HIRFL–CSR加速器中束流与真空中剩余气体的碰撞损失

研究了重离子加速器中束流与真空中剩余气体的碰撞损失过程和碰撞截面,在依据大量实验数据的基础上,提出了一组计算离子一原子的电荷交换截面的经验公式.以兰州重离子加速器HDRFL及冷却储存环CSR为例,给出了依据碰撞截面的公式计算束流在加速器真空中的传输效率的方法,并计算了在不同真空度下HIRFL的ECR源轴向注入束运线、注入器SFC、前束运线、主加速器SSC和后束运线等不同加速阶段及CSR的传输效率,并提出合理的真空度要求.HIRFL的真空分布测量和束流的损失测量证明了该计算方法的可靠性.     

355nm Nd∶YAG激光在H_2中的高效一级斯托克斯转换

对脉冲Nd∶YAG激光(355 nm)在H2和H2∶He-Ar混合气体中的受激拉曼散射(SRS)进行了研究。在0.5 MPa的氢气中,同时测量到从二级反斯托克斯到三级斯托克斯的多波长输出,其总转化效率达88%;而高压下只剩下一级和二级斯托克斯输出,其中二级斯托克斯最大能量转化效率达44%(对应量子效率为63%)。由于高级斯托克斯的竞争,纯氢气中一级斯托克斯的最大能量转换效率不超过43%。通过向3 MPa氢气中掺入2 MPaAr气后,很好地抑制了二级斯托克斯的产生,从而获得了能量转换效率高达71%(对应量子效率为83%)的一级斯托克斯输出。对四波混频和级联受激拉曼散射在氢气多级斯托克斯产生中的作用以及惰性气体对它们的影响进行了讨论。     

水斗非定常自由水膜流三维贴体数值模拟

本研究采用水斗三维非正交贴体坐标系进行了非定常自由水膜流动的数值解析。对不规则水斗内表面采用三维非正交贴体坐标系下离散点进行拟合,推导了曲面离散点的法向矢量和曲面微元面高斯曲率、平均曲率等几何特征量的计算公式,进而导出流体粒子在运动方向上曲率计算式。在水斗三维贴体坐标系中,还推导了流体粒子在水斗曲面上的运动控制方程。最后对某水轮机水斗内表面非定常自由水膜流进行了数值模拟,得到其非定常水膜流态分布。     

AGE method simulations of a turbulent far‐wake compared to spectral DNS

Turbulent flow simulation methods based on finite differences are attractive for their simplicity, flexibility and efficiency, but not always for accuracy or stability. This paper demonstrates that a good compromise is possible with the advected grid explicit (AGE) method. Starting from the same initial field as a previous spectral DNS, AGE method simulations of a planar turbulent wake were carried out as DNS, and then at three levels of reduced resolution. The latter cases were in a sense large‐eddy simulations (LES), although no specific sub‐grid‐scale model was used. Results for the two DNS methods, including variances and power spectra, were very similar, but the AGE simulation required much less computational effort. Small‐scale information was lost in the reduced resolution runs, but large‐scale mean and instantaneous properties were reproduced quite well, with further large reductions in computational effort. Quality of results becomes more sensitive to the value chosen for one of the AGE method parameters as resolution is reduced, from which it is inferred that the numerical stability procedure controlled by the parameter is acting in part as a sub‐grid‐scale model. Copyright © 2002 John Wiley & Sons, Ltd.     

Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

曲轴箱窜气量检测仪的研制

介绍了车用压差式气体流量传感器的结构设计和电测电路，指出了传感器的使用范围，由实验测出了特性曲线．该仪器可检测车用发动机曲轴箱窜气量，适用于发动机不解体故障诊断．     

前缘弯掠斜流转子叶顶间隙流动特性数值分析

本文对前缘弯掠斜流转子叶顶间隙内的流动特性进行了数值分析。结果表明:叶顶间隙气流与主流发生卷吸而生成泄漏涡。泄漏涡作用的区域具有较低的压力分布。在叶片通道内,泄漏涡沿着与转子旋向相反的方向朝相邻叶片的压力面移动。大间隙时的泄漏涡比小间隙时强烈。低流量时泄漏涡的作用区域比高流量时大。在各种流量特性下,叶顶尾缘近吸力面区域都存在着二次间隙流。     

Numerical analysis of turbulent structure in compound meandering open channel by algebraic Reynolds stress model

The turbulent flow in a compound meandering channel with a rectangular cross section is one of the most complicated turbulent flows, because the flow behaviour is influenced by several kinds of forces, including centrifugal forces, pressure‐driven forces and shear stresses generated by momentum transfer between the main channel and the flood plain. Numerical analysis has been performed for the fully developed turbulent flow in a compound meandering open‐channel flow using an algebraic Reynolds stress model. The boundary‐fitted coordinate system is introduced as a method for coordinate transformation in order to set the boundary conditions along the complicated shape of the meandering open channel. The turbulence model consists of transport equations for turbulent energy and dissipation, in conjunction with an algebraic stress model based on the Reynolds stress transport equations. With reference to the pressure–strain term, we have made use of a modified pressure–strain term. The boundary condition of the fluctuating vertical velocity is set to zero not only for the free surface, but also for computational grid points next to the free surface, because experimental results have shown that the fluctuating vertical velocity approaches zero near the free surface. In order to examine the validity of the present numerical method and the turbulent model, the calculated results are compared with experimental data measured by laser Doppler anemometer. In addition, the compound meandering open channel is clarified somewhat based on the calculated results. As a result of the analysis, the present algebraic Reynolds stress model is shown to be able to reasonably predict the turbulent flow in a compound meandering open channel. Copyright © 2005 John Wiley & Sons, Ltd.     

可压稠密气固两相流动过程的模拟计算

基于稠密气体分子运动论和颗粒动理学,建立可压稠密气固两相流动模型。采用梯度模拟来考虑气相可压缩性对气相湍流的影响。模拟计算表明气固两相射流速度沿轴向和径向减小,颗粒浓度下降。气固两相射流具有高的颗粒温度,呈现强烈的气固两相湍流流动特性。