Stagnation flow on a cylinder with partial slip--an exact solution of the Navier-Stokes equations

The stagnation slip flow on an axially moving cylinder is studied.The Navier–Stokes and energy equations reduce to nonlinearordinary differential equations under a similarity transform.For large slip, the flow field decays exponentially into potentialflow. The heat transfer can be expressed as an incomplete gammafunction. In general, the heat transfer increases with slip,Prandtl number and Reynolds number.     

有限长FGM圆筒的热/机应力的解析解

利用微分方程的级数求解方法,分析了两端简支的有限长功能梯度圆筒的轴对称稳态热弹性问题,推导出了稳态温度场与应力场的解析解。分析中采用指数函数模型来描述FGM圆筒中材料性能在厚度方向的连续变化,同时忽略温度对材料性能的影响。另外,论文以金属钼和多铝红柱石制成的功能梯度圆筒为例,给出了稳态温度场和应力场的数值结果。     

A generalized Adadorov theory for anisotropic thin-walled beams

This paper presents a generalized Adadorov theory for anisotropic thin—walled beams. The theory takes account of the shear strain of the middle surface, which exerts a significant influence on the anisotropic thin-walled beams. A new approach is established to solve the governing equations, which have the same form for both open and closed section beams. The numerical examples show that the effects of the shear strain cannot be neglected for this class of beams.This work was part of research project supported by the National Natural Science Foundation of China     

Effect of nanotube functionalization on the properties of single‐walled carbon nanotube/polyurethane composites

A commercially available aliphatic thermoplastic polyurethane formulated with a methylene bis(cyclohexyl) diisocyanate hard segment and a poly(tetramethylene oxide) soft segment and chain‐extended with 1,4‐butanediol was dissolved in dimethylformamide and mixed with dispersed single‐walled carbon nanotubes. The properties of composites made with unfunctionalized nanotubes were compared with the properties of composites made with nanotubes functionalized to contain hydroxyl groups. Functionalization almost eliminated the conductivity of the tubes according to the conductivity of the composites above the percolation threshold. In most cases, functionalized and unfunctionalized tubes yielded composites with statistically identical mechanical properties. However, composites made with functionalized tubes did have a slightly higher modulus in the rubbery plateau region at higher nanotube fractions. Small‐angle X‐ray scattering patterns indicated that the dispersion reached a plateau in the unfunctionalized composites that was consistent with the plateau in the rubbery plateau region. The room‐temperature modulus and tensile strength increase was proportionally higher than almost all increases seen previously in thermoplastic polyurethanes; however, the increase was still an order of magnitude below what has been reported for the best nanotube–polymer systems. Nanotube addition increased the hard‐segment glass transition temperature slightly, whereas the soft‐segment glass transition was so diffuse that no conclusions could be drawn. Unfunctionalized tubes suppressed the crystallization of the hard segment; whereas functionalized tubes had no effect. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 490–501, 2007     

Thermoelastoplastic deformation of a thick-walled cylinder with a radial crack

The thermoelastoplastic fracture mechanics problem of a thick-walled cylinder subjected to internal pressure and a nonuniform temperature field is solved by the method of elastic solutions combined with the finite-element method. The correctness of the solution is provided by using the Barenblatt crack model, in which the stress and strain fields are regular. The elastoplastic problem of a cracked cylinder subjected to internal pressure and a nonuniform temperature field are solved. The calculation results are compared with available data. __________ Translated from Prikladnaya Mekhanika i Tekhnicheskaya Fizika, Vol. 49, No. 3, pp. 173–183, May–June, 2008.     

绕圆柱体自由表面磁流体流动和传热的研究

本文对在不同雷诺数下,绕圆柱体的磁流体自由表面流动及传热进行了模拟,分析了磁场对绕流圆柱尾迹和涡分离的影响,获得了两种雷诺数下的电磁力密度、流场和温度场分布。结果表明,磁场不仅影响了流动的形态,而且对湍流有抑制作用,降低了自由表面的更新机制,从而减少了传热能力;在相同的Hartmann数下,相比低雷诺数下的流动换热情况,高雷诺数下的湍流不能被完全抑制,自由表面与尾迹的相互作用也较强,因而自由表面换热也较强。     

Theory of oscillatory experiments with a coaxial cylinder viscometer

Equations are derived for the coaxial cylinder system in the combined oscillatory and steady-state shear mode. The limitations of the use of the various equations are presented. If the usual linear equations are used, the main limitation, in the case of oscillatory shear only, is that the frequency of measurement should be below 0.016 | ^*|/(r ₂ –r ₁ )². Here | ^*| is the modulus of the complex viscosity, is the density of the liquid andr ₁ andr ₂ are the radii of the cylinders. Furthermore it is shown that there is a small error in the numerical factor of the usually applied equations. The calculations are set up in such a way that extension to higher harmonics follows in a natural way. An experimental example illustrates the use of the derived equations.     

平行双铂丝微电极用于铁氰化钾电流滴定法测定抗坏血酸的研究

平行双柱微电极是一种基于可逆氧化还原物质在电极间反馈扩散使得信噪比进一步增大的新型微电极,作者首次将这种电极应用于电流滴定分析中。结果显示,电极间距很小时,终点突跃变敏锐,使灵敏度进一步提高。该方法不需搅拌溶液,单次测量样品量只需约3μ1,是一种有实用价值的新方法。     

Cyclic Voltammograms of Ferrocene on Multi‐Walled Carbon Nanotubes (MWCNTs)‐Modified Edge Plane Pyrolytic Graphite (EPPG) Electrode in Room Temperature Ionic Liquids (RTILs) of 1‐Ethyl‐3‐Methylimidazolium Tetrafluoroborate (EMIBF4)

In this work, the electrochemical behavior of ferrocene (Fc) was investigated by cyclic voltammetry (CV) in room temperature ionic liquids (RTILs) of 1‐ethyl‐3‐methylimidazolium tetrafluoroborate (EMIBF₄) on glass carbon (GC), edge plane pyrolytic graphite (EPPG) and multi‐walled carbon nanotube (MWCNTs)‐modified EPPG electrodes, respectively. The results demonstrated that on GC electrode, pairs of well‐defined reversible peaks were observed, while for the electrode of EPPG, the peak potential separation (ΔE_p) is obviously larger than the theoretical value of 59 mV, hinting that the electrode of EPPG is distinguished from the commonly used electrode, consistent with the previous proposition that EPPG has many “defects”. To obtain an improved electrochemical response, multi‐walled carbon nanotubes (MWCNTs) were modified on the electrode of EPPG; the increased peak current and promoted peak potential separation not only proved the existence of “defects” in MWCNTs, but also supported that “creating active points” on an electrode is the main contribution of MWCNTs. Initiating the electrochemical research of Fc on the MWCNTs‐modified EPPG electrode in RTILs and verifying the presence of “defects” on both EPPG and MWCNTs using cyclic voltammograms (CVs) of Fc obtained in RTILs of EMIBF₄, is the main contribution of this preliminary work.     

Finite deformation swelling of a temperature-sensitive hydrogel cylinder under combined extension-torsion

The swelling behavior of a temperature-sensitive poly-N-isopropylacrylamide(PNIPAM) hydrogel circular cylinder is studied subjected to combined extension-torsion and varied temperature. In this regard, a semi-analytical solution is proposed for general combined loading. A finite element(FE) analysis is conducted, subjecting a hydrogel cylinder to the combined extension-torsion and the varied temperature to evaluate the validity and accuracy of the solution. A user-defined UHYPER subroutine is de...