3D‐morphology reconstruction of nanoscale phase‐separation in polymer memory blends

In many organic electronic devices functionality is achieved by blending two or more materials, typically polymers or molecules, with distinctly different optical or electrical properties in a single film. The local scale morphology of such blends is vital for the device performance. Here, a simple approach to study the full 3D morphology of phase‐separated blends, taking advantage of the possibility to selectively dissolve the different components is introduced. This method is applied in combination with AFM to investigate a blend of a semiconducting and ferroelectric polymer typically used as active layer in organic ferroelectric resistive switches. It is found that the blend consists of a ferroelectric matrix with three types of embedded semiconductor domains and a thin wetting layer at the bottom electrode. Statistical analysis of the obtained images excludes the presence of a fourth type of domains. The criteria for the applicability of the presented technique are discussed. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1231–1237     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Formation of porous polymer morphology by microsyneresis during divinylbenzene polymerization

This article describes the investigation of the importance of various reaction conditions on microsyneretic pore formation during polymerization of divinylbenzene (DVB) under so‐called “solvothermal” conditions. To induce microsyneretic pore formation, the most important parameter is an unusually high dilution of monomers with a “good” porogen solvating the polymer chains. High dilution and solvation of the growing poly(DVB) chains promote the prolongation of the polymer chains rather than their interconnection by crosslinking. Consequently, when the polymer gel density reaches the point where syneresis starts, the polymer network is geometrically too extensive to be broken up into precipitating entities and, instead, porogen droplets are formed within the continuous polymer gel. The pore geometry created by microsyneresis offers high surface area in wide mesopores and hence, high capacity for supporting functional groups or reactions with much better accessibility than narrow pores between polymer microspheres produced by macrosyneresis in conventional styrenic polymer supports. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 774–781     

Crosslinked poly(ethylene oxide) containing siloxanes fabricated through thiol‐ene photochemistry

Homogenous amphiphilic crosslinked polymer films comprising of poly(ethylene oxide) and polysiloxane were synthesized utilizing thiol‐ene “ click ” photochemistry. A systematic variation in polymer composition was Carried out to obtain high quality films with varied amount of siloxane and poly(ethylene oxide). These films showed improved gas separation performance with high gas permeabilities with good CO₂/N₂ selectivity. Furthermore, the resulting films were also tested for its biocompatibility, as a carrier media which allow human adult mesenchymal stem cells to retain their capacity for osteoblastic differentiation after transplantation. The obtained crosslinked films were characterized using differential scanning calorimetry, dynamic mechanical analysis, thermogravimetric analysis, FTIR, Raman‐IR , and small angle X‐ray scattering. The synthesis ease and commercial availability of the starting materials suggests that these new crosslinked polymer networks could find applications in wide range of applications. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1548–1557     

Invariant discrete flows

In this paper, we investigate the evolution of joint invariants under invariant geometric flows using the theory of equivariant moving frames and the induced invariant discrete variational complex. For certain arc length preserving planar curve flows invariant under the special Euclidean group , the special linear group , and the semidirect group , we find that the induced evolution of the discrete curvature satisfies the differential‐difference mKdV, KdV, and Burgers' equations, respectively. These three equations are completely integrable, and we show that a recursion operator can be constructed by precomposing the characteristic operator of the curvature by a certain invariant difference operator. Finally, we derive the constraint for the integrability of the discrete curvature evolution to lift to the evolution of the discrete curve itself.     

Momentum transport and torque scaling in Taylor-Couette flow from an analogy with turbulent convection

We generalize an analogy between rotating and stratified shear flows. This analogy is summarized in Table 1. We use this analogy in the unstable case (centrifugally unstable flow vs. convection) to compute the torque in Taylor-Couette configuration, as a function of the Reynolds number. At low Reynolds numbers, when most of the dissipation comes from the mean flow, we predict that the non-dimensional torque G = T/ν² L, where L is the cylinder length, scales with Reynolds number R and gap width η, G = 1.46η^3/2(1 - η)^-7/4 R ^3/2. At larger Reynolds number, velocity fluctuations become non-negligible in the dissipation. In these regimes, there is no exact power law dependence the torque versus Reynolds. Instead, we obtain logarithmic corrections to the classical ultra-hard (exponent 2) regimes: G = 0.50 . These predictions are found to be in excellent agreement with avail-able experimental data. Predictions for scaling of velocity fluctuations are also provided. Received 7 June 2001 and Received in final form 7 December 2001     

Economic Equilibrium: Optimality and Price Decentralization

Mathematical economics has a long history and covers many interdisciplinary areas between mathematics and economics. At its center lies the theory of market equilibrium. The purpose of this expository article is to introduce mathematicians to price decentralization in general equilibrium theory. In particular, it concentrates on the role of positivity in the theory of convex economic analysis and the role of normal cones in the theory of non-convex economies.     

Capillary Electrophoresis Chiral Separation for Enantiomeric Purity Determination of a Basic Drug in Pharmaceutical Formulations

Capillary electrophoresis using a running buffer composed of β-cyclodextrin as the chiral selector and ethanolamine mesylate at pH 9.6 is being used to monitor the stereochemical stability of a hydrophobic drug, containing two chiral centers, in two different formulated self-emulsifying drug delivery system (SEDDS) products. The separation takes place in less than 25 min. Strategies for enhancing the method reproducibility and detection sensitivity in the lower potency formulation are presented. The results demonstrating the specificity, assay precision, recovery, linearity and range achieved during the method validation experiments are presented in this paper.Presented at: CE in the Biotechnology and Pharmaceutical Industries: 7th Symposium on the Practical Applications for the Analysis of Proteins, Nucleotides and Small Molecules, Montreal, Canada, August 12–16, 2005.     

Nd0.5Ca0.5Mn1-xAlxO3 (x=0,0.03)体系中电荷有序态的超声研究

系统研究了Nd0．5Ca0．5Mn1-xAlxO3(x=0,0．03)单相多晶样品在低温下的电磁性质和超声特性．电阻和磁化率测量表明,Nd0．5Ca0.5O3体系在TCO-257 K处发生了电荷有序相变．超声声速从室温开始随着温度的降低逐渐减小,并在TCO附近达到最小,之后,随着温度的进一步降低,声速急刷增加,同时伴随着一个尖锐的超声衰减峰出现.TCO附近的超声异常表明体系中存在着强烈的电-声子相互作用,该电-声子耦合来源于Mn3 的Jahn-Teller效应．在低温下,出现了另一个超声衰减峰,它的出现归结为反铁磁相与顺磁相之间的相分离现象.随着Al在Mn位的掺入,超声声速的最低点和衰减峰向低温移动,表明体系中的电荷有序态和反铁磁相均被部分抑制,