两种方法制备ITO薄膜的红外特性分析

比较了用电束加热蒸发法和直流磁控溅射法制备的氧化锡铟(ITO)薄膜在红外波段的光学特性实验发现,通过直流磁控溅射在常温下制备的ITO薄膜在红外波段折射率稳定、消光系数小,比电子束加热蒸发制备的膜有较高的透过率在波长1550nm附近的透过率可达86%以上,消光系数约为004,方电阻最低为100Ω/□.     

双面加热环形通道内干涸点的确定

根据环形管通道内流体流动和换热的特点,以Kirillov和Smogalev提出的干涸点理论模型假设为基础,从最基本的质量守恒方程出发,并引入临界液膜厚度等相应的辅助模型,得到了双面加热环形通道内流动沸腾干涸点的理论模型。同时针对间隙为1.0mm和1.5mm的环形窄缝进行了低压低质量流速工况下干涸点的实验研究。比较发现理论模型预测值与实验结果基本相符。说明本文提出的理论模型适用于低压低流量条件下的窄环形通道。实验同时发现:环状流临界热流密度在系统压力为2.2MPa达到最大值,临界含汽量随质量流速的增大呈缓慢下降趋势。     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.     

覆盖亚临界到临界区的制冷工质物性快速算法

为了在亚临界到临界点这个大范围内保证制冷剂物性计算的快速、稳定、可逆,提出将整个数据区间划分成若干个子区间分别进行隐式拟合,并且保证相邻子区间连接点处的连续与光滑,以及通过求分析解从隐式方程中得到显式物性计算式的方法.以美国国家标准局开发的程序REFPROP6.01的计算结果作为数据源,以R410A为例对该方法做了验证.得出快速物性计算公式的应用范围为饱和温度-60℃至临界温度,与NIST REFPROP 6.01的计算结果进行比较表明,计算速度快1500倍,平均相对偏差小于0.01%.     

Specific Angular Momentum Distribution of Disc Galaxies Formed in Preheated Intergalactic Media

Assuming that baryons within a galactic halo have the same specific angular momentum as the dark matter where they locate initially and a disc forms due to the gas cooling and condensation with the conservation of angular momentum, we investigate the angular momentum distribution in a resulting galactic disc under the new preheated galaxy formation model suggested by Mo and Mao (Mon. Not. R. Astron. Soc. 333 (2002) 768).Compared with the observational results, it can be concluded that the preheated galaxy formation model can match current observations. This model can be a good approach to solve the problems of both the angular momentum catastrophe and the mismatch of angularomomentum profiles in current disc galaxy formation models.     

70K温区混合工质分凝分离循环节流制冷机实验研究

混合工质节流制冷机正在许多方面获得越来越广泛的应用。文中设计了一种新型的混合工质分凝分离循环 ,建立了实验系统 ,并在 70 K温区进行了实验。实验结果表明 ,节流制冷机可以达到 6 5 .3K的低温 ,并在 72 K温度提供 1W的制冷量 ,输入功率为 5 0 0 W。     

辐射加热金X光再发射时间测量

利用星光Ⅱ三倍频激光打双盘靶，研究了辐射加热材料的Ｘ光发射时间。激光脉冲能量４０～６０Ｊ、脉冲宽度６００～７００ｐｓ。通过两台时间关联的亚千Ｘ光能谱仪分别监测双盘靶初、次级发射Ｘ光谱，给出了辐射加热次级Ｘ光再发射时间。     

中国环流器新一号（HL—1M）装置研制

ＨＬ－１Ｍ装置是由ＨＬ－１托卡马克改建成的，从１９９４年１０月起，已成功地投入运行。它们是一个中型圆截面托马克装置，但去掉了铜导体壳，以 便以地等 体进行高功率辅助加热，低杂波电流驱动和弹丸注入等研究。     

激光二极管端面抽运的1.34μm Nd:YVO4三镜折叠腔型激光器

理论上提出了三镜折叠腔的稳区理论,所得结论对设计激光器具有重要的指导意义;实验上实现了激光二极管端面抽运的1.34μm Nd:YVO4三镜折叠腔型激光器的运转.