贝克曼AllegraTM21R型超高速离心机故障排除一例

贝克曼Allegra^TM 21R型超高速离心机开机后，操作面板上出现错误代码“28”，离心机不旋转。离心机的电机采用无刷感应驱动，由电机驱动电源模块BSMl0GD60DN2驱动离心机的电机。故障是由于电源模块BSMl0GD60DN2损坏引起的。采用东芝三相桥式IGBT电源模块MG25Q6ES42代替BSMl0GD60DN2，并更换已烧毁的栅极电阻后。开机试验，仪器恢复正常。     

贝克曼离心机故障排除两例

简要介绍贝克曼离心机触摸键盘失控和控制参数显示混乱两例故障的故障现象、故障分析以及故障排除方法。     

Study on the Correlation between the Protein Profile of Lupin Milk and Its Cheese Production Compared with Cow’s Milk

Australian sweet lupin, the largest legume crop grown in Western Australia, is receiving global attention from the producers of new foods. To understand the effect of protein on cheese yield, lupin milk proteins were separated from the first, second, and third filtrations by cheesecloths. However, proteins from the first and second were analyzed using two-dimensional polyacrylamide gel electrophoresis; then, the isolated proteins associated with cheese production were identified. The research also focused on identifying the optimal method of cheese production based on the coagulation process, temperature, yield, and sensory evaluation. Lupin curds from the two cultivars, Mandelup and PBA Jurien, were produced using vinegar, lemon juice, starter culture, vegetable rennet enzyme as coagulant, as well as curd generated using starter culture and vegetable rennet enzyme. Cow’s milk was used as a control. The results indicated that first-time filtration produced better extraction and higher yield of lupin proteins and cheese than the second filtration. A sensory analysis indicated that lupin cheese produced from PBA Jurien lupin milk using vinegar, 7.80% expressed as acetic acid, and ground in 45 °C water, was the most acceptable. The cheeses were examined for their protein, carbohydrates, fat, ash, and moisture contents. The concentration of protein was approximately 27.3% and 20.6%, respectively, in the cheese from PBA Jurien and Mandelup. These results suggest that lupin milk can adequately supply the proteins needed in human diets and, thus, could be used in the production of many existing products that require animal milk as an input.     

一种用于大容量逆流色谱制备的立式多层螺旋管行星式离心机

Owing to no complications caused by solid supports, such as adsorptive sample loss and deactivation, tailing of solute peaks, and contamination, countercurrent chromatography (CCC) has been an area of intense research since the first introduction of CCC in 1970,[1] and various apparatus and broad applications have been advanced[2,3]. For these developments, the type-J synchronous planet centrifuge has received considerable attention, which relies not only on its relatively simple mechanic design, but also on its high partition efficiency and short elution time caused by mixing and settling for the efficient chromatographic separations. In the past, however, almost all of type-J centrifuges rotated slowly were disposed horizontally due to the original design and some experiments that gravis plays an important role at a low rotary speed as similar to type-V rotating multilayer helical tube in unit gravity[4-9]. In fact,we discovered that the upright apparatus holds more retention of stationary phase than the horiziontal aparatus when large standard tubings were used as mutilayer coil column and the aparatus was operated under same contions. We report here a new coil planet centrifuge with four upright cylindrical columns for large scale countercurrent chromatographic preparation. The design principle and apparatus of UCCC is as samilar to type-J multilayer coil planet centrifuge. Four uptight cylindrical column holders are symmetrically arranged around the centrifuge axis as similar to the type-J HSCCC with three horizontal multilayer coils connected in series[8] . A series of experiments indicat that upright CCC has many advantages over the horizontal CCC when using a large-bore tube as multilayer coil column for large scale countercurrent chromatographic separation.Upright CCC provide a versatile countercurrent chromatographic method for large-scale preparation from very crude sample. It has good preparative capacity and flexible suitability to various sample and two-phase system.The present apparatus not only can be operated at a high speed as similar as commonly used HSCCC for the system having short settling time and but also can be run at a low speed for the system having relative long settling time. Because of automatical control and seal-free flow through device, the uptight CCC apparatus may be readily scaled up to industrial preparation.     

大型精密离心机光栅测角系统的设计与实现

对JML－1大型精密离心机主轴光栅测角系统的关键技术进行了研究,给出了如何解决光栅测角系统的精度问题。抗干扰问题和动态测角问题的设计方法及测试结果。     

Counter-current chromatographic separation of nucleic acid constituents with a hydrophilic solvent system

Nucleic acid constituents such as nucleobases, nucleosides and nucleotides were separated by counter-current chromatography using type J coil planet centrifuge. The separation was performed with a hydrophilic solvent system composed of 1-propanol/800 mM potassium phosphate buffer (pH 7.4) (1:1, v/v) by eluting the lower aqueous phase at a flow-rate of 0.5 ml/min. Eight selected nucleic acid constituents (4.0 mg, 0.5 mg of each), uridine monophosphate (UMP), adenosine monophosphate (AMP), deoxyadenosine monophosphate (dAMP), uridine, urasile, deoxy uridine, adenosine and adenine were well resolved within 160 min.     

Improvements in Silo Design for Moist and Cohesive Bulk Solids by Using a Silo Centrifuge

The Jenike‐method is state of the art in silo design for trouble‐free flow, even for cohesive bulk solids. However, for some bulk solids, especially very cohesive and moist bulk solids, even the correct application of the Jenike‐method can lead to an over‐design of the silo outlet. If a reliable estimation of the critical outlet dimension is possible the dimension as well as the machinery costs can be reduced. Model testing can help to reduce the over‐design but reasonable test equipment and flexibility are only possible with silo centrifuge testing. Results, regarding the state of stress and the critical outlet dimensions, from experiments using a silo centrifuge with cohesive and moist bulk solids are presented. The influence of creeping effects on silo design is investigated using the silo centrifuge with moist gypsum.     

具有六弹簧弹性支承悬臂离心机的整机平衡原理和方法

本文叙述一种具有六弹簧弹性支承悬臂离心机的一种快速整机动平衡技术的原理和方法。本文提出的方法系根据模态平衡原理，但并不需要预先获得各阶模态曲线。本文还叙述了单测点平衡以及同时进行高、低速平衡的原理和方法。经此方法平衡后的离心机，能在整个操作转速的范围内平稳地运转。     

CONTINUOUS ULTRA—FINE CLASSIFICATION IN A DISC—STACK NOZZLE CENTRIFUGEEFFECTS OF G—FORCES AND DISC GEOMETRY

This paper describes the use of a disc-stack nozzle centrifuge for wet classification of ultra-fine particles of calcium carbonate. The influences of G-force and disc geometry on the performance of the ultra-fine classification have been investigated. The results have demonstrated that the efficiency of the classification can be increased by (1) applying a relatively moderate G-force and (2) the use of stud spacer discs in the centrifuge. The increased extraction of the fine particles is related to the formation of the appropriate fluid velocity profile at a lower G-force and a circumferential motion without meridional barriers for the case of the stud spacer discs.     

Improved partition efficiency with threaded cylindrical column in vortex counter-current chromatography

Type-I coil planet centrifuge produces a uniformly circulating centrifugal force field to produce vortex motion of two immiscible solvent phases in a cylindrical cavity of the separation column to perform efficient countercurrent chromatography. The partition efficiency obtained from the original vortex column was substantially improved by threading the cylindrical cavity to increase the area of mass transfer between the two phases. Partition efficiency of the threaded column was evaluated by three different two-phase solvent systems with a broad range of hydrophobicity each with a set of suitable test samples. Overall results of the present studies indicated that the threaded cylindrical column substantially improves the partition efficiency in terms of theoretical plate number, peak resolution, and height equivalent of one theoretical plate. The results also indicated that higher peak resolution is produced by eluting either the upper phase in the head to tail direction or the lower phase in the reversed direction. When there is a choice in the mobile phase, a better separation is achieved by using the less viscous phase as the mobile phase. Since the present system gives extremely low column pressure, it may be a potential alternative to the conventional type-J HSCCC system for a large-scale preparative separation.