Luminescence investigations of the GaP-based dilute nitride Ga(NAsP) material system

Multi-quantum well heterostructures (MQWHs) of the novel Ga(NAsP)/GaP material system have been grown, pseudomorphically strained to GaP-substrate. The crystalline perfection is verified by transmission electron microscopy (TEM). For As-concentrations in excess of about 70%, a direct band structure and adequate luminescence efficiency for laser device application is observed. Temperature-dependent photoluminescence (PL) investigations show the influence of carrier localisation and non-radiative recombination processes typical for dilute nitride materials. With rising N content in the active material, the emission wavelength shifts towards longer wavelength, leading to Ga(NAs)/GaP MQW structures with photon energies below the indirect band gap of silicon (Si). At the same time the luminescence intensity drops due to an increase in non-radiative carrier traps and/or structural degradation.     

Logarithmic corrections for dilute uniaxial ferromagnets at the critical dimension

The leading logarithmic corrections to the critical behavior of a dilute uniaxial (Ising) ferromagnet in the disordered phase are derived using renormalization group methods. The values of the exponents in the logarithmic terms differ from those given by previous authors.     

A tentative approach to the direct simulation of drag reduction by polymers

An efficient technique for drag reduction uses dilute solutions of a few p.p.m. of polymers. A possible reduction in drag of up to 80% is achieved. Several experimental observations have been made which tend to indicate that the polymers modify the turbulence structures within the buffer layer. Flow visualisations have shown that the changes consist of a weakening of the strength of the streamwise vortices. Existing literature reveals no attempts of numerical simulation of this phenomenon. In this paper an approach is pursued by using a constitutive equation which relates the elongation viscosity to the local properties of the flow. According to this model this viscosity is large in zones where the amount of strain rate is greater than the amount of vorticity, and is zero when the vorticity exceeds the strain rate. Simulations have been performed in a “minimal channel” to give good resolution with a limited number of grid points. The accuracy of the method is tested by comparison with the results of other techniques. For simulations with polymers, quantitative comparisons cannot be made, but the results reproduce the qualitative outputs of the experiments. The mean streamwise velocity is modified in the buffer layer; the peak of the streamwise turbulent intensity, in wall units, increases and its maximum moves far from the wall; and the vertical turbulent intensity is largely reduced in the wall region. An interesting outcome from both the simulation and the experiments is that the strength of the longitudinal vortices is reduced when the polymers are present.     

粘度法预测聚乙二醇/壳聚糖体系的相容性

甲壳素在自然界的含量很大，仅次于纤维素，是一种颇具应用潜力的天然高分子．可由甲壳素经脱酸基化制得壳聚糖．由于其分子中存在氨基，因此能溶解干酸性水溶液中，并以聚电解质的形式存在，近来用壳聚糖制得的纤维膜应用于药物、食品等的分离和纯化、污水的处理，分离效果好，且不带入任何化学杂质．在壳聚糖纤维膜制作及与纤维的混纺过程中，都要探讨它与其它相应高聚物的相容性[1]．我们以相容的壳聚糖（chitosan）／聚乙二醇（PEG）体系为例，采用粘度法讨论其分子间的相互作用，并预测它们的相容性．壳聚糖的基本结构为1实验部分1.1…     

刚性聚合物稀溶液流变性质的计算 Ⅱ.非定常流动

本文继续前一篇文章讨论描述刚性聚合物稀溶液流变性质的多棒刚杆分子模型,计算了应力发展的非定常剪切流动,结果表明,η~+将有所希望的“过冲”现象,且在无因次时间常数τ≥5后,流变性质达到定常均匀剪切流的结果,同时亦可方便地导得多球刚杆分子模型和无水学相互作用的刚性哑铃模型的结果。这些结果表明,此模型是较为完善的描述刚性聚合物稀溶液的分子模型。本文还对W_e≤0.7的情况作了深入的分析,比较了各阶近似解的计算结果。表明在W_e≤0.7时,用二阶近似解可代替高阶近似解计算,不会造成很大的误差,但可大大缩短计算时间。     

DIPOLE POLARIZATION RELAXATION AND MOLECULAR STRUCTURE OF MAIN-AND SIDE-CHAIN LIQUID-CRYSTALLINE POLYMERS

Molecular mobility in thermotropic polyesters and side-chain polymers with different struc-ture of mesogens and spacers has been studied by dielectrical method in dilutesolutions. The results made it possible to establish the multiplicity of dielectric relaxationtransitions which reflects the small- and large-scale types of molecular motion. It was shownthat dielectric relaxation processes occurring in accordance with local mechanism (relaxationtimes 10~(-9)--10~(-7)s. and the activation energy 10--50kJ/mol) are due to the mobility of kineticchain elements of different length within a monomer units. It was found that the dielectricrelaxation process connected with a large-scale form of molecular motion (relaxation times10~(-5)--10~(-6)s. and the activation energy 100kJ/mol) did not depend on the molecular massbut was infiuenced by factors changing the conformational state of the macromolecule. It isestablished tha the cooperative reorientation mobility of associated mesogenic fragments isthe source of the large-scale process.     

平菇多糖稀溶液行为的研究

平菇多糖属生物高分子, 文章对平菇多糖稀溶液性质进行了研究。实验系采用Elias浊点滴定法测定平菇多糖溶液的θ组成, 用快速动态膜渗透计和粘度法测定平菇多糖的数均分子量、维利系数与分子链的构型参数。探讨其在θ条件下的分子形态及用Tung函数法等处理分级数据, 从而获得平菇多糖的分子量分布。     

A microwave-assisted sequential extraction of water and dilute acid soluble arsenic species from marine plant and animal tissues

This paper describes the use of dilute nitric acid for the extraction and quantification of arsenic species. A number of extractants (e.g. water, 1.5 M orthophosphoric acid, methanol-water and dilute nitric acid) were tested for the extraction of arsenic from marine biological samples, such as plants that have proved difficult to quantitatively extract. Dilute 2% (v/v) nitric acid was found to give the highest recoveries of arsenic overall and was chosen for further optimisation. The optimal extraction conditions for arsenic were 2% (v/v) HNO₃, 6 min⁻¹, 90 °C. Arsenic species were found to be stable under the optimised conditions with the exception of the arsenoriboses which degraded to a product eluting at the same retention time as glycerol arsenoribose. Good agreement was found between the 2% (v/v) HNO₃ extraction and the methanol-water extraction for the certified reference material DORM-2 (AB 17.1 and 16.2 μg g⁻¹, respectively, and TETRA 0.27 and 0.25 μg g⁻¹, respectively), which were in close agreement with the certified concentrations of AB 16.4 ± 1.1 μg g⁻¹ and TETRA 0.248 ± 0.054 μg g⁻¹.To preserve the integrity of arsenic species, a sequential extraction technique was developed where the previously methanol-water extracted pellet was further extracted with 2% (v/v) HNO₃ under the optimised conditions. Increases in arsenic recoveries between 13% and 36% were found and speciation of this faction revealed that only inorganic and simple methylated species were extracted.