一种新的永久周期磁铁聚焦的高功率宽带放大器

 提出了一种新的高功率宽带放大器，它由速调管和自由电子脉塞组成，用永久周期磁铁聚焦。研究了这种器件的电子束聚焦、群聚和辐射。在速调管提供一阶调制系数为30%，波导管的半径1.51cm，摇摆器的磁场振幅0.16T，周期7.92cm，电子束的电压490kV，电流50A和半径0.368cm的条件下，预估这种器件的辐射波频率为11.4GHz，输出辐射功率为18MW，输出辐射带宽为44%。     

Ultra <Emphasis Type="Italic">LI</Emphasis>-ideals in lattice implication algebras and <Emphasis Type="Italic">MTL</Emphasis>-algebras

A mistake concerning the ultra LI-ideal of a lattice implication algebra is pointed out, and some new sufficient and necessary conditions for an LI-ideal to be an ultra LI-ideal are given. Moreover, the notion of an LI-ideal is extended to MTL-algebras, the notions of a (prime, ultra, obstinate, Boolean) LI-ideal and an ILI-ideal of an MTL-algebra are introduced, some important examples are given, and the following notions are proved to be equivalent in MTL-algebra: (1) prime proper LI-ideal and Boolean LI-ideal, (2) prime proper LI-ideal and ILI-ideal, (3) proper obstinate LI-ideal, (4) ultra LI-ideal. This work was supported by the Zhejiang Provincial Natural Science Foundation of China (Grant No. Y605389) and K. C. Wong Magna Fund in Ningbo University.     

0.18μm CMOS工艺栅极氧化膜可靠性的衬底和工艺依存性

用斜坡电压法(Voltage Ramp, V-ramp)评价了0.18μm双栅极 CMOS工艺栅极氧化膜击穿电量(Charge to Breakdown, Q_bd)和击穿电压(Voltage to Breakdown, V_bd). 研究结果表明，低压器件(1.8V)的栅极氧化膜(薄氧)p型衬底MOS电容和N型衬底电容的击穿电量值相差较小，而高压器件(3.3V)栅极氧化膜(厚氧)p衬底MOS电容和n衬底MOS电容的击穿电量值相差较大，击穿电压测试值也发现与击穿电量 关键词： 薄氧 可靠性 击穿电压 击穿电量     

Working group report: Neutrino and astroparticle physics

This is the report of neutrino and astroparticle physics working group at WHEPP-7. Discussions and work on CP violation in long baseline neutrino experiments, ultra high energy neutrinos, supernova neutrinos and water Cerenkov detectors are discussed.     

Towards advanced circuit board materials: adhesion of copper foil to ultra‐high molecular weight polyethylene composite

Polyethylene based composites are attractive materials for advanced circuit board applications because of their unique combination of properties: low dielectric constant and loss factor, light weight, high flexural modulus and low thermal expansion coefficient controlled in all spatial directions. This investigation describes a process to consolidate chopped fibers of ultra‐high molecular weight polyethylene concurrently with its bonding to a copper foil. Bonding is affected by a thin sheet of low‐density polyethylene, incorporating a crosslinking agent with a concentration gradient across the sheets thickness. In this single step process, the composite material is formed and bonded to the metal foil, achieving good adhesion without the use of extraneous glue. Copyright © 2002 John Wiley & Sons, Ltd.     

QuEChERS/超高效液相色谱-串联质谱法同时测定水产品中四溴双酚A与六溴环十二烷

建立了同时测定水产品中四溴双酚A(TBBPA)和六溴环十二烷(HBCD)的超高效液相色谱-串联质谱方法。样品前处理采用QuEChERS方法,均质生物样品用水分散后加乙腈提取,经C_(18)分散固相萃取净化。采用CORTECS~?C_(18)色谱柱(4.6 mm×100 mm×2.7μm)分离,以甲醇-水为流动相进行梯度洗脱,流速为0.7 mL/min。采用电喷雾离子源,在负离子模式下以多反应监测(MRM)方式检测。结果表明,TBBPA和3种HBCD单体在0.5～500μg/L范围内线性良好,相关系数(r)大于0.998,检出限(LOD,S/N=3)和定量下限(LOQ,S/N=10)分别为0.04～0.16μg/kg和0.12～0.55μg/kg。在5、20、50μg/kg加标水平下的平均回收率为74.0%～121%,相对标准偏差(RSD)为0.20%～23%。该方法操作简单、快速、重现性好,适用于水产品中TBBPA和HBCD的快速检测。     

水合醋酸铈直接热分解制备超细氧化铈及其抛光性能

Ultra fine ceria was prepared by calcining hydrate cerium acetate. The effects of pyrolysis temperature on the particle size, morphology, specific surface area and loose packing density of ceria were investigated, and the removal rate of optical glasses polishing by ceria was determined. The results show that with the increase of pyrolysis temperature, the loose deposit density and crystallinity increases and the specific surface area decreases, however, the particle size decreases firstly and then increases, the minimum medium particle size D₅₀ is 0.47 μm at pyrolysis temperature of 1 000 ℃. The SEM images of ceria prepared by the decomposition at 800 ℃ or at 1 100 ℃ show porous powders or quasi-sphere small particles with loosely agglomeration, respectively. It was found that the removal rate varied with pyrolysis temperature in preparation of ceria and the property of glass polished. The removal rate for three kinds of glasses was in the order of ZF7> F1> K9, and the maximum value appeared at around 1 000 ℃ for ZF7 and F1, and at around 1 100 ℃ for K9.     

Fermentation characteristics and the dynamic trend of chemical components during fermentation of Massa Medicata Fermentata

As a representative of traditionally fermented Chinese medicine, Massa Medicata Fermentata (MMF) shows the functions of invigorating the spleen and stomach and promoting digestion, which plays an important role in the treatment of gastrointestinal diseases. The fermentation mechanism and the key factors that affect the quality of MMF have not been revealed yet, which has become an urgent issue that limits its clinical application. This article aims to systematically and comprehensively reveal the transformation of physical properties and the dynamic trend of chemical components including substrate components, volatile components, and lactic acid as anaerobic fermentation product during MMF fermentation. Along with obvious hyphae growth observed for MMF, the weight of MMF decreased, and the moisture and temperature increased. Through the quantified 14 components from substrate, ferulic acid increased from 45.53 ± 6.94 to 141.89 ± 78.40 μg/g, while glycosides and phenolic acids declined except caffeic acid. Also, within the 66 volatile components analyzed, alcohols and acids increased, while aldehydes and ketones decreased. Lactic acid was not detected in the fermentation substrate, but an apparent increase in lactic acid content was observed along with the increased fermentation days, resulting in 2.54 ± 0.15 mg/g on day 8. Based on the tested components, the fermentation process of MMF was discriminated into three distinct stages by principal component analysis, and an optimal fermentation time of four days was proposed. The results of this study will be of great significance to clarify the characteristics of fermentation and conduce to improving quality standards of MMF.     

溶剂萃取法制备Co(PO_3)_2超细微粉

本文用溶剂萃取法成功地制备了偏磷酸钴超细微粉并通过ＸＲＤ，ＩＲ，ＴＧ，ＤＴＡ，ＴＥＭ等实验对超细微粉的组成、结构进行了表征。     

Trace Detection of Mercury(II) Using Gold Ultra‐Microelectrode Arrays

The electroanalytical detection of trace mercury(II) at gold ultra‐microelectrode arrays is reported. The arrays consist of 256 gold microelectrodes of 5 μm in diameter in cubic arrangements which are separated from their nearest neighbor by 100 μm. The array was utilized in nitric acid using linear sweep voltammetry where a linear response from mercury additions over the range 10 μg L^?1?200 μg L^?1 (10^?8?10^?6 M) was observed with a sensitivity and detection limit of 0.11 nC/μg L^?1 and 3.2 μg L^?1 (16 nM) respectively from using a deposition time of 30 s at ?0.2 V (vs. SCE). This methodology was explored in 0.1 and 1 M chloride media over the mercury range 10 μg L^?1?200 μg L^?1 (5×10^?8?10^?6 M) where similar sensitivities of 0.087 nC/μg L^?1 and 0.078 nC/μg L^?1 were observed with an identical detection limit. The protocol is demonstrated to be useful for the determination of mercury for analysis of environmental water samples.