Collective Tunnelling of Strongly Interacting Cold Atoms in a Double-Well Potential

It is known that under resonance conditions, a group of strongly interacting bosonic atoms, trapped in a double-well potential, mimics a single particle, performing Rabi oscillations between the wells. By implication, all atoms need to tunnel at roughly the same time, even though the Bose–Hubbard Hamiltonian accounts only for one-atom-at-a-time transfers. The mechanism of this collective behavior is analyzed, the Rabi frequencies in the process are evaluated, and the limitation of this simple picture is discussed. In particular, it is shown that the small rapid oscillations superimposed on the slow Rabi cycle result from splitting the transferred cluster at the sudden onset of tunnelling, and disappear if tunnelling is turned on gradually.     

Invariant discrete flows

In this paper, we investigate the evolution of joint invariants under invariant geometric flows using the theory of equivariant moving frames and the induced invariant discrete variational complex. For certain arc length preserving planar curve flows invariant under the special Euclidean group , the special linear group , and the semidirect group , we find that the induced evolution of the discrete curvature satisfies the differential‐difference mKdV, KdV, and Burgers' equations, respectively. These three equations are completely integrable, and we show that a recursion operator can be constructed by precomposing the characteristic operator of the curvature by a certain invariant difference operator. Finally, we derive the constraint for the integrability of the discrete curvature evolution to lift to the evolution of the discrete curve itself.     

Momentum transport and torque scaling in Taylor-Couette flow from an analogy with turbulent convection

We generalize an analogy between rotating and stratified shear flows. This analogy is summarized in Table 1. We use this analogy in the unstable case (centrifugally unstable flow vs. convection) to compute the torque in Taylor-Couette configuration, as a function of the Reynolds number. At low Reynolds numbers, when most of the dissipation comes from the mean flow, we predict that the non-dimensional torque G = T/ν² L, where L is the cylinder length, scales with Reynolds number R and gap width η, G = 1.46η^3/2(1 - η)^-7/4 R ^3/2. At larger Reynolds number, velocity fluctuations become non-negligible in the dissipation. In these regimes, there is no exact power law dependence the torque versus Reynolds. Instead, we obtain logarithmic corrections to the classical ultra-hard (exponent 2) regimes: G = 0.50 . These predictions are found to be in excellent agreement with avail-able experimental data. Predictions for scaling of velocity fluctuations are also provided. Received 7 June 2001 and Received in final form 7 December 2001     

Lower Bounds from State Space Relaxations for Concave Cost Network Flow Problems

In this paper we obtain Lower Bounds (LBs) to concave cost network flow problems. The LBs are derived from state space relaxations of a dynamic programming formulation, which involve the use of non-injective mapping functions guaranteing a reduction on the cardinality of the state space. The general state space relaxation procedure is extended to address problems involving transitions that go across several stages, as is the case of network flow problems. Applications for these LBs include: estimation of the quality of heuristic solutions; local search methods that use information of the LB solution structure to find initial solutions to restart the search (Fontes et al., 2003, Networks, 41, 221–228); and branch-and-bound (BB) methods having as a bounding procedure a modified version of the LB algorithm developed here, (see Fontes et al., 2005a). These LBs are iteratively improved by penalizing, in a Lagrangian fashion, customers not exactly satisfied or by performing state space modifications. Both the penalties and the state space are updated by using the subgradient method. Additional constraints are developed to improve further the LBs by reducing the searchable space. The computational results provided show that very good bounds can be obtained for concave cost network flow problems, particularly for fixed-charge problems.     

Experimental investigation of time-dependent cavitation in an oscillatory squeeze film

The occurrence of time-dependent cavitation and tensile stress in an oscillatory oil squeeze film were investigated experimentally. The test apparatus was a simple thrust bearing consisting of two parallel circular plates separated by a thin viscous oil film. During the test, one plate was at rest while the other (transparent) oscillated in a direction normal to its surface. This test configuration was chosen to avoid the rotational motion and complicated geometry of a squeeze film journal bearing. The frequency of oscillation was in the range of 5 to 50 Hz and was controlled by an electro-magnetic exciter. The process of cavity formation and its subsequent development was recorded by a high-speed video camera. Concomitant pressure in the oil film was measured both within and without the cavitation region. It was found that both tensile stress and cavities existed in a squeeze film under certain working conditions.     

On the application of slip boundary condition on curved boundaries

Hydrodynamic simulations of sloshing phenomena often involve the application of slip boundary condition at the wetted surfaces. If these surfaces are curved, the ambiguous nature of the normal vector in the discretized problem can interfere with the application of such a boundary condition. Even the use of consistent normal vectors, preferred from the point of view of conservation, does not assure good approximation of the continuum slip condition in the discrete problem, and non‐physical recirculating flow fields may be observed. As a remedy, we consider the Navier slip condition, and more successfully, the so‐called BC‐free boundary condition. Copyright © 2004 John Wiley & Sons, Ltd.     

Assessment of two‐equation turbulence modelling for high Reynolds number hydrofoil flows

This paper presents an evaluation of the capability of turbulence models available in the commercial CFD code FLUENT 6.0 for their application to hydrofoil turbulent boundary layer separation flow at high Reynolds numbers. Four widely applied two‐equation RANS turbulence models were assessed through comparison with experimental data at Reynolds numbers of 8.284×106 and 1.657×107. They were the standard k–εmodel, the realizable k–εmodel, the standard k–ωmodel and the shear‐stress‐transport (SST) k–ωmodel. It has found that the realizable k–εturbulence model used with enhanced wall functions and near‐wall modelling techniques, consistently provides superior performance in predicting the flow characteristics around the hydrofoil. Copyright © 2004 John Wiley & Sons, Ltd.     

Free boundary viscous flows at micro and mesolevel during liquid composites moulding process

Numerical simulation aspects, related to low Reynolds number free boundary viscous flows at micro and mesolevel during the resin impregnation stage of the liquid composite moulding process (LCM), are presented in this article. A free boundary program (FBP), developed by the authors, is used to track the movement of the resin front accurately by accounting for the surface tension effects at the boundary. Issues related to the global and local mass conservation (GMC and LMC) are identified and discussed. Unsuitable conditions for LMC and consequently GMC are uncovered at low capillary numbers, and hence a strategy for the numerical simulation of such flows is suggested. FBP encompasses a set of subroutines that are linked to modules in ANSYS. FBP can capture the void formation dynamics based on the analysis developed. We present resin impregnation dynamics in two dimensions. Extension to three dimensions is a subject for further research. Several examples are shown and efficiency of different stabilization techniques are compared. Copyright © 2004 John Wiley & Sons, Ltd.     

On the Existence of Solutions to Vector Quasivariational Inequalities and Quasicomplementarity Problems with Applications Break to Traffic Network Equilibria

For vector quasivariational inequalities involving multifunctions in topological vector spaces, an existence result is obtained without a monotonicity assumption and with a convergence assumption weaker than semicontinuity. A new type of quasivariational inequality is proposed. Applications to quasicomplementarity problems and traffic network equilibria are considered. In particular, definitions of weak and strong Wardrop equilibria are introduced for the case of multivalued cost functions.