交联聚异丁烯酸甲酯型负载树脂的孔结构与分离稀土性能的关系

本文报导异丁烯酸甲酯型负载树脂的交联度、致孔剂组成和含量对负载树脂孔结构的影响.结果指出,良溶剂和劣溶剂按一定比例混合作为致孔剂,可制备不同孔结构的树脂.致孔剂量增加,树脂表观比重减小,而比表面积、孔体积与平均孔径均增加.交联度从10％增加到35%,表观比重和比表面积增加,而孔体积与平均孔径减小.增加致孔剂所含良溶剂的比例,树脂的表观比重、比表面积增加,而孔体积与平均孔径减小.已制备一系列不同孔结构的2-乙己基膦酸单2-乙己基酯(P507)负载树脂,比较了它们分离La、Ce、Pr、Nd的性能.结果表明,适当孔结构的负载树脂用于萃取色层分离稀土元素具有优良的分离性能.     

Sorption kinetics for the removal of aldehydes from aqueous streams with extractant impregnated resins

The sorption kinetics for the removal aldehydes from aqueous solutions with Amberlite XAD-16 and MPP particles impregnated with Primene JM-T was investigated. A model, accounting for the simultaneous mass transfer and chemical reaction, is developed to describe the process. It is based on the analogy to the diffusion and reaction in a stagnant liquid sphere, but corrected for the porosity and particle properties influencing the diffusion. The developed model describes the kinetic behavior of the process in the low concentration region rather well. However, in the high concentration region, larger discrepancies are observed. Initially, the influence of the flow rate was investigated to eliminate the effect of the external mass transfer. The influence of the particle morphology was investigated for both physical and reactive sorption. Physical sorption experiments were used to determine the factor τ that takes the particle properties influencing the diffusion into account. It was shown that the diffusion is faster in XAD-16 than in MPP impregnated systems. Reaction rate constant k _x was determined by fitting the model to the experimental data. Sorption of benzaldehyde appears to be significantly slower (k _x ∼10⁻⁴ l/mol s) than the sorption of pentanal (k _x ∼10⁻³ l/mol s) due to the slower chemical reaction. The influence of the particle size was investigated for the sorption of pentanal with XAD-16. It was observed that the particle size does influence the diffusion term, but does not have an effect on the reaction rate. On the other hand, the extractant loading influences the reaction rate slightly in the low concentration region, whereas the initial concentration of the solute has more pronounced effect.     

红外分光光度法测定水体中石油类及萃取剂的选择

与重量法、紫外分光光度法、荧光分光光度法和非分散红外法相比,红外分光光度法具有灵敏度高、适用范围广和测定结果受标准油品及样品中油品组成影响较小的优点。在萃取剂的选择上,建议采用六氯四氟丁烷(S-316),它具有毒性小,萃取率高,准确度和精密度好等特点,完全可用作测定水与废水中石油类的提取剂。     

三烷基氧膦（TRPO）辐射稳定性研究：辐解损失率的测定

三烷基氧膦是用于高放废液处理的萃取剂,本文试验了在辐照剂量为１×１０＾４Ｇｙ－１×１０＾６Ｇｙ时ＴＲＰＯ损失率。结果表明,１００％（Ｖ／Ｖ）ＴＲＰＯ在λ辐照剂量１０＾４Ｇｙ－１０＾６Ｇｙ变化时,辐解损失率为１．２％－１．６％;３０％（Ｖ／Ｖ）ＴＲＰＯ－煤油在辐照剂量１０＾４Ｇｙ－１０＾５Ｇｙ时,辐解损失率基本不变（０．３３％－０．３４％）,而在１×１０＾６Ｇｙ时增加到０．７７％。均低于磷酸三丁酯的     

Influence of extractant on quality and trace elements content of peat humic acids

Among several extractants used to isolate humic acids (HA) from terrestrial environments, sodium hydroxide (NaOH) and sodium pyrophosphate (Na₄P₂O₇) are the most utilized. In order to evaluate the influence of these different extractant solutions on the HA quality and on their trace elements content, HA were isolated from five Sphagnum-peat samples using three different solutions: (a) 0.5 M NaOH; (b) 0.1 M Na₄P₂O₇; (c) 0.5 M NaOH + 0.1 M Na₄P₂O₇. The obtained HA have been analyzed with respect to ash content, elemental composition, main atomic ratios and characterized by FT-IR and total luminescence (TL) spectroscopies. In addition, both raw peat and HA have been analyzed using X-ray fluorescence in order to determine the Br, Cu, Fe, Ni, Pb and Zn contents.

Results showed that HA extracted with NaOH and NaOH + Na₄P₂O₇ are quite similar with respect to ash, elemental contents and spectroscopic characteristics, while Na₄P₂O₇ solution, which in general reduces the extraction yield, seems to affect the nature of HA, featuring a more complex and aromatic character. With respect to the contents in the corresponding raw peat samples, the HA fractions were richer in Br, Cu and Ni, regardless of the extractant used, and poorer in Fe, Pb and Zn. Further, Br, Cu, Ni and Zn were more concentrated in HA extracted with Na₄P₂O₇ than in those extracted with NaOH and NaOH + Na₄P₂O₇, probably because of the greater affinity of these elements for these more aromatic humic molecules.     

用于水中矿物油测定的新型萃取剂

探讨了用于水中矿物油测定的新型萃取剂的筛选和超纯新型萃取剂的制备方法,对选定的新型萃取剂与目前我国常用萃取剂的萃取能力进行了较详细的对比研究.     

皂化萃取剂的物理化学性质

测定了P507钾(钠)/仲辛醇/正庚烷体系在不同含水量时的密度、折光率、粘度和电导等性质,并从微乳液的形成、结构和相转变对实验结果进行了初步讨论.     

混合三烷基氧膦组成和性能的研究

用气相色谱和质谱法研究了7种不同产地的混合三烷基氧膦的组成，测试了其水洗液的pH值，在水和酸中的溶解率及温度与出现第二有机相的关系。这些数据对于该试剂用于溶剂萃取过程有参考价值。     

三烷基氧膦成分的气相色谱研究

三烷基氧膦（ＴＲＰＯ）用于做放射性废液和化学分离过程的萃取剂。本文用气相色谱技术研究和测量其组成。气相色谱条件为：ＦＦＡＰ毛细管色谱柱；Ｎ２载气，氢火焰原子化检测器，结果表明，不同厂家生产的ＴＲＰＯ其组成不同，其纯度也不同。     

叔铵盐—烷烃—醇—水四元体系的热力学函数与结构研究

叔铵类(R_3N)萃取剂萃取金属离子需在酸性介质中进行,与无机酸先形成铵盐(属阴离子表面活性剂类),然后与金属配阴离子进行阴离子交换反应。而将R_3N制成无机酸盐,作为表面活性剂以微乳液为模型对其进行热力学函数与结构研究尚未见报道。 本文制备了TOA·HCl、N235·HCl、N235·HNO_3与N235·HClO_44种叔铵无机酸盐,测定了叔铵盐的界面化学性质。以w/o型微乳液的球形颗粒结构为模型,用稀释法测定了叔铵盐(TOA·HCl,N235·HCl,N235·HNO_3,N235·HClO_4)-烷烃-醇-水四元均相透明体系的结构参数;并用不同醇时,醇由油相(o)转移至界面层(i)的标准自由能变(?)结果表明其结构“颗粒”半径小于0.5nm,表面活性剂叔铵盐的平均聚集数小于0.05,应属醇的反向胶团。 1 实验 1.1 试剂 三正辛胺(TOA,德国);N235(R_3N,R=C_5—C_(10),大连油脂化学厂)。叔铵盐TOA·HCl分别用干法(D)与湿法(W)制备。向TOA中通入干燥HCl气体至饱和,再加入分析量的TOA中和过量的HCl,制得TOA·HCl(D).TOA与过量10mol/L盐酸振荡平衡,再加入分析量的TOA中和过量酸制得TOA·HCl(W),样品均为淡黄色蜡状固体,N235·HCl、N235·HNO_3、N235·HClO_4均用湿法制备。其它试剂均为A.R.级,未进一步处理,水为二次蒸馏水。