一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

可调谐液晶法-珀滤光片的研究

提出了一种可用于密集波分复用系统中的新型可调谐滤光片的设计方法,该设计利用了液晶的双折射现象,以及液晶盒内法-珀效应,从理论上分析了器件的光谱特性,计算了液晶分子的折射率调制和其分子转动角度的关系.并对器件进行了性能测试.实验结果与理论吻合较好.     

光互联网的抗毁性设计研究

由于互联网层叠模型中多层都存在重复的保护与恢复机制，致使互联网的实现极其复杂，造成网络传输效率较低，而且拥塞。随着密集波分复用（DWDM）的广泛使用和网络底层性能的大幅度提高，已经不需要再对网络中多层进行重复保护与恢复。在此基础上，采用了未来光互联网3层 (应用层、IP层和光互联层) 协议模型，并对其中的光互联层的保护进行了深入的研究，提出了部分共享备用路径保护(P-SPP)方法。此模型能充分利用IP层电子的灵活恢复机制与光互联层的快速保护与恢复机制，提高光互联网的传输性能，以适应目前高速发展的互联网对传输带宽的要求。     

在线滤波技术在光纤马赫-德尔交叉复用器中的应用

为构造出与理想梯形滤波器接近的滤波形状，在单级光纤马赫-德尔交叉复用器的基础上，引入在线滤波技术；通过增加干涉级数和调整2对干涉臂的干涉长度和耦合器的耦合比，实现了逼近宽带陡沿的滤波输出。通过与梯形滤波器傅里叶展开式的比较，计算得到了器件的最佳参数，器件的滤波性能以及温度稳定性相对于单级结构得到了明显提高。根据理论计算，成功制作出通道间隔为50GHz的样品器件。其输出为-0.5dB，带宽大于0.185nm，相邻通道隔离度大于30dB，满足了DWDM系统指标要求。     

Low power Electro-optical filter: Constructed using silicon nanobeam resonator and PIN junction

In this paper, a high tunable Electro-optical filter is designed and simulated with low electric power consumption. A silicon nanobeam resonator based on one-dimensional photonic crystal in the form of Fabry–Perot structure, silicon-on-insulator waveguide, is proposed with a PIN junction. In designing nanobeam resonator, “deterministic design method” is used to achieve the high quality factor and high-transmission rate. Tuning of the resonant wavelength in the output channel of the filter is achieved by manipulating the refractive index of the active area by using the free-carrier dispersion effect. The output wavelengths of designed device can be tuned for the telecom-friendly 1.55 µm range. The device shows a wavelength shift higher than 3 nm for a power consumption of only 0.9 mW. Finally, the simulation results show that the provided device can be considered as a narrowband and tunable Electro-optical filter that is suitable for DWDM communication system.     

体相位全息光栅式波分复用器的研究

利用体相位全息光栅的优良特性,研制光栅式密集型波分复用器(DWDM)。准直后的信道波长通过体相位全息光栅两次衍射,在焦面上实现信道波长的分复用。阐述了体相位全息光栅的独特结构特点,给出了体相位全息光栅式密集型光波分复用器件的原理图,计算出各个信道的位置及间隔,用Zemax仿真出设计模型。相比于薄膜滤光片式器件而言,具有许多独特的优良特性,能够实现更密集更多信道数量的分复用。     

Advanced Optical Network

The following article describes an advanced dense wavelength division multiplexing (DWDM) Optical Network developed by L-3 Photonics. The network, configured as an amplified optical bus, carries traffic simultaneously in both directions, using multiple wavelengths. As a result, data distribution is of the form peer-to-multi-peer, it is protocol independent, and it is scalable. The network leverages the rapid growth in commercial optical technologies, including wavelength division multiplexing (WDM), and when applied to military and commercial platforms such as aircraft, ships, unmanned and other vehicles, provides a cost-effective, low-weight, high-speed, and high noise-immune data distribution system.     

一种新型密集波分复用滤波器的调谐特性分析

研究了一种新型模拟双折射结构DWDM滤波器的中心频率和带宽的可调谐特性.研究表明：当给定满足一定平坦化要求的光谱透射率所需的各模拟波片中偏振旋转器的旋转角时,通过模拟波片中楔形介质对的相对位移来调节光在各模拟波片中的光程差,同时保持光程差仍满足特定的比例关系,可实现中心频率及带宽的调谐.当光在各模拟波片中的光程差变化较小时,可实现中心频率的调谐,此时带宽的改变很小,可忽略不计；随着光程差变化的不断增大,带宽的改变则不能忽略.     

Cost-Effective Migration from Sub-Lambda to Wavelength-Based Metro Networks

This article will discuss the importance of hybrid coexistence of sub-lambda grooming with wavelength-based services for driving down costs and maximizing the use of metro bandwidth, as well as enabling next-generation lambda-based services. The article will also address migration to all optical metro networks.     

Investigation of optimum pulse shape for 112 Gbps DP-DQPSK in DWDM transmission

This paper reports the simulative analyses to investigate the impact of different pulse shapes on DP-DQPSK modulation for high-spectral efficient DWDM transmission at 112 Gbps per channel. In the simulation model we have considered three different pulse shapes viz. NRZ, 50% duty cycle RZ (RZ50) and 67% duty cycle RZ (RZ67) in symbol-aligned and symbol-interleaved format. The analysis has been carried out for various linear and nonlinear system impairments where the pulse is subjected to degradation under the influence of amplified spontaneous emission (ASE) noise, group velocity dispersion (GVD), cross-phase modulation (XPM) and polarization mode dispersion (PMD) and thus, limiting the system performance. Results show that the RZ50 pulse shape for DP-DQPSK with symbol interleaving shows the maximum tolerance for the various system degradations in long haul DWDM transmission. Even the system based on the NRZ pulse shape can gain significant improvement from the symbol-interleaving.