Alloyed Tetranuclear Metal Chains of Pd4−nPtn (n=0–3) Scaffolded by a New Linear Tetraphosphine Containing a PNP Bridge

A new linear tetraphosphine containing a PNP phosphazane bridge, rac-bis[(diphenylphosphinomethyl)phenylphosphino]phenylamine (rac-dpmppan), was synthesized and utilized to support a series of Pd/Pt mixed metal tetranuclear chains, [Pd_4−nPt_n(μ-rac-dpmppan)₂(XylNC)₂](PF₆)₂ (XylNC=xylyl isocyanide; n=0: Pd₄ ( 1 ), 1: PtPd₃ ( 2 ), 2: PtPd₂Pt ( 3 ), 2: Pt₂Pd₂ ( 4 ), 3: Pt₂PdPt ( 5 )), in which the number and positions of additional Pt atoms were successfully controlled depending on the respective synthetic procedures using transformations from 1 to 3 through 2 and from 4 to 5 by redox-coupled exchange reactions. The ³¹P{¹H} NMR and ESI mass spectra and X-ray diffraction analyses revealed almost identical tetranuclear structures, with slight contraction of metal-metal bonds according to incorporation of Pt atoms. The electronic absorption spectra of 1 – 5 exhibited characteristic bands at 635–510 nm with an energy propensity depending on the number and positions of Pt centres, which were assigned to HOMO (dσ*σσ*) to LUMO (dσ*σ*σ*) transition by theoretical calculations. The present results demonstrated that the electronic structures of Pd/Pt mixed-metal tetranuclear complexes are finely tuned as orbital-overlapping alloyed metal chains by atomically precise Pt incorporation in the Pd₄ chain.     

Degradation of p-nitrophenol (PNP) in aqueous solution by mFe/Cu-air-PS system

In this study, batch experiments were conducted to investigate the performance of microscale Fe/Cu bimetallic particles-air-persulfate system (mFe/Cu-air-PS) for p-nitrophenol (PNP) treatment in aqueous solution. The results indicate that toxic and refractory PNP in aqueous solution could be decomposed effectively and transformed into lower toxicity intermediates.     

MAO‐free and extremely active catalytic system for ethylene tetramerization

The original Sasol catalytic system for ethylene tetramerization is composed of a Cr source, a PNP ligand, and MAO (methylaluminoxane). The use of expensive MAO in excess has been a critical concern in commercial operation. Many efforts have been made to replace MAO with non‐coordinating anions (e.g., [B(C₆F₅)₄]^?); however, most of such attempts were unsuccessful. Herein, an extremely active catalytic system that avoids the use of MAO is presented. The successive addition of two equivalent [H(OEt₂)₂]⁺[B(C₆F₅)₄]^? and one equivalent CrCl₃(THF)₃ to (acac)AlEt₂ and subsequent treatment with a PNP ligand [CH₃(CH₂)₁₆]₂C(H)N(PPh₂)₂ ( 1 ) yielded a complex presumably formulated as [ 1 ‐CrAl (acac)Cl₃(THF)]²⁺[B(C₆F₅)₄]^?₂, which exhibited high activity when combined with iBu₃Al (1120 kg/g‐Cr/h; ~4 times that of the original Sasol system composed of Cr (acac)₃, iPrN(PPh₂)₂, and MAO). Via the introduction of bulky trialkylsilyl substituents such as –SiMe₃, –Si(nBu)₃, or –SiMe₂(CH₂)₇CH₃ at the para‐position of phenyl groups in 1 (i.e., by using [CH₃(CH₂)₁₆]₂C(H)N[P(C₆H₄‐p‐SiR₃)₂]₂ instead of 1 ), the activities were dramatically improved, i.e., tripled (2960–3340 kg/g‐Cr/h; more than 10 times that of the original Sasol system). The generation of significantly less PE (<0.2 wt%) even at a high temperature is another advantage achieved by the introduction of bulky trialkylsilyl substituents. NMR studies and DFT calculations suggest that increase of the steric bulkiness on the alkyl‐N and P‐aryl moieties restrict the free rotation around (alkyl)N–P (aryl) bonds, which may cause the generation of more robust active species in higher proportion, leading to extremely high activity along with the generation of a smaller amount of PE.     

液相催化复极性流化床电解槽处理对硝基酚废水

应用液相催化复极性流化床电解槽降解处理对硝基酚废水.溶液中的Fe2+离子与O2在阴极还原生的成H2O2形成了Fenton试剂,实验以对硝基酚为降解底物,考察了槽电压、Fe2+浓度及曝气量对模拟废水对硝基酚及COD去除率的影响.结果显示,在pH=3.0,电压30V,Fe2+浓度500 mg.L-1,曝气量0.4 m3.h-1的条件下,对硝基酚及COD均有较高的去除率.     

超支化铬系催化剂的合成及乙烯齐聚性能研究

以不同端基烷基链长度的1.0G超支化大分子为桥联基,通过对其端基氨基进行催化功能改性,合成了系列具有不同桥联基长度的超支化PNP铬系催化剂。采用红外光谱(IR)、核磁共振氢谱(1H-NMR)、核磁共振磷谱(31P-NMR)、紫外光谱(UV)和质谱(MS)等表征方法证明合成催化剂的结构与理论结构相符。详细考察了溶剂种类、反应温度、Al/Cr摩尔比、反应压力、催化剂用量和催化剂结构对催化剂乙烯齐聚性能的影响。实验结果表明,当以甲苯为溶剂,甲基铝氧烷(MAO)为助催化剂时,超支化PNP铬系催化剂表现出良好的催化乙烯齐聚性能,产物以低碳烯烃为主。最佳条件下,催化活性最高可达到1.69×105g/mol Cr·h,己烯和辛烯的选择性为43.3%以上。相同聚合条件下,其催化活性随着端基烷基链长度的增加而下降。     

超支化铬系催化剂的合成及乙烯齐聚性能研究

以正辛胺和十二胺为原料,分别制备了两种超支化PNP配体,通过引入金属铬活性位点的方法合成了具有不同烷基链长度的超支化PNP铬系催化剂.采用红外光谱(IR)、核磁共振磷谱(~(31)P-NMR)、核磁共振氢谱(~1H-NMR)、紫外光谱(UV)和质谱(MS)等表征方法证明合成催化剂的结构与理论结构预测相符.详细考察了催化剂用量、溶剂种类、反应条件以及配合物结构对乙烯齐聚性能的影响.实验结果显示,超支化PNP铬系催化剂在甲苯作溶剂,甲基铝氧烷(MAO)做助催化剂时表现出良好的催化乙烯齐聚性能,产物主要为低碳烯烃.在最佳条件下,催化活性最高可达到1.69×10~5 g·(mol Cr·h)~(-1),己烯和辛烯的选择性为43.3%以上.相同聚合条件下,其催化活性随着端基烷基链长度的增加而下降.     

A terminal palladium fluoride complex supported by an anionic PNP pincer ligand

A terminal palladium (II) fluoride complex (^FPNP)PdF (where ^FPNP is a an anionic fluoro-substituted diarylamido/bis(phosphine) pincer ligand) has been prepared and characterized spectroscopically and structurally. An X-ray diffraction study revealed an approximately square-planar environment about Pd and a short Pd-F bond distance. (^FPNP)PdF reacted with silanes containing electron-withdrawing groups on Si by exchange of fluoride with one of the substituents on Si. An analysis of the ¹⁹F chemical shifts of both the Pd-bound fluoride and of the fluorines on the backbone of the ^FPNP ligand is provided.     

Zirconium complexes containing a diarylamido diphosphine ligand: Structural preferences controlled by ligand electronics and sterics

This work describes the preparation of [PNP]ZrX₃ ([PNP]⁻ = [N(o-C₆H₄PⁱPr₂)₂]⁻; X = Cl, Me, CH₂SiMe₃) whose structural preference is found to be a function of the electronic and steric nature of the monodentate ligand X⁻. The reaction of ZrCl₄(THF)₂ with [PNP]Li in toluene at room temperature generates [PNP]ZrCl₃ as a red solid in 60% yield. Alkylation of [PNP]ZrCl₃ with three equivalents of Grignard reagents in diethyl ether at −35 °C produces cleanly [PNP]ZrR₃ (R = Me, CH₂SiMe₃) as yellow crystalline materials. An X-ray diffraction study of [PNP]ZrCl₃ showed it to be a chloride-bridged binuclear species {[PNP]ZrCl₂(μ−Cl)}₂ in which both zirconium atoms are 7-coordinate whereas that of [PNP]ZrMe₃ revealed a mononuclear, 6-coordinate core structure. Interestingly, with the incorporation of more sterically demanding alkyls, [PNP]Zr(CH₂SiMe₃)₃ is a 5-coordinate compound wherein the amido phosphine ligand is κ²-N,P bound to zirconium. The solution structures of these molecules were also assessed by variable-temperature NMR spectroscopy.     

一种基于特征点间线段倾角的姿态测量方法

基于目标特征点间线段倾角信息,提出了一种适合于目标远距离成像和相机内参未知条件下解算目标姿态的目标3维姿态测量方法.采用仿真图像对该方法的正确性进行了验证.实验结果:姿态测量误差绝对值均值小于0.6°,且目标成像尺寸为350pixel时,姿态测量误差绝对值小于0.5°.实验表明该算法具有较高解算准确度和较强的收敛性.     

Ion flux through membrane channels--an enhanced algorithm for the Poisson-Nernst-Planck model

A novel algorithmic scheme for numerical solution of the 3D Poisson-Nernst-Planck model is proposed. The algorithmic improvements are universal and independent of the detailed physical model. They include three major steps: an adjustable gradient-based step value, an adjustable relaxation coefficient, and an optimized segmentation of the modeled space. The enhanced algorithm significantly accelerates the speed of computation and reduces the computational demands. The theoretical model was tested on a regular artificial channel and validated on a real protein channel-alpha-hemolysin, proving its efficiency.