Optimization of Transducer Location for Novel Non-Intrusive Methodologies of Diagnosis in Diesel Engines

The health monitoring has been studied to ensure integrity of design of engine structure by detection, quantification, and prediction of damages. Early detection of faults may allow the downtime of maintenance to be rescheduled, thus preventing sudden shutdown of machines. In cylinder pressure developed, vibrations and noise emissions data provide a rich source of information about condition of engines. Monitoring of vibrations and noise emissions are novel non-intrusive methodologies for which positioning of various transducers are important issue. The presented work shows applicability of these diagnosis methodologies adopted in case of diesel engines. The effects of changing various fuel injection parameters was analyzed. Scope of using non-intrusive technique has been analyzed by changing locations of microphone. Novelty of this worklies in exploring signal processing methods for various locations around the engine test set up. Various frequency ranges of contributing noise and vibration sources were identified. Time-Frequency analysis showed the onset of various cyclic. Based on the identification of various frequency bands, it is possible to device suitable filters in order to extract more information.     

Localization and quantification of radical production in cavitating flows with luminol chemiluminescent reactions

Hydrodynamic cavitation experiments in microfluidic systems have been performed with an aqueous solution of luminol as the working fluid. In order to identify where and how much reactive radical species are formed by the violent bubble collapse, the resulting chemiluminescent oxidation reaction of luminol was scrutinized downstream of a constriction in the microchannel. An original method was developed in order to map the intensity of chemiluminescence emitted from the micro-flow, allowing us to localize the region where radicals are produced. Time averaged void fraction measurements performed by laser induced fluorescence experiments were also used to determine the cavitation cloud position. The combination void fraction and chemiluminescence two-dimensional mapping demonstrated that the maximum chemiluminescent intensity area was found just downstream of the cavitation clouds. Furthermore, the radical yield can be obtained with our single photon counting technique. The maximum radical production rates of 1.2*10⁷ OH/s and radical production per processed liquid volume of 2.15*10¹⁰ HO/l were observed. The proposed technique allows for two-dimensional characterisation of radical production in the microfluidic flow and could be a quick, non-intrusive way to optimise hydrodynamic cavitation reactor design and operating parameters, leading to enhancements in wastewater treatments and other process intensifications.     

基于串联两阶段网络DEA模型的供应链规模收益分析

数据包络分析(DEA)是评价供应链系统(Supply chain system)间相对有效性的一种重要的工具,但是传统的DEA不考虑供应链的内部结构,对系统效率评价偏高;而本文所研究两阶段串联供应链系统,考虑把部分中间产品作为最终产品输出,增加额外中间投入的情形.基于所提出的供应链系统结构,本文建立相应的串联结构下的网络DEA模型,并针对所建立模型进行相关理论的研究,给出了串联结构下的生产可能集和规模收益情况判定方法.最后,进行数值实验,以验证我们提出的结论.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

一阶最优性条件研究

本对由Botsko的关于多变量函数取极值的一阶导数检验条件定理^[1]进行了分析研究，给出了更实用而简捷的差别条件。最后，举出若干例子予以说明。     

C^n中子空间之间极端主角的一些应用

本文给出了Ｃ＾ｎ中子空间之间最大和最小主角在矩阵逼近，投影算子的扰动分析，群逆以及Ｏｒａｘｉｎ逆的扰动估计，条件数理论，Ｂｏｔｔ－Ｄｕｆｆｉｎ系统扰动分析中一些应用。     

一类小缺陷码的链条件

利用射影几何方法在小缺陷码中,NMDS码是链条件码;给出k维NμMDS(0μk-2)码满足链条件的一个充要条件与一些易判断的充分条件.     

一类机器人系统的最优控制

本文通过把结构阻尼系数当作控制变量来讨论一类弹性机器人系统的最优控制问题 ,并利用Banach空间几何性质证明了最优控制元的存在唯一性     

Sensitivity analysis for discrete optimal control problems

We present local sensitivity analysis for discrete optimal control problems with varying endpoints in the case when the customary regularity of boundary conditions can be violated. We study the behavior of the optimal solutions subject to parametric perturbations of the problem.     

非完整系统Chetaev动力学和vakonomic动力学的等价条件

就一般非完整约束系统，从约束方程满足的变分恒等式出发，利用增广位形流形上的向量场定义三类非自由变分，即非完整变分：vakonomic变分、Hlder变分、Suslov变分，并讨论它们之间的关系以及它们成为自由变分的充要条件.利用非完整变分以及相应的积分变分原理建立两类动力学方程：vakonomic方程和Routh方程或Chaplygin方程.通过vakonomic方程分别与Routh方程和Chaplygin方程比较，得到它们具有共同解的两类充分必要条件.这些条件并不是约束的可积性条件. 关键词： 非完整约束 非完整变分 Chetaev条件 vakonomic动力学