Numerical study on thermal performance of TiO2, Fe3O4 and NiCr/engine oil in an inclined wavy pip

The essential intention of the existing article is to illustrate the effect of wall properties on flow and thermal behavior, through a sinusoidal inclined wavy pipe. To succeed this phenomena we assume a sinusoidal pipe consist of wavy surface, whose walls traveling down to its borders and located at an inclined position, moreover titanium dioxide (TiO₂), ferrosoferric oxide (Fe₃O₄) and nichrome (80% Ni and 20% Cr) are considered as nano-particles and unused engine oil is assumed as a base fluid. The arising mathematical equations for thermal and flow ratio with wall slip impact are solved by mathematica. Also, evaluate graphically the thermal and flow behavior of nanofluids for multi values of solid volume fractions (η), rigidity parameter (M₁), stiffness parameter (M₂), viscous damping parameter (M₃), Grashof number (G_r), slip parameter (β) and heat generation parameter (H) also discuss the streamlines for different values of solid volume fraction.     

von Neumann’s trace inequality for Hilbert–Schmidt operators

von Neumann’s inequality in matrix theory refers to the fact that the Frobenius scalar product of two matrices is less than or equal to the scalar product of the respective singular values. Moreover, equality can only happen if the two matrices share a joint set of singular vectors, and this latter part is hard to find in the literature. We extend these facts to the separable Hilbert space setting, and provide a self-contained proof of the “latter part”.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Morphologically controlled synthesis of 1-dimensional selenium dioxide and study of its application as catalyst for diesel fuel additive

In this research work, selenium dioxide (SeO₂) nanorods have been prepared by a solvothermal method in which a strong reducing agent (NaBH₄) was used to reduce precursor salt into SeO₂ nanorods. X-ray diffraction (XRD) technique was applied to observe the crystal structure which confirmed its tetragonal geometry. Moreover, morphology and particle size were studied by scanning electron microscopy (SEM). SEM fully described the 1-dimensional morphology of SeO₂ nanorods which then arranged themselves to create a 3-dimensional flower-like structure with an average particle size of 50 nm. Also, the catalytic activity of SeO₂ nanorods as diesel-additive was studied by defining different parameters such as fire and flash points, calorific value, cloud and pour points, specific gravity, and kinematic viscosity. Subsequently, SeO₂ nanorods proved to be an excellent diesel additive due to higher total heat content and lower value of kinematic viscosity which enhances the better performance of the diesel engine.     

Design and development of a two‐dimensional system based on hydrophilic and reversed‐phase liquid chromatography with on‐line sample treatment for the simultaneous separation of excreted xenobiotics and endogenous metabolites in urine

In the present work we describe a two‐dimensional liquid chromatographic system (2D‐LC) with detection by mass spectrometry (MS) for the simultaneous separation of endogenous metabolites of clinical interest and excreted xenobiotics deriving from exposure to toxic compounds. The 2D‐LC system involves two orthogonal chromatographic modes, hydrophilic interaction liquid chromatography (HILIC) to separate polar endogenous metabolites and reversed‐phase (RP) chromatography to separate excreted xenobiotics of low and intermediate polarity. Additionally, the present proposal has the novelty of incorporating an on‐line sample treatment based on the use of restricted access materials (RAMs), which permits the direct injection of urine samples into the system. The work is focused on the instrumental coupling, studying all possible options and attempting to circumvent the problems of solvent incompatibility between the RAM device and the two chromatographic columns, HILIC and RP. The instrumental configuration developed, RAM‐HILIC‐RPLC‐MS/MS, allows the simultaneous assessment of urinary metabolites of clinical interest and excreted compounds derived from exposure to toxic agents with minimal sample manipulation. Thus, it may be of interest in areas such as occupational and environmental toxicology in order to explore the possible relationship between the two types of compounds. Copyright © 2015 John Wiley & Sons, Ltd.     

A rational approximation and its applications to nonlinear partial differential equations on the whole line

An orthogonal system of rational functions is discussed. Some inverse inequalities, imbedding inequalities and approximation results are obtained. Two model problems are considered. The stabilities and convergences of proposed rational spectral schemes and rational pseudospectral schemes are proved. The techniques used in this paper are also applicable to other problems on the whole line. Numerical results show the efficiency of this approach.     

用Java实现网上结构图实验仿真

基于线性系统仿真的连接矩阵方法，用Java语言开发面向结构图的实验仿真程序，以Applet小应用程序的形式插入网页中运行，实现了信号与系统网上实验教学中的结构图实验仿真。经试用，程序在浏览器中运行正常，可以完成一般线性系统仿真，与以MATLAB，LABView等程序开发的实验仿真程序相比，该程序运行环境简单，几乎所有常用的Web浏览器都支持Java运行，不需另行安装相应组件。对于线性系统结构图，实现了所见即所得的图形化编程环境，具有较好的人机交互性。     

Clifford分析中无界域上正则函数的边值问题

在引入修正Cauchy核的基础上,讨论了无界域上正则函数的带共轭值的边值问题：a(t)Φ (t) b(t)Φ (t) c(t)Φ-(t) d(t)Φ=g(t)．首先给出了无界域上正则函数的Plemelj公式,然后利用积分方程方法和压缩不动点原理证明了问题解的存在唯一性．