Soliton interaction under the influence of higher-order effects

In this paper, we present exact N-soliton solution by employing simple, straightforward Darboux transformation based on the Lax pair for Hirota equation, a higher-order nonlinear Schrödinger (HNLS) equation. As examples, one- and two-soliton solutions in explicit forms are given and their properties are also analyzed. A bound solution without interaction will be theoretically predicted if one can adjust frequency shift for each soliton appropriately. Further, we obtain the approximate eigenvalues by employing two-soliton solution and discuss analytically the interaction between neighboring solitons under the influence of the higher-order effects. It is shown that the combined effects of the higher-order effects can restrain the interaction between neighboring solitons to some extent. The results are proved by directly solving HNLS equation numerically.     

用楔形柱面光纤微透镜耦合的1.3μm SOA组件

运用激光模式耦合理论分析了半导体光放大器(SOA)与单模通信光纤的连接损耗,并设计制作了楔形柱面光纤微透镜用来实现两者的模斑匹配,有效地降低了器件的光耦合损耗.本文介绍了楔形柱面光纤微透镜耦合的1.3 μm半导体光放大器(SOA)组件及其制作方法.该组件的最大增益不小于14 dB,其偏振灵敏度小于1 dB,增益波动不大于0.5 dB.     

空间光通信指令传输的抗干扰设计

设计一种用归零码及多重相关解调技术的传输方案，并给了所需的几种抗干扰单元电路，最后结合实验说明了此方案可提高不良环境下传输数据的置信率。     

Spatially resolved Raman spectroscopy evaluation of residual stresses in 3C-SiC layer deposited on Si substrates with different crystallographic orientations

Raman scattering studies were performed on hot-wall chemical vapor deposited (heteroepitaxial) silicon carbide (SiC) films grown on Si substrates with orientations of (1 0 0), (1 1 1), (1 1 0) and (2 1 1), respectively. Raman spectra suggested that good quality cubic SiC single crystals could be obtained on the Si substrate, independent of its crystallographic orientation. Average residual stresses in the epitaxially grown 3C-SiC films were measured with the laser waist focused on the epilayer surface. Tensile and compressive residual stresses were found to be stored within the SiC film and in the Si substrate, respectively. The residual stress exhibited a marked dependence on the orientation of the substrate. The measured stresses were comparable to the thermal stress deduced from elastic deformation theory, which demonstrates that the large lattice mismatch between cubic SiC and Si is effectively relieved by initial carbonization. The confocal configuration of the optical probe enabled a stress evaluation along the cross-section of the sample, which showed maximum tensile stress magnitude at the SiC/Si interface from the SiC side, decreasing away from the interface in varied rate for different crystallographic orientations. Defocusing experiments were used to precisely characterize the geometry of the laser probe in 3C-SiC single crystal. Based on this knowledge, a theoretical convolution of the in-depth stress distribution could be obtained, which showed a satisfactory agreement with stress values obtained by experiments performed on the 3C-SiC surface.     

求解通信网节点间全部路由的逻辑代数化算法

经典的D IJKSTRA和BELLM AN-F LOYD通信网络路由算法,只能根据特定网络参数得到最佳路由,却无法获得网络存在的全部可用路由,而通信网理论研究及网络管理等方面,往往需要获得节点之间的全部可用路由.研究出一种路由新算法,遵循逻辑代数运算规则、采用关联矩阵中行与行之间整合与删除方式计算,N个节点的网络只需N-1次整合及删除运算,就能得到源节点到任意节点两点之间全部路由结果.详细论证了算法的正确性与合理性,简介了算法的并行运算可行性及与经典路由算法的兼容性等问题.通过算例详细说明算法的计算过程,并验证其正确性.     

Study on structure change of carbon nanotubes depending on different reaction gases

Aligned carbon nanotubes were grown by plasma-enhanced hot filament chemical vapor deposition using different reaction gases and they were investigated by scanning electron microscopy and transmission electron microscopy. It is found that the hollow carbon nanotubes were formed using methane and hydrogen as the reaction gases, but the bamboo-structured carbon nanotubes were grown when ammonia was added into the reaction gases, indicating that the structure of the aligned carbon nanotubes was changed depending on different reaction gases. On setting of diffusion of carbon, the effects of the nitrogenous gas on the structure change of carbon nanotubes are studied.     

Low noise double pass L-band erbium-doped fiber amplifier

A new double pass long wavelength band erbium-doped fiber amplifier with enhanced noise figure characteristics is demonstrated. The noise figure is improved by about 2.6 dB with the incorporation of broadband conventional-band fiber Bragg grating (FBG) in between the two segments of erbium-doped fiber. By incorporating both the pre-amplifier and the FBG, the noise figure is further improved, which varies from 4.0 to 5.0 dB in the flat gain region from 1570 to 1600 nm. The gain varies from 32.0 to 33.4 dB within this region. The new amplifier with high gain and low noise figure can be useful as an inline amplifier in a wavelength division multiplexing transmission system.     

Constructing Space for Science at the Royal Institution of Great Britain

Those who have worked in the Royal Institution of Great Britain have, since its foundation in 1799, made significant contributions to scientific knowledge, to its practical application, and to its communication to a wide variety of audiences. Such work cannot be carried out in an architectural vacuum, and in this paper we examine how the buildings of the Royal Institution, 20 and 21 Albemarle Street in central London, have shaped the work undertaken within its walls and how, on a number of occasions, the buildings have been reconfigured to take account of the evolving needs of scientific research and communication. This paper is based on the Conservation Plan of the Royal Institution that we wrote during 2003. The Conservation Plan did not examine the land owned by the Royal Institution to the north (i.e., 22 and 23 Albemarle Street; for this area see Richard Garnier, “Grafton Street, Mayfair,” Georgian Group Journal 13 (2003), 210–272), but it did discuss 18 and 19 Albemarle Street. In this paper we concentrate on the core Royal Institution buildings at 20 and 21 Albemarle Street. Other studies of the relationship of architecture,space, and science include Crosbie Smith and Jon Agar, ed., Making Space for Science: Territorial Themes in the Shaping of Knowledge (Basingstoke: Macmillan, 1997); Peter Galison and Emily Thompson, ed., The Architecture of Science (Cambridge, Mass.: MIT Press, 1999); and Sophie Forgan,“The architecture of science and the idea of a university,” Studies in History and Philosophy of Science 20 (1989), 405–434. Frank A.J.L. James is Professor of the History of Science at the Royal Institution; he has written widely on the history of nineteenth-century science in its social and cultural contexts and is editor of the Correspondence of Michael Faraday. He is President of the British Society for the History of Science. Anthony Peers is an Associate of Rodney Melville and Partners where he works in the field of building conservation as an architectural historian. He is a Council member of the Ancient Monument Society.     

Photoemission studies of oxygen adsorbed on a LiAl(1 1 0) alloy surface: Role of Li segregation

We investigated that the effect of the number of segregated Li atoms on the rate of oxidation on a LiAl alloy surface. Oxygen molecules adsorbed on the LiAl alloy react with the surface atoms to form stable oxides. The segregated Li atoms at reconstructed surfaces (c(2×2) and (2×1)) enhance the oxidation rate and form stable LiAlO_x and Li₂O. The degree of enhancement of oxidation by segregated Li atoms varies as a function of O₂ exposure and annealing temperature, where the latter is directly related to the mode of surface reconstruction by Li segregation.