Monitoring the packet gap of real-time packet traffic

Real-time packet traffic is characterized by a strict deadline on the end-to-end time delay and an upper bound on the information loss. Due to the high correlation among consecutive packets, the individual packet loss does not well characterize the performance of real-time packet sessions. An additional measure of packet loss is necessary to adequately assess the quality of each real-time connection. The additional measure considered here is the average number of consecutively lost packets, also called the average packet gap. We derive a closed form for the average packet gap for the multiclassG/G/m/B queueing system in equilibrium and show that it only depends on the loss behavior of two consecutive packets. This result considerably simplifies the monitoring process of real-time packet traffic sessions. If the packet loss process is markovian, the consecutive packet loss has a geometric distribution.     

塞曼石墨炉原子吸收光谱法测定粉尘降尘中痕量锡

以KOH熔样,又以KOH作基体改进剂,研究了测定锡的灰化温度、原子化行为和消除干扰及试样前处理的方法,以KOH熔解的粉尘及降尘样液,特别适用于塞曼石墨炉的测定,背景可完全扣除。方法简便、快速、准确,灵敏度和精度高。相对标准偏差为4.0%,回收牢在96.4～110%范围内。     

Preparation and microwave absorption properties of electroless Co-Ni-P coated strontium ferrite powder

A new type of Co-Ni-P coated strontium ferrite nanocomposite was prepared with electroless plating enhanced by ultrasonic wave at room temperature. The plating process was studied carefully. The morphology, crystal structure and microwave absorption properties of the Co-Ni-P coated powder were studied with field emission scanning electron microscopy (FE-SEM), X-ray diffraction (XRD), energy dispersive analysis of X-rays (EDX) and vector network analyzer. The results show that the strontium ferrite powder was successfully coated with Co-Ni-P alloy and possesses excellent microwave absorption properties. The maximum microwave loss of the composite powder reaches −44.12 dB. The bandwidth with the loss above −10 dB exceeds 13.8 GHz.     

Azine bridged silver coordination polymers: Powder X-ray diffraction route to crystal structure determination of silver benzotriazole

In continuation of our interest in solid-state structures of silver complexes of photographic importance, the structure for silver benzotriazole (AgBZT), has now been obtained. The preferred method for solving crystal structures is via single-crystal X-ray diffraction (XRD). However, for some materials, growing single crystals of appropriate size and quality is often difficult or even impossible. AgBZT is an example of such a silver complex with poor solubility. The usual routes to preparing single crystals using recrystallization from a cooperating solvent resulted in polycrystalline powder samples. We propose a crystal structure for AgBZT, solved from synchrotron X-ray powder diffraction data, using a direct-space Monte Carlo simulated annealing approach. AgBZT crystals are monoclinic, (P2₁/c), with unit cell dimensions, a=14.8052(3) Å, b=3.7498(4) Å, c=12.3495(12) Å, and β=114.200(6)°. The AgBZT complex is constructed from all three of the Benzotriazole (BZT) nitrogens bonding to a separate silver atom. As a consequence of this bonding mode, the structure is a highly cross-linked, coordination polymer.     

Zur Synthese und Struktur von K3N

Synthesis and Structure of K₃N Two phases in the binary system K/N have been obtained via co‐deposition of potassium and nitrogen onto polished sapphire at 77 K and subsequent heating to room temperature. The powder diffraction pattern of one of these phases can be satisfactorily interpreted by assuming the composition K₃N, and the anti‐TiI₃ structure‐type, which is also adopted by Cs₃O. The resulting hexagonal lattice constants are: a = 779.8(2), c = 759.2(9) pm, Z = 2, P6₃/mcm. Comparison with possible structures of K₃N generated by computational methods and refined at Hartree‐Fock‐ and DFT level, reveals that the energetically most favoured structure has not formed (presumable Li₃P‐type), but instead one of those with very low density. In this respect, the findings for K₃N are analogous to the results on Na₃N. The thermal evolution of the deposited starting mixture has been investigated. Hexagonal K₃N transforms to another K/N phase at 233 K. Its XRD can be fully indexed resulting in an orthorhombic cell a = 1163, b = 596, c = 718 pm. Decomposition leaving elemental potassium as the only residue occurs at 263 K.     

Quantitative methods for nanopowders characterization

The size, shape and surface topology have a strong influence on powders properties, such as: mechanical, optical, catalytic, etc. In addition, when particles have a nanometer size, the dispersion of these features plays an important role.There are a number of techniques, which could be used in order to characterize powders in terms of particle size and shape. However, due to the scale of analysis, well beyond the wavelength of visible light, most of them cannot be applied for investigations of nanopowders.In this paper, transmission electron microscopy (TEM) image analysis and X-ray methods are presented as promising and complementary techniques. An example of their application to ZrO₂ nanopowder is shown. The advantages and limitations of each method are described.     

Markovian network processes: Congestion-dependent routing and processing

A Markovian network process describes the movement of discrete units among a set of nodes that process the units. There is considerable knowledge of such networks, often called queueing networks, in which the nodes operate independently and the routes of the units are independent. The focus of this study, in contrast, is on networks with dependent nodes and routings. Examples of dependencies are parallel processing across several nodes, blocking of transitions because of capacity constraints on nodes, alternate routing of units to avoid congestion, and accelerating or decelerating the processing rate at a node depending on downstream congestion. We introduce a general network process representing the numbers of units at the nodes and derive its equilibrium distribution. This distribution takes the form of a product of functions of vectors in which the arguments of the functions satisfy an interchangeability property. This new type of distribution may apply to other multi-variate processes as well. A basic idea in our approach is a linking of certain micro-level balance properties of the network routing to the processing rates at the nodes. The link is via routing-balance partitions of nodes that are inherent in any network. A byproduct of this approach is a general characterization of blocking of transitions without the restriction that the process is reversible, which had been a standard assumption. We also give necessary and sufficient conditions under which a unit moving in the network sees a time average for the unmoved units (called the MUSTA property). Finally, we discuss when certain flows between nodes in an open network are Poisson processes.This research was sponsored in part by Air Force Office of Scientific Research contract 84-0367.     

负载型纳米Ni催化剂用于对氯硝基苯选择加氢

以TiO2为载体,N iB为诱导剂,粉末化学镀法制备了负载型纳米N i催化剂.通过TEM、HRTEM、XRD和ICP技术对催化剂物性进行了表征.结果表明,碱性镀液可使载体表面均匀负载微晶结构纳米N i团簇,尺度为35nm左右.该负载型纳米N i在对氯硝基苯选择加氢反应中表现出很高催化加氢活性,并能有效抑制脱氯,达到了工业骨架镍水平.由酸性镀液得到的负载型非晶态纳米N i-P合金具有较弱的催化对氯硝基苯加氢活性.反应温度对反应时间和脱氯率有明显影响.     

Enzyme production and profile by Aspergillus niger during solid substrate fermentation using palm kernel cake as substrate

The oil palm sector is one of the major plantation industries in Malaysia. Palm kernel cake is a byproduct of extracted palm kernel oil. Mostly palm kernel cake is wasted or is mixed with other nutrients and used as animal feed, especially for ruminant animals. Recently, palm kernel cake has been identified as an important ingredient for the formulation of animal feed, and it is also exported especially to Europe, South Korea, and Japan. It can barely be consumed by nonruminant (monogastric) animals owing to the high percentages of hemicellulose and cellulose contents. Palm kernel cake must undergo suitable pretreatment in order to decrease the percentage of hemicellulose and cellulose. One of the methods employed in this study is fermentation with microorganisms, particularly fungi, to partially degrade the hemicellulose and cellulose content. This work focused on the production of enzymes by Aspergillus niger and profiling using palm kernel cake as carbon source.     

Surface Modification of Fine Particles with a SnO<Subscript>2</Subscript> Film by Using a Polyhedral-Barrel Sputtering System

Fine particles were modified with a thin film of SnO₂ by using a barrel sputtering system that is a dry process. The conditions for the preparation of SnO₂ were studied by reactive sputtering onto a glass plate substrate. The optimal conditions for the preparation of tetragonal SnO₂ were identified as 60% partial oxygen pressure and 1.0 Pa total gas pressure with the substrate at room temperature. Under the optimized conditions, the surfaces of Al flake particles were modified with a thin film of SnO₂. XRD and SEM/EDS analysis of the prepared samples showed that the Al particle surfaces were uniformly modified by a thin film of SnO₂ in all cases. The film thicknesses were 80, 130, and 180 nm at RF outputs of 195, 350, and 490 W. These measured thicknesses coincided with the values estimated from the interference colors of the samples.