基于吸收系数的生脉注射液中聚山梨酯80含量测定新方法

聚山梨酯80又名吐温80，为一种亲水型非离子表面活性剂，是食品、保健品和药品中常用的辅料，作为增溶剂和澄清剂广泛用于中药注射剂。近年来，不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视，有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用，有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点，可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定，也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异，难以采用统一的转换公式或对照品准确定量。此外，中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题，以生脉注射液为例，提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间，在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%_{1 cm})为104.23，相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后，精密量取供试品溶液1.0 mL，精密加入硫氰酸钴溶液10 mL，二氯甲烷20 mL，涡旋振荡3 min。将混合液移至分液漏斗中，静置30 min，取下层二氯甲烷液，将前1 mL弃去，接收约15 mL，在320 nm处测定吸光度，再根据Lambert-Beer定律，利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰，精密度和重复性相对标准偏差均低于3%，平均回收率为98.42%。为进一步验证方法的准确性，分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液，并与实际投料量比较。配对t检验结果表明，当置信度为95%时，两种方法无显著性差异，吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长，显著降低了基质干扰，克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品，亦不用制备标准曲线，可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便，为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。     

微波消解-氢化物发生-原子荧光光谱法测定7种中草药中砷

利用原子荧光光谱法测定7种驱虫类中草药中的砷.实验采用微波消解样品,以盐酸为测定介质,硫脲-抗坏血酸为预还原剂,硼氢化钾为氢化剂,用氢化物发生-原子荧光光谱法测定砷含量.砷含量在10-100ng/mL浓度范围内线性关系好(r2=0.9924).回收率为93.83%-110.94%之间.方法简便、快速、灵敏、准确,可用于中草药中砷的测定.     

空心阴极灯激发的微波等离子体炬原子/离子荧光光谱研究--钙的原子/离子荧光光谱

用强短脉冲供电技术的空心阴极灯作激发源、微波等离子体炬作原子／离子化器，建立了原子／离子荧光光谱实验装置。详细研究了微波等离子体功率、观察高度、空心阴极灯电流等因素对原子／离子荧光信号强度的影响，测量了系统对Ca的原子／离子荧光光谱的检出限。     

国内首次研制成功的高温超导移动通讯基站子系统原理性样机

高温超导移动电话基站子系统可以明显提高基站的性能，因此受到广泛的重视。我们利用一个高性能超导滤波器，低噪声放大器，脉冲管制冷机和有关的微波线路集成了一台完整的高温超导移动通讯基站子系统原理性样机。该子系统是针对DCS1800基站系统，频段为1710-1785MHz，系统增益为18dB，该子系统是国内研制成功的首台原理性样机。这表明对高温超导微波器件的应用研究已取得了阶段性的重要成果。性能更好的实用子系统样机正在研制中。     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

A Compact Magnetically Insulated Line Oscillator with New-Type Beam Dump

We present a compact improved model of the magnetically insulated line oscillator with new-type beam dump and other novel features. In the experiments, high-power microwave of the TM01 mode is generated from the device with a frequency range of 1.73-1.78 GHz and a peak power level of above 2 GW, when the diode voltage is taken in the range 520-540kV, and the diode current is in the range 58-62kA. This confirms the simulation results.     

A Generalization of the Mean Size Formula of Wavelet Packets in Lp

The purpose of this paper is to investigate the mean size formula of wavelet packets in Lp for 0 〈 p ≤ ∞. We generalize a mean size formula of wavelet packets given in terms of the p-norm joint spectral radius and we also give some asymptotic formulas for the Lp-norm or quasi-norm on the subdivision trees. All results will be given in the general setting,     

A New High Efficiency Multiwave Cerenkov Generator Operating at Low Magnetic Field

With a resonant cavity inserted between the second slow-wave-structure section and the tapered wavegulde, a new structure of the multlwave Cerenkov generator (MWCG) operating at low guiding magnetic field is proposed to produce high efficiency and high power microwave. Some features and potential advantages of the proposed device are analysed. The 2.5-dimensional partlcle-in-cell simulation is employed to verify the initial expectation.The results show that, with the use of an electron beam of 640keV and 8.4kA guided by the magnetic lield of 0.6 T, a stable and monochromatic X-band microwave output of 4 GW in peak power is achieved, and the average efficiency is over 30%.