Effect of sodium dodecyl sulfate on CO2 and H2S absorption enhancement of functionalized multiwall carbon nanotubes in water: Experimental study and empirical model

A single bubble absorption column was used to examine the effect of hydrodynamic on carbon dioxide (CO₂) and hydrogen sulfide (H₂S) absorption in pure water and water-based nanofluids dispersed with neat, and OH and NH₂ functionalized multiwall carbon nanotubes (MWCNTs). Sodium dodecyl sulfate (SDS) was used as a surfactant and stabilizer. The maximum absorption of CO₂ and H₂S were found to be 0.0038 mmol/m²·s and 0.056 mmol/m²·s using NH₂-MWCNTs /nanofluid with 0.5 wt% content, respectively. The diffusion coefficients of gases into the nanofluids were computed by using an equation attained based on Dankwert’s theory. A last, an empirical correlation was proposed to determine the Sherwood number for the absorption of the aforementioned gases into the nanofluids.     

基于吸收系数的生脉注射液中聚山梨酯80含量测定新方法

聚山梨酯80又名吐温80，为一种亲水型非离子表面活性剂，是食品、保健品和药品中常用的辅料，作为增溶剂和澄清剂广泛用于中药注射剂。近年来，不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视，有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用，有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点，可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定，也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异，难以采用统一的转换公式或对照品准确定量。此外，中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题，以生脉注射液为例，提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间，在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%_{1 cm})为104.23，相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后，精密量取供试品溶液1.0 mL，精密加入硫氰酸钴溶液10 mL，二氯甲烷20 mL，涡旋振荡3 min。将混合液移至分液漏斗中，静置30 min，取下层二氯甲烷液，将前1 mL弃去，接收约15 mL，在320 nm处测定吸光度，再根据Lambert-Beer定律，利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰，精密度和重复性相对标准偏差均低于3%，平均回收率为98.42%。为进一步验证方法的准确性，分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液，并与实际投料量比较。配对t检验结果表明，当置信度为95%时，两种方法无显著性差异，吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长，显著降低了基质干扰，克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品，亦不用制备标准曲线，可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便，为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。     

原子吸收光谱法测定铝锂合金中锂

本文研究了用原子吸收光谱法在笑气－乙炔火焰中测定铝锂合金中锂的最佳条件。其电离干扰可通过加进钾进盐来控制。应用本法测定合金中 锂的含量，获得了满意结果。     

理论研究C8H80-（H2O）n（n=1～5）团簇

应用密度泛函B3LYP／6—31＋G（d，p）方法对C8H80-（H2O）n（n=1～5）团簇这种弱相互作用体系进行垒自由度能量梯度优化，得到该系列团簇的稳定蛄构．计算结果表明。在该系列二元团簇中，一方面水分子数目的多少对苯基丙酮分子的结构影响很小，另一方面由于苯基丙酮分子的存在，破坏了团簇中水分子的对称性结构，在团簇内部极力形成O—H—O这样弯曲的有方向性的氢键．对苯基丙酮-水这样结构复杂的团簇，指认光谱的难度非常大，本文只讨论了与C=O有关的振动峰和水分子的对称伸缩振动的最强峰．     

A novel approach to the acoustic characterisation of porous road surfaces

Porous road surfaces offer an effective means of reducing the generation and propagation of noise from road traffic. However, the porosity of these surfaces can deteriorate over time, leading to a reduction in their noise reducing properties. Efficient methods are therefore required for monitoring this performance. Existing techniques for performing in-situ measurements of acoustic absorption are unsuitable for use within the traffic stream. Static measurements using time domain Maximum Length Sequence (MLS) based techniques have been demonstrated to offer advantages over traditional techniques, presenting the opportunity for measurements under dynamic conditions. This paper describes the design of a system for carrying out dynamic MLS-based measurements. Results are presented which demonstrate that stable dynamic measurements can be carried out at speeds of up to 30 km/h.     

基于虚拟仪器的人体皮肤组织吸收光谱检测平台

本文运用光电无损检测技术,采用皮外反射式测量方法,通过光纤光谱仪和虚拟仪器构建人体皮肤组织吸收光谱检测平台.该平台适合于光子-组织相互作用基础研究及激光美容临床检测,可协助医师进行病理诊断和病变程度判别.文中给出几个吸收光谱的检测结果.     

Acoustic characterization and prediction for fan-duct-plenum-room integrations

This paper investigates mutual influence of duct and room acoustics in the whole fan-duct-plenum-room integrations. Applying the parametric design language of finite element software ANSYS (APDL), dimensional and positional influence on system acoustics has been studied. Models with different room dimensions, duct lengths, duct cross-sections, duct locations, duct discharges and duct elbow were constructed, and their characteristics were compared qualitatively. Results show that small rooms, short ducts, large duct cross-sections and bell mouth duct discharges help to increase room sound pressure levels (SPLs); SPLs in ducts and plenums are sensitive to duct dimensions and duct discharge types but insensitive to duct locations and room dimensions; duct elbows have relatively indistinct acoustic influence in each component. Based on the calculation results, a semi-experimental method was proposed for simply and approximately evaluating indoor acoustic spectra of fan-duct-plenum-room integrations, then an example was used to demonstrate the prediction process. Finally, by adopting several ideal models, sound field constitutions, duct and room wall admittances and duct end reflection were explored quantitatively. This study may give a detailed understanding of fan-duct-plenum-room acoustics for researchers, also it might provide a new, simple and approximate prediction method for professionals to evaluate and improve fan-ducted acoustics.     

First-principles study on the origin of optical transitions to be associated with F colour centers for PbWO4 crystals

The electronic structures of PbWO₄ crystals containing F type color centers with the lattice structure optimized are studied within the framework of the fully relativistic self-consistent Direc–Slater theory, using a numerically discrete variational (DV-Xα) method. The calculated results show that F and F⁺ centers have donor energy level in forbidden band. Their optical transition energy are 1.84 eV, 2.21 eV, respectively, which corresponds to the 680 nm, 550 nm absorption bands. It predicts that the 680 nm, 550 nm absorption bands originate form the F and F⁺ centers in PbWO₄ crystals.     

Optimization of the locations of the loudspeaker and absorption material in a small room

The sound field both in the loudspeaker box and in the room is calculated by an analytical solution of three-dimensional wave equation. It is shown in theory that the amplitude response in small rooms is affected by the following positions: driver position on the front panel of the box, box position in the room, absorption material position in the box and absorption material position on the interior walls of the room. Both our computer prediction and experiments prove that the optimum positions are beneficial to the amplitude response.     

Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003