Optimization of Transducer Location for Novel Non-Intrusive Methodologies of Diagnosis in Diesel Engines

The health monitoring has been studied to ensure integrity of design of engine structure by detection, quantification, and prediction of damages. Early detection of faults may allow the downtime of maintenance to be rescheduled, thus preventing sudden shutdown of machines. In cylinder pressure developed, vibrations and noise emissions data provide a rich source of information about condition of engines. Monitoring of vibrations and noise emissions are novel non-intrusive methodologies for which positioning of various transducers are important issue. The presented work shows applicability of these diagnosis methodologies adopted in case of diesel engines. The effects of changing various fuel injection parameters was analyzed. Scope of using non-intrusive technique has been analyzed by changing locations of microphone. Novelty of this worklies in exploring signal processing methods for various locations around the engine test set up. Various frequency ranges of contributing noise and vibration sources were identified. Time-Frequency analysis showed the onset of various cyclic. Based on the identification of various frequency bands, it is possible to device suitable filters in order to extract more information.     

The coupled-cluster formalism – a mathematical perspective

ABSTRACT

The Coupled-Cluster (CC) theory is one of the most successful high precision methods used to solve the stationary Schrödinger equation. In this article, we address the mathematical foundation of this theory with focus on the advances made in the past decade. Rather than solely relying on spectral gap assumptions (non-degeneracy of the ground state), we highlight the importance of coercivity assumptions – Gårding type inequalities – for the local uniqueness of the CC solution. Based on local strong monotonicity, different sufficient conditions for a local unique solution are suggested. One of the criteria assumes the relative smallness of the total cluster amplitudes (after possibly removing the single amplitudes) compared to the Gårding constants. In the extended CC theory the Lagrange multipliers are wave function parameters and, by means of the bivariational principle, we here derive a connection between the exact cluster amplitudes and the Lagrange multipliers. This relation might prove useful when determining the quality of a CC solution. Furthermore, the use of an Aubin–Nitsche duality type method in different CC approaches is discussed and contrasted with the bivariational principle.     

3D‐morphology reconstruction of nanoscale phase‐separation in polymer memory blends

In many organic electronic devices functionality is achieved by blending two or more materials, typically polymers or molecules, with distinctly different optical or electrical properties in a single film. The local scale morphology of such blends is vital for the device performance. Here, a simple approach to study the full 3D morphology of phase‐separated blends, taking advantage of the possibility to selectively dissolve the different components is introduced. This method is applied in combination with AFM to investigate a blend of a semiconducting and ferroelectric polymer typically used as active layer in organic ferroelectric resistive switches. It is found that the blend consists of a ferroelectric matrix with three types of embedded semiconductor domains and a thin wetting layer at the bottom electrode. Statistical analysis of the obtained images excludes the presence of a fourth type of domains. The criteria for the applicability of the presented technique are discussed. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1231–1237     

The character and the wave front set correspondence in the stable range

We relate the distribution characters and the wave front sets of unitary representation for real reductive dual pairs of type I in the stable range.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

On generalized perfect difference sets constructed from Sidon sets

Let $\mathbb{N}$ be the set of positive integers. For a nonempty set A of integers and every integer u, denote by $d_A(u)$ the number of $(a,a^{\prime })$ with $a,a^{\prime }\in A$ such that $u=a-a^{\prime }$. For a sequence S of positive integers, let $S(x)$ be the counting function of S. The set $A\subseteq \mathbb{N}$ is called a perfect difference set if $d_A(u)=1$ for every positive integer u. In 2008, Cilleruelo and Nathanson (2008) [4] constructed dense perfect difference sets from dense Sidon sets. In this paper, as a main result, we prove that: let $f:\mathbb{N}\to \mathbb{N}$ be an increasing function satisfying $f(n)\ge 2$ for any positive integer n, then for every Sidon set B and every function $\omega (x)\to \infty$, there exists a set $A\subseteq \mathbb{N}$ such that $d_A(u)=f(u)$ for every positive integer u and $B(x/3)-\omega (x)\le A(x)\le B(x/3)+\omega (x)$ for all $x\ge C_{f,B,\omega }$.     

Properties of bounded stochastic processes employed in biophysics

Abstract

Realistic stochastic modeling is increasingly requiring the use of bounded noises. In this work, properties and relationships of commonly employed bounded stochastic processes are investigated within a solid mathematical ground. Four families are object of investigation: the Sine-Wiener (SW), the Doering–Cai–Lin (DCL), the Tsallis–Stariolo–Borland (TSB), and the Kessler–Sørensen (KS) families. We address mathematical questions on existence and uniqueness of the processes defined through Stochastic Differential Equations, which often conceal non-obvious behavior, and we explore the behavior of the solutions near the boundaries of the state space. The expression of the time-dependent probability density of the Sine-Wiener noise is provided in closed form, and a close connection with the Doering–Cai–Lin noise is shown. Further relationships among the different families are explored, pathwise and in distribution. Finally, we illustrate an analogy between the Kessler–Sørensen family and Bessel processes, which allows to relate the respective local times at the boundaries.     

基于串联两阶段网络DEA模型的供应链规模收益分析

数据包络分析(DEA)是评价供应链系统(Supply chain system)间相对有效性的一种重要的工具,但是传统的DEA不考虑供应链的内部结构,对系统效率评价偏高;而本文所研究两阶段串联供应链系统,考虑把部分中间产品作为最终产品输出,增加额外中间投入的情形.基于所提出的供应链系统结构,本文建立相应的串联结构下的网络DEA模型,并针对所建立模型进行相关理论的研究,给出了串联结构下的生产可能集和规模收益情况判定方法.最后,进行数值实验,以验证我们提出的结论.     

Formation of porous polymer morphology by microsyneresis during divinylbenzene polymerization

This article describes the investigation of the importance of various reaction conditions on microsyneretic pore formation during polymerization of divinylbenzene (DVB) under so‐called “solvothermal” conditions. To induce microsyneretic pore formation, the most important parameter is an unusually high dilution of monomers with a “good” porogen solvating the polymer chains. High dilution and solvation of the growing poly(DVB) chains promote the prolongation of the polymer chains rather than their interconnection by crosslinking. Consequently, when the polymer gel density reaches the point where syneresis starts, the polymer network is geometrically too extensive to be broken up into precipitating entities and, instead, porogen droplets are formed within the continuous polymer gel. The pore geometry created by microsyneresis offers high surface area in wide mesopores and hence, high capacity for supporting functional groups or reactions with much better accessibility than narrow pores between polymer microspheres produced by macrosyneresis in conventional styrenic polymer supports. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 774–781