the absolute value of the phase. In this way it is possible to determine the topography of a surface with a single RGB snapshot maintaining a simple experimental set-up, which is an important feature, especially for the study of dynamic phenomena such as deformations. We present the experimental results obtained after measuring different objects with both smooth and rough surface textures.     

Analysis of a demodulation system for Fiber Bragg Grating sensors using two fixed filters

The analysis of a demodulation system for Fiber Bragg Grating sensors based on two fixed spectral filters has been carried out both theoretically and experimentally. Different system configurations were analyzed by modifying the spectral position of the filters as well as the optical power-level of the signal reaching the two photo-detectors. Measurements with integration times that varied from 0.01 to 1 s have been compared with the low-frequency limit predicted for long-term operation. Comparisons between simulated and experimental results show good agreement, and extrapolations indicate that it should be possible to achieve an operating spectrum range of the order of 7 nm, with uncertainties equivalent to less than 2 pm in measurements of the sensor peak position.     

强度解调型光纤光栅温度传感实验

光纤光栅在工程上应用广泛,但由于存在解调系统复杂、成本高,尤其是需要使用光纤光谱仪等波长解调仪器,使得光纤光栅很难走入本科教学的实验课堂.本文提出了一种基于窄线宽DFB激光器的强度解调方案,极大地简化了光纤光栅传感器的解调系统,完全满足较高分辨率和实时检测的系统要求.合理安排的温度传感实验可以非常直观地展示光纤光栅的线性传感性能,使得工程化的光纤光栅传感技术轻松走进本科教学课堂,具有极高的推广和应用潜力.     

新型高准确度光纤光栅压力传感系统

提出一种使用光纤双布喇格光栅测定压力的测量方法.在外界压力作用下,传感光纤布喇格光栅反射波长的漂移,被转变成在交变力策动下,发生弯曲的等强度悬臂梁调制扫描光栅反射光脉冲间隔的变化.实验结果表明,光纤布喇格光栅反射波长漂移的测量范围为0～3 nm,波长测量的不确定度为1 pm;压力传感器的量程为0～6 MPa时,压力的测量不确定度为0.005 Mpa.     

基于光频调节的干涉型光纤水听器相位补偿检测方法

提出了一种基于光源频率调节的干涉型光纤水听器主动相位补偿的信号检测方法。详细介绍了该方法的基本检测原理,对信号解调误差进行了理论分析与仿真。为了验证该方法的可行性,搭建了实验系统,并编写了实时的信号采集、处理程序,对某一干涉型光纤水听器的声压灵敏度进行了测试。在频带20 Hz-1.3 kHz上,平均声压灵敏度为-162.2 dB(0 dB=1 rad/μPa),波动小于±0.8 dB,与采用相位载波调制解调方法测量的结果基本吻合。实验结果证明该方法是有效的。由于传感部分不含有源器件,便于实现全光纤化,且解调算法简单、检测频带宽,该方法能被广泛应用到各种干涉型光纤传感器的信号检测当中。     

具有有源闭合腔的光纤光栅传感系统地址查询技术

基于熔融拉锥技术研制的3 dB宽带耦合器的光纤环形镜的工作原理,提出了一种新型的具有有源闭合腔装置的光纤光栅传感系统。在用作闭合共振腔端镜的环形镜中写入十个波分复用光纤光栅传感元,利用共振腔中接入的法布里-珀罗滤波器,通过控制电压对传感光栅的波长扫描,实现对传感地址的查询。用非平衡的迈克耳孙扫描干涉仪将传感光栅的波长漂移信息变为相移信息,实现传感信号的解调。系统传感灵敏度的实验值为1.5835°/10-6ε,与理论值(1.6662°/10-6ε)基本吻合。     

光纤微机电系统法布里-珀罗压力传感器的波分复用

提出了一种用阵列波导光栅复用光纤微机电系统法布里-珀罗压力传感器的方法,实现了法布里-珀罗压力传感器的准分布式测量。传感器基于法布里-珀罗腔干涉的原理,采用微机电系统技术加工制作,用双波长方法解调干涉信号,利用传感器对两个不同波长光的反射率的比值与压力的单值关系确定所施加压力的大小,用阵列波导光栅实现传感器复用。理论分析与实验验证了传感器解调和复用的基本原理。实验结果表明:在压力的线性测量范围(0~1.5 MPa)内,系统的灵敏度(相对反射率比值/压力)可达到0.02026 MPa-1,测量结果具有较好的线形性,相对反射率比值的标准偏差小于3×10-4。该系统可以补偿传感器光网中和波长无关的变动引起的误差,具有好的线性、灵敏度和精度,复用能力强且复用传感器间无串扰。     

静电陀螺仪MUM小角度读取的相关技术研究

讨论了同步解调法实现静电陀螺仪质量不平衡调制（MUM，Mass-Unbalanced Modulation）小角度读取的原理，分析了影响读取分辨率的各种因素，并对其实施方案中的相关技术进行了探讨。研究表明，尽管MUM读取方案非常适用于实心转子静电陀螺仪，但前提是将其小角度读取的分辨率提高到可与光电方法相比的水平（角秒级）。要实现这一目标，首先要保证转子和电极的机械特性达到一定要求；在此基础上，还要在支承系统的结构、转子位移测量电路设计等方面进行精心设计。     

Quadrature demodulation technique for self-mixing interferometry displacement sensor

A new, to the best of our knowledge, signal processing method based on quadrature demodulation technique is presented for laser diode self-mixing interferometry(LDSMI) displacement sensor. Phase modulation of the laser beam is obtained by an electro-optic modulator (EOM) in the external cavity. Detection of the target's displacement can be easily achieved by sampling the interference signal at those times which satisfied certain conditions. The major advantage of the technique is that it does not involve any complicated calculation and insensitive to the sampling error. Experimental results show that the proposed method can effectively improve the displacement measurement resolution of the laser diode self-mixing displacement sensor to a few nanometers.