Preparation and properties of homogeneous V2O5-SiO2 xerogel composite based on interpenetrating polymer network

In this paper, we report the conducting and electrochemical properties of a homogeneous V₂O₅-SiO₂ xerogel composite obtained from the simultaneous polymerization in both inorganic components (Si-O and V-O based polymers) forming an interpenetrating polymer network, where a mutual “solubility” due to cross-links and entanglements was observed. The presence of V₂O₅ inside the silica matrix has a strong effect on electrical conductivity; measurements showed room temperature conductivity almost 1000 times higher than what is found in the literature. In addition, the electrochemical behavior is quite similar to that found in V₂O₅ xerogel. Moreover, the effects of thermal treatment on the conducting and electrochemical properties were investigated. It was found that both properties were improved with no significant effect on V₂O₅ xerogel layered structure.     

Optical and conductive properties of AlSi-alloy/SiCp composites: application in modelling CO2 laser processing of composites

The optical properties—reflectivity, real part of the refractive index, absorption coefficient as well as the thermal and electrical conductivity of AlSi-alloy/SiC_p composite were measured. The optical parameters and both conductivities decreased with the increase of SiC_p particles volume in AlSi-alloy matrix. This decrease was almost linear for the volume fraction of SiC_p particle up to 10 vol% of the total mass of the composite. For the 15 vol% of SiC_p particles, the departure from linearity is connected with the presence of additional phases in AlSi-alloy/SiC_p composite materials. The measured temperature dependencies of optical reflectivity and electrical conductivity for AlSi-alloy/SiC_p 15 vol% are of metallic character. Modelling of the interaction of the CO₂ laser radiation with AlSi-alloy/SiC_p 15 vol% composite should allow to estimate the initiation time at which the surface composite reaches melting temperature.     

聚（3—丁基噻吩）电导的热稳定性

研究了导电聚合物聚（３－丁基噻吩）（ＰＢＴ）在大气环境下的导电热稳定性。在室温至２２０℃范围内，测试电导率随时间及温度的变化。ＴＧＡ分析以及化学分析的结果表明：掺杂态的ＰＢＴ大约在１４０℃附近有一转化温度，低于或高于这一转化温度，电导率下降的决定因素各不相同。高于转化温度时，电导率下降的主要原因是反离子和高分子主链的解离，进而发生化学反应，影响了高分子主链的结构。ＸＰＳ测试结果表明：经热处理后的Ｐ     

Composition and spectral studies of polyaniline salts

Five different polyaniline salts have been prepared by chemical polymerization of aniline in aqueous solution of different acids. The polyaniline base was obtained from the corresponding polyaniline salt by dedoping using aqueous ammonium hydroxide solution. Electron paramagnetic, electronic absorption, infrared spectral and conductivity measurements have been performed on the polyaniline salts and polyaniline bases. This composition and the extent of dopant in polyaniline salt systems have been determined. There is no definite correlation between the conductivity and the stoichiometric ratio between the polyaniline base and the acid, and also the spin concentration.     

New integrated measurement protocol using capillary electrophoresis instrumentation for the determination of viscosity, conductivity and absorbance of ionic liquid-molecular solvent mixtures

The low vapor pressure and the versatility of the physico-chemical properties of ionic liquids make them really attractive as an alternative for conventional molecular solvents. The knowledge of their physico-chemical properties (viscosity, conductivity, miscibility with organic solvents and anion-cation interactions) has appeared mandatory for better targeting their applications, although it is generally still lacking or incomplete.This work promotes capillary electrophoresis instrumentation as an integrated apparatus for measurement of viscosity, conductivity and absorbance of pure ionic liquids and ionic liquid-molecular solvent mixtures. Compared to current conventional techniques, the assets of this instrumentation for this purpose are the combined availability of a pressure delivery system, power supply, diode array absorbance detector and thermoregulation device, allowing unattended, automatic and easy operation, involving minimum sample handling. Most importantly, the required sample volume can be reduced to about 50 μL, making this protocol very cost-effective. A protocol was optimized with respect to time, sample consumption and data reliability for the determination of these physico-chemical parameters. Ionic liquids selected for method development and validation differed in the nature of their cation (butyl- and ethyl-methylimidazolium) and anion (trifluoromethanesulfonate and bis(trifluoromethanesulfonyl)imide). Various molecular solvents were mixed with these ionic liquids (acetonitrile, methanol, dimethylformamide and trifluoroethanol) and the same physico-chemical properties were determined by optimized methods. The knowledge of these data should be of great support in various application areas, including the development of new separation media for capillary electrophoresis and chromatographic techniques.     

Polyaniline and polypyrrole: A comparative study of the preparation

Aniline and pyrrole have been oxidized with ammonium peroxydisulfate in aqueous solutions, in the presence of equimolar quantities of hydrochloric acid. The oxidation of pyrrole was faster; the induction period typical of aniline oxidation was absent in the case of pyrrole. As the proportion of oxidant-to-monomer molar concentration increased up to 1.5, the yield increased in both cases. Similarities between the two oxidations are illustrated and discussed. The oxidant-to-monomer molar ratio 1.25 is proposed to be the optimum stoichiometry, in the accordance with the data published in the literature. The conductivities of the polymers prepared were only slightly dependent on the oxidant-to-monomer ratio in the range 0.3-1.5, and were of the order of 10⁰ S cm⁻¹ for polyaniline and ∼10⁻²-10⁻¹ S cm⁻¹ for polypyrrole. Outside this interval, the conductivity of both polymers was reduced. Polyaniline having conductivity ∼10 S cm⁻¹ was produced in solutions of phosphoric acid of various concentrations. On the contrary, the conductivity of polypyrrole was reduced as the concentration of phosphoric acid became higher. The type of protonation is discussed with the help of FTIR spectra by analyzing the ammonium salts obtained after deprotonation. Sulfate or hydrogen sulfate anions produced from peroxydisulfate always constitute a part of the counter-ions.     

酞菁,酞菁铁及酞菁镍电子性质的理论研究

以双片层分子为晶体单胞模型，用量子化学具有晶体轨道的ＥＨＭＯ方法研究了酞菁、酞菁铁及酞菁镍的导电性能，讨论了碘掺杂对它的影响。计算结果表明：由于碘掺杂后，系体构型发生了较大的变化，层间作用加强，从而前述几种晶体的能隙均显著降低，电导率大幅度提高。     

Electrical conductivity measurements of aqueous sodium chloride solutions to 600°C and 300 MPa

Electrical conductance measurements of dilute (<0.1>^–1) aqueous NaCl solutions were made primarily to quantify the degree of ion association which increases with increasing temperature and decreasing solvent density. These measurements were carried out at temperatures from 100 to 600°C and pressures up to 300 MPa with a modified version of the apparatus used previously in the high temperature study in this laboratory. Particular emphasis was placed on conditions close to the critical temperaturelpressure region of water, i.e., at 5° intervals from 370 to 400°C. The results verify previous findings that the limiting equivalent conductance A_o of NaCl increases linearly with decreasing density from 0.75 to 0.3 g-cm^–1 and also with increasing temperature from 100 to 350°C. Above 350°C. A_o is virtually temperature independent. The logarithm of the molal association constant as calculated exclusively from the data400°C is represented as a function of temperature (Kelvin) and the logarithm of the density of water (g-cm^–3) as follows:

碱金属和重金属叠氮化物的感度和导电性研究

分别用EHCO和DV－X_α方法，计算研究了α－NaN_3、β-NaN_3和AgN_3的能带结构和原子簇电子结构. AgN_3与NaN_3相比：带隙(△Eg)较小、带宽(BW)较大，因而电导率较大. 比较前沿晶体轨道(CO)和前沿分子轨道(MO)的能级、组成及电子在其间的跃迁；预示AgN_3比NaN_3更敏感、更易分解和起爆．还从电子微观层次揭示了金属叠氮化物的导电性和爆炸性之间的联系．     

Behavior of rifampicin in association with<Emphasis Type="Italic"> β</Emphasis>-cyclodextrin in aqueous media: a spectroscopic and conductometric study

The behavior of rifampicin (D) with -cyclodextrin (-CyD) in aqueous media (W) has been examined by means of UV-vis spectroscopy and conductivity measurements over the temperature range 15–30 °C. The UV-vis study has been used to characterize the systems. The estimated molar absorption coefficient for D/CyD/W system was 10757±280 M^–1 cm^–1 in comparison to the value of 6133±99 M^–1 cm^–1 for D/W system. The conductivity was measured (i) as a function of [D] for binary D/W systems, (ii) as a function of [CyD], keeping the concentration of drug constant, for D/CyD/W system, and (iii) as a function of [D] in the presence of a constant cyclodextrin concentration. Two transition points were observed for D/CyD/W system at constant [CyD], which were assigned as cac-1 and cac-2. The stoichiometry of the association was estimated from the conductivity data. This was obtained from [drug] value at which the change in slope of occurs. The standard free energy change, of aggregation was also calculated from the critical concentration data. An attempt has also been made to estimate the stoichiometry of -cyclodextrin:rifampicin association.