高分辨大视场紫外-可见光偏振成像融合处理技术

采用蒙特卡罗方法对水云下大气的偏振态分布进行了仿真分析,所建立的水云大气环境在紫外360～400 nm波段的偏振度响应最大。采用紫外-可见光偏振成像技术对同一视场下的楼房、云和天空进行了偏振成像实验,并用霍夫变换分割方法对图像中的每个区域进行了统计分析,发现观测区域内无云区与云区的偏振角均值相对差为1.6%,偏振度均值相对差为-14%,证明了大气偏振角较偏振度稳健。紫外光和可见光在对云目标的偏振观测中存在互补性,采用拉普拉斯金字塔图像融合技术能够提高对大气目标的探测能力,验证了大视场高分辨紫外-可见光偏振成像技术在大气探测中的可行性和有效性。     

扩宽OMA-Ⅵ同时谱宽的新方法

OMA－Ⅵ存在同时谱宽窄的缺点，本文用一种新方法大幅度地扩宽了它的同时谱宽，且不降低其系统分辨率，应用效果甚佳。     

非晶调制多层膜Nb/Si中的互扩散研究

利用原位Ｘ射线衍射技术得到非晶调制多层膜Ｎｂ／Ｓｉ中的互扩散系数与退火温度的关系，调制周期Ｌ＝３.２ｎｍ的非晶调制多层膜是用粒子溅射方法制备的．温度范围为４２３—５２３Ｋ的有效互扩散系数通过原位测量多层膜的一级调制峰强度与退火温度之间的关系而得到．利用缺陷陷阱延迟扩散机制解释了所得到的扩散系数与退火温度的关系．建立了可以解释较小前置系数的模型 关键词：     

Second-order random wave solutions for interfacial internal waves in N-layer density-stratified fluid

This paper studies the random internal wave equations describing the density interface displacements and the velocity potentials of N-layer stratified fluid contained between two rigid walls at the top and bottom. The density interface displacements and the velocity potentials were solved to the second-order by an expansion approach used by Longuet-Higgins （1963） and Dean （1979） in the study of random surface waves and by Song （2004） in the study of second- order random wave solutions for internal waves in a two-layer fluid. The obtained results indicate that the first-order solutions are a linear superposition of many wave components with different amplitudes, wave numbers and frequencies, and that the amplitudes of first-order wave components with the same wave numbers and frequencies between the adjacent density interfaces are modulated by each other. They also show that the second-order solutions consist of two parts： the first one is the first-order solutions, and the second one is the solutions of the second-order asymptotic equations, which describe the second-order nonlinear modification and the second-order wave-wave interactions not only among the wave components on same density interfaces but also among the wave components between the adjacent density interfaces. Both the first-order and second-order solutions depend on the density and depth of each layer. It is also deduced that the results of the present work include those derived by Song （2004） for second-order random wave solutions for internal waves in a two-layer fluid as a particular case.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

约束层对激光驱动冲击波压力影响机理的理论研究

针对刚性约束层、柔性约束层以及液体约束层，从激光诱导冲击波阵面状态、汽化物(包括气体和等离子体)扩散以及冲击波的反射进行分析，发现对于脉宽小于冲击波通过汽化物层的时间间隔的短脉冲激光，约束层并不能直接提高冲击波的冲量，而对于脉宽大于冲击波通过汽化层时间间隔的激光，其增强冲击效果是通过约束汽化物的扩散，提高压力幅值和由于冲击波在约束层与工件表面的多次反射而延长对工件的作用时间来实现的.刚性约束层能最大地增加冲击冲量，而柔性约束层和液体约束层的主要优点是其形状可与非平面形工件表面符合. 关键词： 激光 约束层 扩散 反射波     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

模糊对向传播网络数据融合目标识别方法

重点研究了模糊对向传播网络 (FCPN)模型。针对数据融合和目标识别的特点 ,提出了基于模糊对向传播网络的融合目标识别方法和改进的模糊对向传播网络 (MFCPN)融合结构。利用仿真数据对网络的训练算法和融合结构进行了实验研究。结果表明 ,模糊对向传播网络较误差后向传播网络 (BPN)能够有效地实现融合识别 ;改进的模糊对向传播网络融合结构是可行的。同时还对FCPN和MFCPN应用于前视红外 (FLIR)和可见光摄像机目标跟踪系统进行了应用研究。