Purcell Effect and Nonlinear Behavior of the Emission in a Periodic Structure Composed of InAs Monolayers Embedded in a GaAs Matrix

Enhancement of spontaneous emission in a resonant Bragg quantum well (QW) structure with 60 periods of triple InAs monolayers embedded in a GaAs matrix is studied experimentally and theoretically. From measurements of the time‐resolved photoluminescence, besides the QW exciton at 1.47 eV, a specific super‐radiant (SR) emission demonstrating nonlinear properties is found. The SR mode shows a near‐quadratic dependence of intensity on excitation power, while its energy position follows the Bragg condition. It is revealed that the SR mode shows a peculiar non‐monotonic dependence of intensity on direction, with a maximum observed at approximately 40°. The enhancement in the SR emission at a specific direction is correlated well with suggested theoretical consideration of the modal Purcell factor for periodic quantum well structures.     

Approaches to improving critical current density of YBCO superconducting thick films deposited by electrophoresis

The irreversibility field (Hirr) of Y-based superconductor is much higher than that of Bi-based superconductor. Y-based superconductor is capable of maintaining stable electrical currents in high magnetic field and electric field, so it is a better suited mate-rial for electric-current applications. Commonly, the Y-based tapes comprise a YBCO thick film deposited on a flexible substrate, typically with an intermediate buffer layer, and an overcoat of noble metal. In this process, the interm…     

稀薄气体二维外部柱体绕流特性研究

本文采用直接模拟蒙特卡罗方法对稀薄气体二维外部柱体绕流问题进行了数值模拟。结果表明:外部绕流问题,在特定情况下会产生激波,激波的产生,不仅与气体的稀薄程度有关,还与来流马赫数有关。而气流与壁面之间的换热,随来流马赫数增加而增加,随气体稀薄程度增加而减小。     

Stagnation flow on a cylinder with partial slip--an exact solution of the Navier-Stokes equations

The stagnation slip flow on an axially moving cylinder is studied.The Navier–Stokes and energy equations reduce to nonlinearordinary differential equations under a similarity transform.For large slip, the flow field decays exponentially into potentialflow. The heat transfer can be expressed as an incomplete gammafunction. In general, the heat transfer increases with slip,Prandtl number and Reynolds number.     

有限长FGM圆筒的热/机应力的解析解

利用微分方程的级数求解方法,分析了两端简支的有限长功能梯度圆筒的轴对称稳态热弹性问题,推导出了稳态温度场与应力场的解析解。分析中采用指数函数模型来描述FGM圆筒中材料性能在厚度方向的连续变化,同时忽略温度对材料性能的影响。另外,论文以金属钼和多铝红柱石制成的功能梯度圆筒为例,给出了稳态温度场和应力场的数值结果。     

A generalized Adadorov theory for anisotropic thin-walled beams

This paper presents a generalized Adadorov theory for anisotropic thin—walled beams. The theory takes account of the shear strain of the middle surface, which exerts a significant influence on the anisotropic thin-walled beams. A new approach is established to solve the governing equations, which have the same form for both open and closed section beams. The numerical examples show that the effects of the shear strain cannot be neglected for this class of beams.This work was part of research project supported by the National Natural Science Foundation of China     

Effect of nanotube functionalization on the properties of single‐walled carbon nanotube/polyurethane composites

A commercially available aliphatic thermoplastic polyurethane formulated with a methylene bis(cyclohexyl) diisocyanate hard segment and a poly(tetramethylene oxide) soft segment and chain‐extended with 1,4‐butanediol was dissolved in dimethylformamide and mixed with dispersed single‐walled carbon nanotubes. The properties of composites made with unfunctionalized nanotubes were compared with the properties of composites made with nanotubes functionalized to contain hydroxyl groups. Functionalization almost eliminated the conductivity of the tubes according to the conductivity of the composites above the percolation threshold. In most cases, functionalized and unfunctionalized tubes yielded composites with statistically identical mechanical properties. However, composites made with functionalized tubes did have a slightly higher modulus in the rubbery plateau region at higher nanotube fractions. Small‐angle X‐ray scattering patterns indicated that the dispersion reached a plateau in the unfunctionalized composites that was consistent with the plateau in the rubbery plateau region. The room‐temperature modulus and tensile strength increase was proportionally higher than almost all increases seen previously in thermoplastic polyurethanes; however, the increase was still an order of magnitude below what has been reported for the best nanotube–polymer systems. Nanotube addition increased the hard‐segment glass transition temperature slightly, whereas the soft‐segment glass transition was so diffuse that no conclusions could be drawn. Unfunctionalized tubes suppressed the crystallization of the hard segment; whereas functionalized tubes had no effect. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 490–501, 2007     

用电泳技术制备YBCO高温超导厚膜

介绍了电泳技术制备YBCO高温超导厚膜的实验方法和YBCO高温超导厚膜的电学性质测量 ,讨论了在学生小型科研实验或设计实验中开展此实验的学时安排、注意事项和实验内容的扩展 .     

辽河冷家油田特稠油降粘剂LJVR-1及其性能评价

采用荧光法测定了辽河冷家油田冷47-556井特稠油乳化HLB值,然后以混合型表面活性剂、非离子型表面活性剂为主剂,快速渗透剂为辅剂按一定比例制备了水基降粘剂LJVR-1.实验结果表明,该降粘剂具有良好的乳化降粘性能,开采后易于破乳脱水,是一种较为理想的特稠油降粘剂.     

Thermoelastoplastic deformation of a thick-walled cylinder with a radial crack

The thermoelastoplastic fracture mechanics problem of a thick-walled cylinder subjected to internal pressure and a nonuniform temperature field is solved by the method of elastic solutions combined with the finite-element method. The correctness of the solution is provided by using the Barenblatt crack model, in which the stress and strain fields are regular. The elastoplastic problem of a cracked cylinder subjected to internal pressure and a nonuniform temperature field are solved. The calculation results are compared with available data. __________ Translated from Prikladnaya Mekhanika i Tekhnicheskaya Fizika, Vol. 49, No. 3, pp. 173–183, May–June, 2008.