多功能旋流燃烧器的工业性试验研究

秦皇岛热电厂2＃锅炉燃烧不稳定、燃烧效率低等问题主要是由于燃烧器的一次风管道结构不合理造成的。本文采用多功能旋流燃烧器的设计思想对旋流燃烧器进行了技术改造和工业性试验研究。结果表明,改造后的旋流燃烧器其着火点提前,并且仅改造6只主力燃烧器就可以使锅炉在50％负荷时达到不投油而稳定燃烧,排烟温度、飞灰含碳量和NOx排放量明显下降。     

A decomposition procedure for the determination of arsenic in marine samples

The use of wet and dry ashing procedures to decompose marine biological tissues and to degrade organoarsenic compounds to inorganic arsenic for analysis by zinc-column arsine generation and atomic-absorption spectrophotometry was investigated. Wet ashing with nitric, sulphuric and perchloric acids (10:2:3 v/v) released the largest percentage of arsenic from fish tissue and quantitatively degraded methylated and other organoarsenic compounds to inorganic arsenic. The arsenic concentrations found when standard reference materials were ashed with this acid mixture were in agreement with the certified values.     

Investigation of two‐ and three‐bond carbon–hydrogen coupling constants in cinnamic acid based compounds

Two‐ and three‐bond coupling constants (²J_HC and ³J_HC) were determined for a series of 12 substituted cinnamic acids using a selective 2D inphase/antiphase (IPAP)‐single quantum multiple bond correlation (HSQMBC) and 1D proton coupled ¹³C NMR experiments. The coupling constants from two methods were compared and found to give very similar values. The results showed coupling constant values ranging from 1.7 to 9.7 Hz and 1.0 to 9.6 Hz for the IPAP‐HSQMBC and the direct ¹³C NMR experiments, respectively. The experimental values of the coupling constants were compared with discrete density functional theory (DFT) calculated values and were found to be in good agreement for the ³J_HC. However, the DFT method under estimated the ²J_HC coupling constants. Knowing the limitations of the measurement and calculation of these multibond coupling constants will add confidence to the assignment of conformation or stereochemical aspects of complex molecules like natural products. Copyright © 2016 John Wiley & Sons, Ltd.     

电站锅炉中粉煤灰与SiC耐火材料结渣性研究

本文主要研究含Cr2O3的硅酸锆结合SiC耐火材料的抗粉煤灰侵蚀规律,将两种不同的粉煤灰平铺在SiC耐火材料上,作用温度为1250～1450 ℃,保温时间为40小时,然后用视频光学显微镜和XRD衍射图谱来确定其显微结构和物相组成,初步实验结果表明SiC质耐火材料具有较好的抗煤灰侵蚀性能.     

气体示踪法研究燃烧器横向湍流混合扩散特性

用气体示踪法对侧边风燃烧器弱旋流一次风和侧边直流二次风横向湍流混合扩散特性进行了详细研究，讨论了各截面混合物浓度分布规律及混合强度分布规律，分析对燃料着火的影响，同时利用湍流运动方程反算气体湍流扩散系数     

大速差射流型双一次风通道通用煤粉主燃烧器

本文介绍了一种新型煤粉主燃烧器－双一次风通道通用煤粉主燃烧器。它既保留了大速差射流燃烧技术的优点，又彻底克服了燃烧器内容易局部结焦的缺点，从而由辅助燃烧器（或预燃室）发展成为主燃烧器。具有煤种适应性广，低负荷运行范围大，煤粉着火点位置可控等优点。     

Metall-π-komplexe von benzolderivaten : III. Bis(diphenylphosphino-h6-benzol)-chrom(0)

Rhodium complexes containing poly(pyrazolyl)borate ligands are described, and the fluxional nature of some of them considered.     

Darrieus–Landau instability and Markstein numbers of premixed flames in a Hele-Shaw cell

Hydrodynamic flame instabilities are studied in a Hele-Shaw burner. By studying the development of perturbations, starting from a 2D Bunsen flame at the top of the burner, growth rates are measured for propane and methane–air mixtures, and compared to theoretical predictions. It is found that the dispersion relation in a Hele-Shaw cell has the same dependence with wavenumber $\sigma =k?k^2$ as the one predicted in tubes. Markstein numbers relative to fresh gases are obtained for propane and methane flames and compared to the literature.     

On the global structure and asymptotic stability of low-stretch diffusion flame: Forced convection

The present work analyzes cylindrical diffusion flames (Tsuji burner) under low stretch condition, considering fuel injection also from the backward region of the burner. To highlight the fundamental aspects of this flame, some assumptions are imposed, like constant thermodynamic and transport coefficients, unitary Lewis number and no radiative heat loss. It is also considered potential flow model and incompressible Navier–Stokes model. Despite the simplicity of the former model, results from both models show good agreement. Also, an asymptotic analysis describing the problem far from the burner is able to capture the most important mechanisms controlling the flame, then the flame shape is determined and the dependence of the characteristic length scales on Peclet number (based on the burner properties), free stream velocity and stoichiometry is revealed. The results show that the flame width is proportional to the mass stoichiometric coefficient and reciprocal to the Peclet number the 1/4 power and free stream velocity the 3/4 power, and that the flame height is proportional to the square of the mass stoichiometric coefficient and to the square root of the ratio of Peclet number to free stream velocity. In addition, an asymptotic stability analysis reveals low-stretch flame extinction to be caused by reduction in fuel and oxidizer concentrations, which provides the range of the stoichiometric coefficient for stable regime, and at the same time the range of heat released.     

Experimental and numerical study of a conical turbulent partially premixed flame

The structure and dynamics of a turbulent partially premixed methane/air flame in a conical burner were investigated using laser diagnostics and large-eddy simulations (LES). The flame structure inside the cone was characterized in detail using LES based on a two-scalar flamelet model, with the mixture fraction for the mixing field and level-set G-function for the partially premixed flame front propagation. In addition, planar laser induced florescence (PLIF) of CH and chemiluminescence imaging with high speed video were performed through a glass cone. CH and CH₂O PLIF were also used to examine the flame structures above the cone. It is shown that in the entire flame the CH layer remains very thin, whereas the CH₂O layer is rather thick. The flame is stabilized inside the cone a short distance above the nozzle. The stabilization of the flame can be simulated by the triple-flame model but not the flamelet-quenching model. The results show that flame stabilization in the cone is a result of premixed flame front propagation and flow reversal near the wall of the cone which is deemed to be dependent on the cone angle. Flamelet based LES is shown to capture the measured CH structures whereas the predicted CH₂O structure is somewhat thinner than the experiments.