Numerical study on thermal performance of TiO2, Fe3O4 and NiCr/engine oil in an inclined wavy pip

The essential intention of the existing article is to illustrate the effect of wall properties on flow and thermal behavior, through a sinusoidal inclined wavy pipe. To succeed this phenomena we assume a sinusoidal pipe consist of wavy surface, whose walls traveling down to its borders and located at an inclined position, moreover titanium dioxide (TiO₂), ferrosoferric oxide (Fe₃O₄) and nichrome (80% Ni and 20% Cr) are considered as nano-particles and unused engine oil is assumed as a base fluid. The arising mathematical equations for thermal and flow ratio with wall slip impact are solved by mathematica. Also, evaluate graphically the thermal and flow behavior of nanofluids for multi values of solid volume fractions (η), rigidity parameter (M₁), stiffness parameter (M₂), viscous damping parameter (M₃), Grashof number (G_r), slip parameter (β) and heat generation parameter (H) also discuss the streamlines for different values of solid volume fraction.     

介绍一个与材料相关的研究型综合化学实验——壳聚糖的制备与表征

在中国科学技术大学夏季学期的研究型实验课程"化学科研基础训练"中开设"壳聚糖的制备与表征"综合实验,以龙虾壳为原料,通过除蛋白、脱盐、脱色、脱乙酰等一系列反应,制备得到目标产物壳聚糖。运用红外光谱、核磁共振仪、黏度法、滴定等对产品的结构及性能进行表征。     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Morphologically controlled synthesis of 1-dimensional selenium dioxide and study of its application as catalyst for diesel fuel additive

In this research work, selenium dioxide (SeO₂) nanorods have been prepared by a solvothermal method in which a strong reducing agent (NaBH₄) was used to reduce precursor salt into SeO₂ nanorods. X-ray diffraction (XRD) technique was applied to observe the crystal structure which confirmed its tetragonal geometry. Moreover, morphology and particle size were studied by scanning electron microscopy (SEM). SEM fully described the 1-dimensional morphology of SeO₂ nanorods which then arranged themselves to create a 3-dimensional flower-like structure with an average particle size of 50 nm. Also, the catalytic activity of SeO₂ nanorods as diesel-additive was studied by defining different parameters such as fire and flash points, calorific value, cloud and pour points, specific gravity, and kinematic viscosity. Subsequently, SeO₂ nanorods proved to be an excellent diesel additive due to higher total heat content and lower value of kinematic viscosity which enhances the better performance of the diesel engine.     

研究性物理实验与大学生创新心理品质培养

文章提出了大学研究性物理实验与创新心理品质培养的主题,介绍了大学研究性物理实验的特点,论述了大学研究性物理实验对大学生创新心理品质的影响。     

对超重、失重演示实验的改进

对传统的超重、失重演示实验进行了改进,使弹簧秤的指针能静止在超重(或失重)的位置上,从而能准确地读出读数,提高演示效果.     

超细CaO粉炉内喷射脱硫的实验研究

本文对超细ＣａＯ粉炉内喷射脱硫进行了实验研究，分析了可能影响超细ＣａＯ粉炉内脱硫效率的多种因素，实验结果表明：使用预先锻烧生成的超细ＣａＯ粉在并不苛刻的反应条件下脱硫效果很好，颗粒大小、反应区温度、反应时间和Ｃａ／Ｓ比对炉内喷钙脱硫的效率有重要的影响．     

计算机辅助物理实验教学的几点思考

探讨了物理实验教学引入智能化仪器的必要性和意义，指出引入计算机辅助教学必须对传统的实验教学内容和方法重新设计，同时软件的设计应给学生留有接口的余地。     

自制金割效应物理摆的研究性实验

金割效应物理摆是将数学中的优选法与物理实验中的复摆结合起来并用计算机处理数据的自制教学仪器.把金割效应物理摆作为研究性实验进行开设,更有利于培养学生的开拓精神和创新能力.     

U型管内液柱振动的演示实验研究

根据实验结果，分析了影响U型管中液柱振动的各种因素，给出了获得好的演示效果的改进措施．