Ultrahigh Loading Copper Single Atom Catalyst for Palladium-free Wacker Oxidation

Wacker oxidation is an industry-adopted process to transform olefins into value-added epoxides and carbonyls. However, traditional Wacker oxidation involves the use of homogeneous palladium and copper catalysts for the olefin addition and reductive elimination. Here, we demonstrated an ultrahigh loading Cu single atom catalyst(14% Cu, mass fraction) for the palladium-free Wacker oxidation of 4-vinylanisole into the corresponding ketone with N-methylhydroxylamine hydrochloride as an additive under mild conditions. Mechanistic studies by ¹⁸O and deuterium isotope labelling revealed a hydrogen shift mechanism in this palladium-free process using N-methylhydroxylamine hydrochloride as the oxygen source. The reaction scope can be further extended to Kucherov oxidation. Our study paves the way to replace noble metal catalysts in the traditional homogeneous processes with single atom catalysts.     

An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

Ceramic Films via Organometallic Complex as Single Source Precursor

Fe2(CO)6(μ-S2) was used as a single source precursor in attempt to produce FeS film via MOCVD. Pyrolysis of Fe2(CO)6(μ-S2) at temperature below 500℃ produced Fe1-xS or Fe7S8 powder as indicated by its powder X-ray spectra. At 750 ℃, polycrystalline FeS powder was obtained. In film deposition, polycrystalline Fe1-xS or Fe7Ss films were obtained on Si(100) and Ag/Si(100) substrates below 500 ℃. SEM micrographs showed the film on Si(100) substrate containing whisker like grains. However, pillar like grains were obtained on Ag/Si(100) substrate.Deposition rates are also different for different substrates as evaluated by the thickness of the films, which were obtained by SEM micrographs of the cross section of the films. At 750℃, similar polycrystalline Fe1-xS or Fe7S8 film was obtained.     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Some new classes of stochastic order relations among arithmetic random variables, with applications in actuarial sciences

Recently, Fishbum and Lavalle (1995) and Lefèvre and Utev (1996) have considered some stochastic order relations specific for arithmetic random variables. The present work is concerned with these orderings, together with two other classes of stochastic order relations closely related. First, attention is paid to characterizations and various properties of all these orderings. Then, sufficient conditions of crossing-type for the two new classes of orderings are derived and extrema among discrete random variables are deduced. This is applied in actuarial sciences to obtain new bounds for the classical single life premiums as well as for the probability of ruin in the compound binomial risk model.     

Isotone relations revisited

We propose a new approach towards proving that the fixed point property for ordered sets is preserved by products. This approach uses a characterization of fixed points in products via isotone relations. First explorations of classes of isotone relations are presented. These first explorations give us hope that this approach could lead to advances on the Product Problem.     

Banach-Saks property in Marcinkiewicz spaces

We catalogue all Marcinkiewicz function and sequence spaces with the Banach-Saks property and present necessary and sufficient conditions for a wide subclass of spaces to possess the p-Banach-Saks property, 1<p<∞. We apply our results to several open problems.     

用紧耦合方法研究C4+和O6+与He原子碰撞

用双中心原子轨道紧耦合方法计算了C4+-He以及O6+-He碰撞的单俘获总截面,入射离子的能量范围为10～100keV/amu,所得计算结果在实验误差范围内与实验值很好符合.对满壳层入射离子,研究了单俘获截面随入射离子电荷态的变化,并讨论了原子轨道展开波函数数目对计算结果的影响.p     

Ⅰ类超晶格势阱中能级分布及电子跃迁规律研究

在研究大量实验曲线的基础上,指出势阱所有能级均有一定的宽度,电子或空穴在各能级中出现的概率符合正态分布,从理论上分析了I类超晶格和双势垒单势阱的发光光谱与吸收光谱·解释了GaAs/Ga1-xAlxAs多量子阱和超晶格吸收光谱吸收边及量子阱变窄时各吸收峰的“蓝移现象”及GaAs/Ga1-xAlxAs双势垒单量子阱样品的电流—电压特性曲线及电导—电压特性曲线的特征和出现的“负阻效应”·     

单链表在离子发动机光学系统粒子模拟中的应用

 目前离子发动机光学系统数值模拟大多采用PIC方法，由于该方法需要跟踪单个粒子的运动，因此需要存储每个粒子的位置信息与运动信息。传统的粒子模拟程序中，保存粒子信息大多采用数组的方式，但是采用这种方式存在弊端，例如对粒子总数变化的自适应不好。基于此开发了一种使用链式存储结构的粒子模拟程序，该程序使用带头节点的单向链表存储粒子信息。使用基于链式存储结构的PIC方法对离子发动机光学系统进行了粒子模拟，验证了链式粒子信息存储方法在粒子模拟中的可用性。模拟表明：（1）在粒子模拟中采用链式存储结构存储粒子信息，无需预先指定最大粒子总数，程序可自适应粒子总数的变化，因此无需进行试算，节省了计算时间；（2）在粒子模拟中采用链式存储结构，由于不存在内存资源的浪费，因而可显著提高程序的存储效率与计算效率。