二次阳极氧化方法制备有序多孔氧化铝膜

通过二次阳极氧化方法制备多孔氧化铝膜与一次阳极氧化方法制备多孔氧化铝膜孔排布规律性的对比 ,结果发现 ,二次阳极氧化方法制取的多孔氧化铝膜孔排布规律性明显好于一次阳极氧化法制取的多孔膜 .在几个微米范围内 ,孔呈理想的六角排布 .去除一次阳极氧化膜后 ,二次阳极氧化得以在更良好的表面进行 ,制取的氧化铝膜孔规律性和有序度更高 .有序区域的尺寸与晶粒内的亚晶大小有一定关系     

Reintroduced solids increase inhibitor levels in a pretreated corn stover hydrolysate

Following detoxification of the liquid hydrolysate produced in a corn stover pretreatment process, inhibitor levels are seen to increase with the re-addition of solids for the ensuing hydrolysis and fermentation processes. The solids that were separated from the slurry before detoxification of the liquor contain approx 60% (w/w) moisture, and contamination occurs owing to the diffusion of inhibitors from the moisture entrained in the porous structure of the corn stover solids into the bulk fluid. This evidence suggests the need for additional separation and detoxification steps to purge residual inhibitors entrained in the moisture in the solids. An overliming process to remove furans from the hydrolysate failed to reduce total organic acids concentration, so acids were removed by treatment with an activated carbon powder. Smaller carbon doses proved more efficient in removing organic acids in terms of grams of acid removed per gram of carbon powder. Sugar adsorption by the activated carbon powder was minimal.     

城市污水处理工艺综述

介绍了国内外活性污泥废水处理的最新工艺。     

Sulfur Concentration in Nanoporous Alumina Membrane

Nanoporous alumina membrane prepared by anodic oxidation using sulfuric acid electrolyte was subjected to TG-DTA and X-ray Photoelectron Spectroscopy (XPS or ESCA) to further study the distribution of sulfur. In XPS study, Ar⁺ ion bombardment was performed on the sample to etch the surface at a rate of 3 nm min^-1. As a result, sulfur was found to be concentrated within a depth of 3nm from the surface. The S content of the surface was found to be 2.7±0.5 wt%, and that at a depth of ca. 3 nm and ca. 10 nm was found to be as low as about 0.6±0.11 wt% (5.37±1.0 wt%→ 1.26±0.2wt% SO₂). In TG-DTA, the mass loss of 7.3% was in fair agreement with that calculated on XPS results (7.1±1.2%). This revised version was published online in July 2006 with corrections to the Cover Date.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.     

Preparation and characterization of activated carbons from impregnation pitch by ZnCl2

Using an impregnation pitch from bituminous coal tar (OP) supplied by Industrias Químicas del Nalon Company as raw material, two phases (isotropic and anisotropic) have been obtained. The latter was used as precursor for the preparation of activated carbons. First, a chemical activation process was carried out with ZnCl₂ as activating agent. The process was conducted at different concentrations and temperatures and by means of impregnation with solid zinc chloride. Optimal values were obtained for samples prepared by using a ZnCl₂:pitch ratio equal to 3:1 (sample AZn3). Next, this sample was thermally treated at two different temperatures, i.e., 700 and 800 °C. A lose of specific surface area, microporosity and mesoporosity was observed with respect to sample AZn3, such a lose being more remarkable as temperature increased. Moreover, impregnation of the anisotropic phase of the original pitch with an aqueous solution of ZnCl₂ followed by thermal treatment resulted in a poorly developed surface area and porous texture, probably due to the presence of Zn complexes, which interfere with the activation process.     

超临界co2中模板法制备氧化铝多孔材料

超临界co2;活性炭;模板;氧化铝;多孔     

氧化铝/碳纳米管复合材料的制备及表征

采用聚乙烯醇对碳纳米管表面进行改性，通过化学沉淀法将Al(OH)₃均匀沉积在碳纳米管表面，然后在氮气气氛下于500 ℃煅烧2 h，制备出氧化铝/碳纳米管复合材料。采用TEM、TG、DTA、XRD、IR、氮吸附脱附(比表面积及孔结构分析)等对氧化铝/碳纳米管复合材料进行表征，结果表明:未经聚乙烯醇改性的碳纳米管，氧化铝与碳纳米管相互分离;经聚乙烯醇改性的碳纳米管，氧化铝与碳纳米管结合良好。经聚乙烯醇改性的碳纳米管表面均匀覆盖一层聚乙烯醇膜，通过聚乙烯醇的吸附作用， Al(OH)₃沉积在碳纳米管表面形成一层连续的覆盖层。     

The first example of the C-3 alkylation of indoles with cyclopropyl ketones promoted by CeCl3·7H2O/LiI

Indoles undergo smooth alkylation with cyclopropyl ketones in the presence of the CeCl₃·7H₂O/LiI reagent system in refluxing acetonitrile under neutral conditions to produce the corresponding C-3 substituted indole derivatives in good to high yields and with high selectivity. The use of CeCl₃·7H₂O/LiI makes this method simple, convenient, and cost-effective.     

铕离子探针研究Al2O3的相变过程

氧化铝具有许多重要的工业用途，而制备高热稳定活性氧化铝的技术也在不断地发展[1，2]，因此，研究其高温烧结下的相变过程很有意义．离子深法作为新型测试手段，已成功地用于生物大分子结构与功能研究方面［‘］，而在固体材料测试中的应用尚未见报道．我们以EU’“作为荧光探针，并结合＊＊D和＊nR研究了川对。在不同烧结温度下的相变过程．1实验部分样品的制备采用复盐分解法．先将Elf刀s用高纯硝酸溶解定容．以占AlzO。重量1％的量加入到硫酸铝锭溶液中，进行超声处理，冷冻干燥．再依次登于900”C、1000C、1100C、1200C的高温炉…