全文获取类型
收费全文 | 128篇 |
免费 | 8篇 |
国内免费 | 16篇 |
专业分类
化学 | 11篇 |
力学 | 60篇 |
综合类 | 3篇 |
数学 | 42篇 |
物理学 | 36篇 |
出版年
2023年 | 2篇 |
2022年 | 2篇 |
2021年 | 5篇 |
2020年 | 9篇 |
2019年 | 3篇 |
2018年 | 5篇 |
2017年 | 4篇 |
2016年 | 6篇 |
2015年 | 6篇 |
2014年 | 5篇 |
2013年 | 10篇 |
2012年 | 6篇 |
2011年 | 8篇 |
2010年 | 7篇 |
2009年 | 4篇 |
2008年 | 3篇 |
2007年 | 5篇 |
2006年 | 9篇 |
2005年 | 5篇 |
2004年 | 3篇 |
2003年 | 6篇 |
2002年 | 2篇 |
2001年 | 7篇 |
2000年 | 3篇 |
1999年 | 3篇 |
1998年 | 7篇 |
1997年 | 4篇 |
1996年 | 3篇 |
1995年 | 3篇 |
1994年 | 1篇 |
1993年 | 1篇 |
1991年 | 1篇 |
1990年 | 1篇 |
1987年 | 1篇 |
1984年 | 1篇 |
1982年 | 1篇 |
排序方式: 共有152条查询结果,搜索用时 15 毫秒
1.
Fouling Mitigation in a Heat Exchanger: High Cycles of Concentration for a Cooling-Tower Application
The purpose of the present study is to investigate the effect of a physical water treatment (PWT) technology on fouling mitigation in a simulated cooling tower operating at high cycles of concentration. Hard water was produced by evaporating pure water in a circulating open cooling tower, where dissolved calcium carbonate ions became concentrated with time. Heat transfer tests were conducted in a rectangular channel by varying the cycle of concentration (COC) from 5 to 10, and fouling resistances were measured over 270 hrs for each case with and without the PWT treatment. Another test was conducted with no blowdown case with and without the PWT treatment. The fouling resistance at 5 cycles with the PWT treatment was about 70% less than that in the case without the PWT treatment at the end of 270-hr tests. Even at 10 cycles, the PWT treatment reduced the fouling resistance by 60% from the value for the no treatment case. Thus, one can conclude that the PWT technology can help circulating cooling-tower water at relatively high COC for significant freshwater conservation, while keeping fouling resistances below industry standards. 相似文献
2.
3.
为明确冷却塔在水平地震下的内力环向分布特征及内在原因,同时探究不同地震波时程与规范反应谱所得内力差异的原因,以某大型双曲冷却塔为例,在动力特性分析的基础上,通过反应谱方法和时程方法的水平地震响应计算及对比分析,对上述两个问题进行了研究。研究表明:由于仅侧弯振型对水平地震有贡献,而塔筒的侧弯振型和实际响应均表现为整体侧倾并伴随微弱的截面“流动”变形,这也使塔筒各内力的环向分布分别呈现正弦、余弦分布特征;其整体侧倾可类比于悬臂杆结构,塔筒子午向轴力FY、子午向弯矩MY、剪力FXY和扭矩MXY的环向分布可借助悬臂杆侧倾时截面正应力和剪应力分布来解释;而截面“流动”变形则决定了环向轴力FX和环向弯矩MX的环向分布;整体侧移显著而截面变形极小也使FY和FXY的幅值在塔筒中下部明显大于FX;由于冷却塔第1阶侧弯振型在水平地震响应中往往起绝对主导作用,因此可先对所选地震波计算得到其反应谱,对比第1阶侧弯振型周期对应的水平地震影响系数α值,即可初步推断不同时程及规范反应谱方法所得结果的大小关系。 相似文献
4.
5.
对输电塔进行合理简化可以提高塔线体系动力学仿真的效率。本文给出自立塔梁柱简化模型的计算方法,并提出利用梁柱简化模型计算方法建立自立塔塔线体系整体模型,同时采用桁梁混合模型建立精细化塔线体系整体模型,对两种模型塔线体系静力特性及振型和固有频率等动力特性进行对比分析。以脱冰工况为例,采用生死单元技术将施加在输电线节点上的集中质量单元杀死来模拟脱冰,实现对塔线体系动力学响应的有限元模拟,研究塔线体系简化模型在动态响应中的适用性。结果表明,两种模型弯曲变形误差小,低阶的振型相同,固有频率值误差小,动力特性基本相同;脱冰工况下,自立塔节点位移和塔材内力时程曲线一致,在提高计算效率的情况下,能有效保证计算精度。 相似文献
6.
Vé ronique Maume-Deschamps 《Transactions of the American Mathematical Society》2001,353(8):3371-3389
We study the decay of correlations for towers. Using Birkhoff's projective metrics, we obtain a rate of mixing of the form:
where goes to zero in a way related to the asymptotic mass of upper floors, is some Lipschitz norm and is some norm. The fact that the dependence on is given by an norm is useful to study asymptotic laws of successive entrance times.
7.
8.
9.
针对架空输电线路铁塔中常用的四地脚螺栓塔脚板进行了抗拉承载力试验和理论计算方法研究。首先,选取8个试件进行塔脚板抗拉承载力试验研究,分析塔脚底板板厚及有无加劲板对塔脚板抗拉承载力的影响;其次,通过有限元模拟塔脚板的应力分布情况,并结合“塑性分析,弹性设计”的思想,提出了一种基于屈服线理论的四地脚螺栓塔脚板抗拉承载力计算公式;最后,与试验结果、有限元仿真结果、已有技术规定中的计算结果进行了对比。结果表明:建议公式与试验结果和仿真结果较为吻合,相关技术规定中的计算结果偏于保守,验证了本文建议公式的精确性;底板厚度和加劲板的作用对塔脚板承载力影响较大。研究结果可为输电铁塔四地脚螺栓塔脚板结构设计提供参考。 相似文献
10.
本文采用随机数值方法模拟噪声,并用有限元法分析噪声对大型冷动塔动力特性的影响。研究发现,无论是迭加噪声还是调频噪声,都将使冷却塔振动响应超过规定允许值。通过改变冷却塔体横加结构,改善了塔体的动力特性,噪声影响明显减少。 相似文献