Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

93W合金有关力学参量的综合选评

 对93W合金材料进行了超声测量实验，并结合原有的超声测量结果进行了分析比较，提出了可以直接用冲击波速度关系式的三个系数c₀ 、λ和λ′来对钨合金的有关力学参量，如G₀、K₀、G₀′、K₀′等进行综合选评的方法。得到了一组对93W合金较为合理的力学参量推荐值。     

Chronoamperometric studies in an ammonia citrate electrolyte for the deposition of a nickel-molybdenum alloy

Dependences of the current and the chemical composition of cathodic deposits on the electrolysis time are studied in an ammonia-citrate electrolyte for the deposition of a nickel-molybdenum alloy in potentiostatic conditions. At potentials less negative than ?0.93 V, no nickel-molybdenum alloy deposition occurs and in the course of electrolysis there is observed a decrease in the current, which is connected with the blocking of the electrode surface by the formed molybdenum oxides. In the region of potentials of deposition of a nickel-molybdenum alloy there is realized the following shape of a time dependence of the current. Within the first few seconds of the electrolysis process, the current somewhat decreases. Then there occurs its increase, which is connected with the alloy deposition on the cathode. In the course of electrolysis there occurs a decrease in the molybdenum content in the cathodic deposit.     

面心立方晶体外延膜沉积生长中失配位错的结构与形成过程

用分子动力学方法对5%负失配条件下面心立方晶体铝薄膜的原子沉积外延生长进行了三维模拟.铝原子间的相互作用采用嵌入原子法(EAM)多体势计算.模拟结果再现了失配位错的形成现象.分析表明，失配位错在形成之初即呈现为Shockley扩展位错，即由两个伯格斯矢量为〈211〉/6的部分位错和其间的堆垛层错组成，两个部分位错的间距、即层错宽度为1.8 nm,与理论计算结果一致；外延晶体薄膜沉积生长中，位错对会发生滑移，但其间距保持稳定.进一步观察发现，该扩展位错产生于一种类似于“局部熔融-重结晶”的表层局部无序紊乱- 关键词： 失配位错 外延生长 薄膜 分子动力学 铝     

Co-P非晶态合金电子性质和局域结构的理论研究

根据Co P非晶态合金结构的短程有序和结构中可能存在P -P相互作用的实验事实 ,选择了单磷原子簇模型ConP(n =1～ 5 )和双磷原子簇模型ConP2 (n =1～ 4 ) ,用密度泛函理论方法对其进行计算 .结果表明 ,在单磷Co2 P( 2 ) 、Co3 P( 1) 及Co4P( 2 ) 模型体系中 ,Co原子供给P原子电子 ,与电负性规则一致 ,同时Co和P之间具较强化学作用 ,可以形成稳定的原子簇 ;而在双磷和单磷原子簇Co5P( 1) 模型体系中 ,形成的原子簇不稳定 ,采用单磷Co2 P( 2 ) 、Co3 P( 1) 及Co4P( 2 ) 模型能较好地反映Co P非晶态合金的结构特点 .     

Non-isothermal short-range-order kinetics of binary alloys as influenced by solute-vacancy complexes

A model describing the roles of bound and unbound vacancies is proposed in order to predict defect decay and short-range-order kinetics of quenched binary alloys during linear heating experiments. This is an alternative treatment of a previous approach. The model has been applied to the differential scanning calorimetry (DSC) curves of Cu-5 at.% Zn quenched from different temperatures. An expression to calculate the activation energy for migration of solute-vacancy complexes was also developed which make use of DSC trace data. A value of 89.12±0.32 kJ mol^-1 was obtained for the above alloy. The relative contribution of bound and unbound vacancies to partition of effective activation energy corresponding to the ordering process as influenced by quenching temperature was also assessed. This revised version was published online in July 2006 with corrections to the Cover Date.     

Spectrofluorimetric Method for the Determination of Aluminum with Alizarin Red PS

 A simple and direct spectrofluorimetric method has been developed for the determination of aluminum using alizarin red PS (1,2,4-trihydroxy 9,10-anthraquinone-3-sulfonic acid). The method is based on the strong fluorescence (480/564 nm) of Al³⁺ and alizarin red. Experimental parameters such as pH, concentration of the ligand, ionic strength of the solution, reaction time and temperature were optimized in order to maximize the analytical signal. Interferences of several ions (anions and cations) were studied and evaluated. The linear range of the method extends from 3 to 100 μg L⁻¹. Limit of detection (3s_b) was 0.9 μg L⁻¹. The method was tested with a silicate certified reference material. Interferences were eliminated by a liquid extraction with cupferron. Author for correspondence. E-mail: aucelior@rdc.puc-rio.br Received September 10, 2002; accepted January 15, 2003 Published online May 5, 2003     

An experimental study on the kinetics of leaching for the preparation of a Raney-silver catalyst

A Raney-Ag catalyst was prepared by leaching out aluminium from a Raney Ag-Al alloy with NaOH solution. The kinetics of leaching has been investigated in a stirred-batch-reactor at various temperatures by using alloy particles of different sizes. The kinetic model best fitting the experimental results has been determined. This revised version was published online in June 2006 with corrections to the Cover Date.